2014 JEEP CHEROKEE Complaints

It began with front end grinding sounds. I took the vehicle to multiple mechanic shops and all the shops agree that the Power Transfer Unit is leaking and metal shaving are visibly coming out of the seal. This is supposed to be a sealed unit that doesn’t require service. There are already two separate recalls for this exact issue 2017 - 2019 and 2019 - 2023. Apparently, this could disengage from the transmission or worse, lock my transmission up and possibly cause an accident. Flashing the CM did not solve anything. My car has been at the mechanic shop for a little over a month with a new unit already ordered. I have been paying close attention to this and relevant recalls.

Vehicle: 2014 Jeep Cherokee VIN: [XXX] Component: Power Train – Transfer Case (PTU) Safety Issue: Loss of motive power / PTU failure Complaint: My 2014 Jeep Cherokee is experiencing the same failure mode described in FCA PTU recalls W47 (20V343) and W48 (20E037). The PTU output shaft bearing is failing under load. The grinding noise disappears when the driveshaft is removed and returns immediately when the driveshaft is reinstalled, confirming a load dependent PTU failure. This defect can cause sudden loss of motive power and inability to hold Park, which matches the safety description in the recall documentation. My vehicle falls within the recall build date ranges, yet the manufacturer refuses to cover the repair. This is a safety related defect that should be included in the population recall. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

This vehicle stalls while on the road and it also stops driving, and the vehicle remains stationary. It's random and I never know when it will happen. There was a recall issued for this very problem in 2019. When I type in Mt Vin # it says no recalls on this vehicle. I feel this vehicle meets the same safety issues as the recall. I've contacted Chrysler with no progress.

I had a recall completed in March 2023 for transmission issues. Since January 2026, my vehicle has been in a repair for a part that is backorder. The part is Transfer Case Control Module (TCCM). The part number is 68540646AA for a 2014 Jeep Cherokee Latitude V6 3.2 4x4. I feel that this is unfair and it has caused me and my family undue hardship. After I obtain this part, then other parts such as O2 sensor and the thermostat has to be replaced as well. I feel that Stellanis should cover the cost of all of the repairs.

My Cherokee started showing a light on the dash that said 4WD SYSTEM TEMPORARILY UNAVAILABLE....I took it to the jeep dealer they fixed other things and then after I paid it was still showing that same warning light. So I'm just wondering if it's covered in the recall?

Failed PTU is signaling AWD service light. Jeep Cherokee Trailhawk 2014 Later Trims have recalled failure Jeep won't go over 25mph without shaking. Sounds are grinding. Very dangerous to drive

The contact owns a 2014 Jeep Cherokee. The contact stated that while driving 45 MPH, the message “Turn off Air Conditioner - Engine Overheating” was displayed. The vehicle was towed to an independent mechanic, where it was determined that the water pump and wiring needed to be replaced. The vehicle was repaired, but the failure persisted. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 114,000.

The contact owns a 2014 Jeep Cherokee. The contact stated that while driving at 15 MPH, the transmission seized, and the vehicle was jumping while accelerating and going around a curve. After the failure, the vehicle started operating as intended. There were no warning lights illuminated. The local dealer was contacted and informed that the VIN was not under recall. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 123,840.

My 2014 Jeep Cherokee Trailhawk (Active Drive II / Sales Code DK4) has a confirmed DTC C14A7-97, indicating the PTU Motor is obstructed or blocked. This has resulted in a "Service 4WD" warning and a complete loss of all-wheel-drive capability. My vehicle was manufactured in November 2013, and I am being denied the XJ1 Extended Warranty (15 years/unlimited miles) because my VIN does not appear in the dealer's system, despite the vehicle being a 2014 model year with the exact failure code the XJ1 program was designed to address. This failure can lead to a sudden loss of drive power while in motion and a loss of the "Park" function, creating a significant rollaway risk. These are the same safety hazards identified in NHTSA Recall 20V-343 (W47). I am requesting that NHTSA investigate why 2014 model year vehicles with 2013 build dates are excluded from the XJ1 warranty extension for this known safety defect.

The contact owns a 2014 Jeep Cherokee. The contact stated that water was leaking into the vehicle from the sunroof, causing the parking brake to become inoperable. The “Service Parking Brake” warning light was illuminated. The contact stated that the parking brake failed to function properly and failed to disengage as needed. The vehicle was taken to an independent mechanic, where it was determined that the parking brake actuator had failed and needed to be replaced. The vehicle was not repaired. The dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 68,000.