GMC Complaints

The backup camera visibility at night is poor, making it very difficult to see behind the vehicle. This poses a potential safety hazard for pedestrians who may be in the path while reversing.

The drivers side grab handle (a pillar trim piece) is cracked through completely at upper bolt mount location, causing the grab handle to be weakened and unable to safely support while using and could pull away from vehicle while in use potentially causing the driver to fall and become injured. I replaced the original with a genuine OEM replacement from the dealership and it cracked in the exact same place. I posted an inquiry to a Facebook group of fellow GMC owners and there were numerous reports of this having to them and having the dealership replace under warranty, only to have the issue occur again. This structural failure seems to happen with or without use of the grab bar.

The contact owns a 2018 GMC Sierra 1500. The contact stated that the battery had been replaced three times since 2018. The vehicle was taken to the dealer; however, the failure was not duplicated. The contact referenced an unknown recall; however, the VIN was not associated with the recall. In addition, the contact stated that the first battery was replaced a month after the vehicle was purchased, and the second battery was replaced three weeks after the first replacement. The contact stated that the third battery was replaced a day after the second battery replacement. The manufacturer was made aware of the failure and a case was filed. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was approximately 36,000.

While traveling on the freeway at freeway speeds and with the cruise control on, on 7/22/2025, my vehicle abruptly start making an odd noise, the steering wheel started to vibrate / move as if I had a flat tire. I safely existed the freeway and pulled over to investigate, there was no flat tire yet the vehicle still made the noise and experienced issues when the throttle was applied. I proceeded to call a tow truck, and have the vehicle towed from Alpine, CA to Temecula and Temecula Valley GMC. While there the dealership gave me an initial diagnosis of "Miss fire in cylinder 8". We left the vehicle, and awaited more information. The next day I received a phone call stating that they needed to do an engine teardown to completely diagnose the issue, to the tune of approx. $1,500. In the dealers words, they needed to do the teardown to determine if "They could salvage the engine, or if it had to be condemned". The following day I received another call stating that the engine needed to be completely replaced due to a collapsed cylinder. The estimate for this work is over $13,000. the truck is 6 years old with 58,XXX miles.

My daughter and I drove to town to run some errands, we live twenty-three minutes away and take the freeway. Speed limit on that specific section of the freeway (I80) is 80mph. As I was taking the on-ramp to enter traffic, My GMC started shifted very hard and losing power. The vehicle was sputtering and making strange sounds. I was unable to exceed 60mph due to excessive vibrations/shaking the vehicle. Steering was starting to be difficult at the same time I noticed Oil Pressure Gauge slowly dropping on instrument panel below 25psi. I had to pull over immediately. oil pressure remained lower than normal, verified Oil was filled to manufactures specifications (changed June 30, 2025). Returned the vehicle to my place of residence as safe and slow as I possibly could and parked it as it is a major safety concern.

Local dealer is not repairing my recall. I keep getting told parts are not available and this has gone on for years.

2021 GMC Sierra 1500 [XXX] miles 36,500. My childs seatbelt does not work and the lane keep assist does not work INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2022 GMC Sierra 1500. The contact stated that while driving at an undisclosed speed, the check engine warning light was illuminated, and the vehicle suddenly stalled. The vehicle was able to restart, but the check engine warning light remained illuminated. The vehicle was taken to the local dealer, where it was diagnosed with an engine oil consumption failure. The vehicle was not repaired. The contact was informed that the failure was related to NHTSA Campaign Number: 25V274000( Engine and Engine Cooling). The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 87,500.

While driving the vehicle, the engine started to make a knocking noise and we experienced illumination of the check engine light. We also experienced engine performance issues with hesistation and reduced acceleration. We were able to take the vehicle to a GM dealer and it was determined that the lifters and crankshaft were defective and need to be replaced. There is a warranty out for 2021 GMC Yukon Denali vehicles that were manufactured less than a year after ours that have currently have a recall issued by GM for the same problems that we experienced. My wife and two young children, ages [XXX] and [XXX] , frequently ride in this car and catastrophic engine failures put their safety and livelihood at serious risk. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Vehicle stalled while driving and would not turn back on. I had to have it towed over 45 minutes.