2011 HYUNDAI SONATA Complaints

2011 sonata se 2.0t door lock’s acting up won’t open or lock fuel smell in the car really strong and not measuring the gas keeps going up and down and at times I don’t even know if I have gas or not and when filling gas at the gas tank entrance where you fill up at won’t let me fill up gas keeps getting spit out when I’m filling and I have to keep clicking the gas gun and not put pressure have to fill it very slow

The brake lights stay on all the time, thus preventing vehicles behind mine from knowing if I'm actually stopping. Hence, they may stop without reason, and endanger drivers behind them. The manufacturer has likely known of this being an issue in Sonatas from, at least, 2007 through 2013 models. The manufacturer is putting the task of solving the problem (if that's even possible), upon a dealer. And, my trip to that (nearest) dealership (75 miles away) creates its own danger. The danger is added to by a pre-existing unsolved issue of the horn not functioning. As per the brake light issue, I've been to the dealership about it twice, and they weren't even aware that the brake light switch they think attaches to my car doesn't. So, I wonder if the manufacturer tried to address the issue in the middle of the 2011 model year, installed a different model switch and wiring on more newly built cars in that model year, and decided to ignore the owners of vehicles sold earlier in that model year. As for an additional related issue, unless I disconnect my battery when not in the car. the lights stay on and run down the battery. That can contribute to its own safety issue.

The contact owns a 2011 Hyundai Sonata Hybrid. The contact stated that upon retrieving the vehicle from the local dealer after a recall repair, the brakes were inoperable. There were no warning lights illuminated. The vehicle was taken to the local dealer, where a diagnostic test was completed. The vehicle was repaired, but the failure recurred. The manufacturer was not contacted. The failure mileage was unknown.

The contact owns a 2011 Hyundai Sonata. The contact stated that after the manufacturer performed Service Campaign 993 (Inspect & Anti-Theft Software Upgrade) the vehicle failed to shutoff as needed. Additionally, the alarm was activated while starting the vehicle. The contact disconnected the battery to shutoff the vehicle. The vehicle was taken to the dealer, where pliers were used to remove the key fob and a second key was used to restart the vehicle; however, the failure recurred. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 112,000.

My right brake light has melted my housing due to the bulb getting too hot and my cruise control suddenly stopped working one day the light comes on but when I go to hit the set button it doesn't set or activate

The contact owns a 2011 Hyundai Sonata. The contact stated while driving 55 MPH, the check engine warning light illuminated, and the vehicle stalled. The contact was able to veer to the side of the road. The vehicle failed to restart and was towed to an independent mechanic, where it was diagnosed that the engine had seized and needed to be replaced. The vehicle was not repaired. The dealer and the manufacturer were not notified of the failure. The failure mileage was approximately 175,000.

My brake lights constantly go out new bulbs don't work either...it sems to be a malfunction in the wiring for the lights. The seatbelt on driver side will not latch no matter what. All electrical has issues, dash will go in and out as well as radio and heating/ac lights.

Knocking from steering column indicating internal damage to electronic steering components of the steering column. Recommend replacing steering column. Reviewed by independent mechanic.

My engine is stalling out. It shuts off while driving. And the engine oil lamp light keeps flicking on and off. Definitely something wrong with the engine.

- Code P0304 Engine- Metallic debris have been detected upon inspection and it was declared that the debris have not been completely removed near the engine crankshaft this caused oil flow to be restricted through the connecting rod bearings, causing connecting rod damage, also there is a worn out connecting rod bearing causing this vehicle to have a loud knocking noise possible engine failure. Due to this Malfunction it caused the following Code - Code P0304- Vibrations indicating excessive connecting rod bearing wear.