2006 JEEP COMMANDER Complaints

Brakes failed completely. 2-3 car lengths between be and car in front of me with plenty of time to stop. My jeep did not even slow down when brakes we applied.

My jeep will shut off unexpectedly, it will do a up and down idle increase and decrease while at a idle the abs will lock up my wheel tight to where itll drag while trying to move forward. The 4x4 low will not engage at all says service 4x4

The contact owns a 2006 Jeep Commander. The contact stated while driving approximately 10 MPH in a parking lot the vehicle stalled. There was no warning light illuminated. The contact stated the failure was intermittent but a recurring failure. The contact stated that the failure occurred at various speeds. The contact stated that the 12-Volt battery had been replaced approximately 2 years ago due to battery drainage issues. The contact stated that the failure with the 12-Volt battery being drained and had jumpstart the vehicle several times. The contact researched online and related the failure to NHTSA Campaign Number: 08V203000 (Power Train); however, the VIN was not included in the recall. The contact also replaced the ECM module independently. The contact had not taken the vehicle to a local dealer or independent mechanic. The manufacturer was not informed of the failure. The failure mileage was approximately 200,000.

Seat Belts/Rear. The integrated retractor bracket edge on the third row seat may contact the seat belt during certain operating conditions. In the event of a crash, the seat belt may not properly restrain thee third row occupant. Service Brakes. Hydraulic: Antilock/Traction Control/Electronic Limited.: Control Unit/Module. On certain sport utility vehicles, the software programmed into this ABS Electronic Control Module allow a momentary delay in breaking when coasting up a kill during certain conditions. This has happened while wet conditions occur some.

Power Train. The (TCM/PCM/TECM) Chrysler is recalling 24, 461 Jeep Commander vehicles equipped with 407 V8 engines. Th powertrain control module (PCM) was programmed with software that may allow the engine to stall under certain operating conditions. This could cause a crash without warning. ( My Jeep turns on, but it is not able to be moved, it is stalled indefinitely). I asked the dealer @Rockwall Dodge, Rockwall TX to check the PCM/TCM/TECM. They refused. Said they were not able to check this situation. Didn't have that equipment. Electrical System. This defect can affect the safe operation of the airbag system. The air bag lights comes on randomly. The engine will turn off, which will then depower various key safety systems. I am unable to unlock the ignition on several occasions. Suspension. Rock Krawler recalled 44 performance suspension systems sold as aftermarket equipment for use on the vehicle listed above. We have had suspension issues on our Jeep. No one can find the issue to fix it. The Jeep makes noise at the suspension system.

Radiator coolant system failed and caused the engine to overheat and loss of power while traveling on an interstate highway. Pulled over to side of highway. The vehicle was towed to a private mechanic shop. The shop evaluated the engine could not start as it had seized from overheating. It was determined that the radiator plastic end caps suddenly failed causing the engine to overheat and seize. The radiator temperature is very high and the plastic and aluminum materials expand and contract at different rates therefore weakening the connection between the two materials until the part fails. This is a bad design, application, and mix of materials in a part that does follow the basic principles of thermodynamics.

Abs, traction control, and another light come on and goes off intermittent. While reversing feels like brakes are locking up. Transmission shifts different intermittently. I have seen that there is recalls for other 06 commanders that reflect the issues I am having.

Vehicle randomly saying transmission over temp. Vehicle may or may not crank upon turning key Vehicle downshifts to second gear while driving and has caused me to run off the road/slam on brakes to stop Vehicle resets itself to where Jeep dealership cannot even trace wiring harness for shorts or check to see if transmission control module works properly after having my commander from August to December. Suspect faulty Transmission control module/short due to poorly designed wiring and parts on manufacturer's behalf. Other issues include random codes with each new code reader, stereo wiring issues, vehicle changing from v8 to v4 randomly while driving, consuming excessive gas amounts only receiving 9 miles per gal of fuel Extremely dangerous to drive and do not feel safe

I had gotten my sepertine belt replaced and it started showing message transmission over heating it had not aloud my jeep to start and it made the starter go out to the alternator is now bad I have had it stall before I got the message and it about caused an accident several times until message. Brakes had skidded me about into a tree & other things and people when I had pressed on them two handful of times, it's Like that were be slammed or something.

There are 2 issues I am reporting. 1.) The passenger front seat belt tensioner does not allow you to buckle the seat belt. 2.) The vehicle will go into limp mode and shift into 3 gear. I disconnect the battery and wait about 15 seconds and the problem is magically resolved.