2015 JEEP CHEROKEE Complaints

Power Transfer Unit stopped working. Brakes locked up and car would not move. Is not drive-able at this time. Currently at a dealership awaiting part, of which there is NO ETA on. I was just entering a roundabout when the part failed, and I could have been hit as the vehicle fully stopped and could not be moved. There was a grinding noise and no warning prior of this part failing. The problem was confirmed by a local mechanic who recommended a Jeep Dealership to take care of the issue as the part may be under warranty. I am unsure of who inspected the part currently. This is my primary vehicle and the dealership will not "cover" a loaner car so I am stuck.

Headlights cut out when it says low beam out and both headlights are new and work fine until it decides it doesn’t. Transmission is faulty in these cars.

For several months I've received "Service 4WD" notifications in my car and I have noticed it has difficult getting up hills specifically if there is any snow/even rain. I brought it in for repair and was told it was the Transfer Case Assembly (PTU) which is a very common issue they've seen with these Jeeps. I told them to go ahead and order the part to fix it. About a week later the service person was told that Chrysler corporate would not release the part because it was or would soon be a recall and they will only release it to the dealers to handle the recall (I understand there are only about 100 of the part available at this moment). I called 2 dealers and it is not appearing as a recall (yet) for my Jeep so they said they could not do anything and gave me the corporate number. Corporate said to reach out here or talk to the dealership again. It is clear that this is an issue for many and should be a recall. At this point, I am just trying to get my car fixed and I can't even get the part because it is in this "almost" recall stage.

After learning of the recall for the lift gate module because of water intrusions of multiple points. The wiring harness to the lift gate module was serverly corroded and had to be replaced. The original fix, without the corrosion on the harness, was the place a piece of plastic over the module. That recall and fix did nothing to address the issues of multiple points of water intrusions. From body seems, the seal around the hatch, and around the tail light(s). There is more than one harness, and more than one module in the tire well. The multiple water leaks, that can and have affected an electrical component the was deemed as being a potential to start a fire, and none of the others in there are. There needs to be a recall on the water leaks, from their poor design! I have saw first hand how badly the harness they HAD to replace, along with the lift gate module. Because of the very seriousness of the corrosion. Where they not only replaced both of them, but also had to relocate the lift gate module, because of the evidence of the amount on water that has been entering the cargo, and wheel well areas! À 11 year old vehicle, from the information I have read up on, many with this same production years are also having the issues of water intrusions! Hold them responsible, instead of letting them cut corners of just trying to put a umbrella over there recall! I don't have pictures now, or when I took it to the dealership originally for the recall. But I am willing to take pictures, as I'm still in the process of disassembly the interior to try and pin point all the water intrusions! The dealership I took it to for the recall work, said they are "not aware of any water intrusions on this vehicle". That's a big problem!!

The contact owns a 2015 Jeep Cherokee. The contact stated that after starting the vehicle, the check engine warning light remained illuminated. The message "4WD Low" was displayed, and there was a grinding sound coming from the front of the vehicle. The vehicle was towed to the local dealer to be diagnosed. The vehicle was diagnosed with PTU failure. The contact was informed that the PTU needed to be replaced; however, the part was on backorder. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 150,000.

The contact owns a 2015 Jeep Cherokee. The contact stated that while in a drive-thru line, the front driver's side window started smoking. The contact disconnected the wiring to the door. The vehicle was taken to O'Reilly, where it was diagnosed with an internal door electrical failure. The contact personally replaced the power window motor. The vehicle was repaired. The contact stated that the vehicle was experiencing hard shifts while driving. The check engine warning light was illuminated. The vehicle was previously taken to O'Reilly’s, where it was diagnosed that the failure was related to the alternator and low battery voltage. The alternator was taken to two technicians for testing, and the contact was informed that the alternator was in good condition. The vehicle was not repaired. Additionally, the contact stated that the ABS warning light was illuminated. The vehicle was recently taken to O'Reilly’s and AutoZone for diagnostic testing and the contact was provided fault codes for EVAP system leak detected, 1,2,3 Active Grille Shutter (AGS), throttle pedal position sensor switch A circuit high, System Voltage below and above Threshold, denied torque request signal, ECU configuration mismatch, ECU vehicle option mismatch, output speed sensor, input speed sensor/Correlation, fan 1 control circuit, throttle pedal position sensor switches D and B circuit low, and DTC U0402-00 for TCM immediate repair. The dealer was notified of the failure. The vehicle was not repaired. The manufacturer was not contacted. The failure mileage was approximately 72,000.

The contact owns a 2015 Jeep Cherokee. The contact stated that while attempting to open the liftgate, the liftgate failed to open. The contact stated that during inclement weather, water was entering the cabin of the vehicle, causing mold to develop inside the vehicle. Neither an independent mechanic nor a dealer was contacted. The vehicle was not taken to the dealer or an independent mechanic to be diagnosed. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 23V338000 (ELECTRICAL SYSTEM, STRUCTURE); however, the VIN was not included in the recall. The manufacturer was not notified of the failure. The failure mileage was 130,000.

My daughter was driving her car in the middle of a busy intersection when the parking brake locked up causing her to come to an abrupt stop and almost cause an accident. A quick google search appears to indicate that this issue has already been under investigation by NHTSA for a period of time.

Check engine light on and coastal transmission in Toms River New Jersey inspected car and said transmission is not working properly and could cause a sudden stop. Cost would be $4,000 to rebuild it. [XXX] [XXX] [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

My transmission failed and was not connecting with the driver train any more. The Jeep only has 112k miles on it. This recall mentions the transmission teeth being broken/wore down and creating an issue. NHTSA Campaign #:: 20V343000 I never got anything about this recall. My cost to replace the transmission was $4700.