2016 JEEP COMPASS Complaints

It will stop running while driving or making turn without warning must stop put in park and restart .The more you use more it happens. Very dangerous

My engine is shutting down, sometimes in the middle of me driving. My car will shut done and I will stop in the middle of merging into traffic. Or waiting at a light my car will shut down. I almost got rear ended today because my car randomly shut down. No warning lights are on. I have looked up information and this exact problem is happening with other 2016 keep compasses. The dealer I contacted just told me that there were no codes that could be read so he couldn’t tell me what was wrong. I also took my car to advance for them to check everything and the gentleman there also told me no codes were reading. This has been happening for about a month.

I have taken my jeep to get the thermostat sensor put in for the second time. This jeep has multiple mechanical issues that i have taken into a mechanic shop for fixing now the check engine light on.jeep came from drive time with these issues since I had the car they need to recall these jeep because it's a safety issue for possible accident.the issues have been a problem since 2020 when I got it and every year from then

In May 2020 as I was driving down the road at approximately 50 mph I suddenly lost the ability to accelerate and dropped down to 25 mph immediately. I tried to accelerate, but the vehicle would not go over 25 mph. The check engine, traction control and another light illuminated on the dash. I pulled the vehicle over and shut it off. I waited approximately 5 minutes and restarted the vehicle. All of the lights went off except the check engine light. I started to drive again and it appeared that I had function back with the accelerator. This happened again several days earlier. It seemed to happen most when I needed to accelerate to climb a hill or slight incline. This is not safe, especially when in traffic or with traffic behind you. I brought it to my local garage and it was diagnosed with a bad throttle body sensor. The sensor was replaced in May 2020. I have just begun having similar issues again recently. The vehicle seems to hesitate when the accelerator is pressed as though it is not getting enough gas. I brought it is to the garage again, and again it was diagnosed with a bad throttle body sensor. This is not something that should be replaced twice in 2 years?

Engine would intermittently stall while driving without warning. Some cases the engine would go into limp mode and other cases the engine would completely shut off. Problem occured while driving on city streets as well as driving on highway at highway speeds. Severe risk of collision occurred multiple times to myself and all other vehicles around me. A local repair shop misdiagnosed the problem multiple times as there was no check engine light present. A private mechanic determined that my vehicle needed the Chrysler s89 recall fix. A licensed dealership declined to perform the recall because my vehicle was manufactured in November of 2015. The private mechanic replaced the three electrical terminals that connect to the crank/camshaft sensors which unofficially completed the Chrysler s89 recall fix. Vehicle ran problem free for two weeks with about 300 miles driven before engine stalled again this time with check engine light illuminated as well as an emissions light. Vehicle was towed to a licensed dealership. Licensed dealership found codes C2101 and P2173. Dealership replaced throttle body and a sensor. Between a local repair shop, a private mechanic, a licensed dealership and multiple tow companies I spent over 3,000 dollars (assuming the throttle body failure is a result of the Chrysler s89 recall).

Have replaced Cam Shaft AND Crankshaft Positioning sensors to no avail. Check engine light will come and go, sometimes with the traction control lights as well if the brake is engaged for any length of time. After these lights come on, the jeep loses the ability to accelerate, leaving the car in limp mode. Light goes off after each sensor is replaced, will drive fine for a day or so, and then will leave you stuck. All attempts to diagnose, end in codes that have already been fixed

On October 12, 2021about 1:30pm, I was at my dentist office. As I was leaving, my 2016 Jeep Compass would not start. I called my wife to bring jumper cables to me. I jumped my vehicle and started towards home. My driveway has a slite income and I drove just inside the overhead door and stopped. For a moment, I took my food off the brake pedal to draw my drivers mirror inward, at that moment, the vehicle started forward. I slammed my foot unto the brake pedal and the pedal went to the floor, not stopping the vehicle before hitting my work bench. The front edge of the hood had five dents in it. I made an appointment with the local Jeep dealer for October 19, 2021. I explained to the service adviser, about the battery and brake pedal, both happening on the same day. Later in that day, the adviser called me at home. They could not find a problem with the brake system, However, they said I needed a new battery. I gave them the okay. Several times sense that time, I have felt like my pedal was going to the floor, while stopping the vehicle.

The contact owns a 2016 Jeep Compass. The contact stated while driving 25 MPH and attempting to accelerate, the vehicle failed to respond, lost motive power, and stalled. The vehicle was taken to the dealer to be diagnosed; however, the mechanic was unable to retrieve a fault code. The contact explained to the dealer that the vehicle was experiencing the failure listed in NHTSA Campaign Number: 16V907000 (Engine and Engine Cooling) but the dealer stated that the VIN was not included in the recall. The manufacturer was contacted and stated that there was nothing that they could do because the vehicle was not under recall and referred the contact to the NHTSA for assistance. The failure mileage was 59,000.

Vehicle has a slow acceleration ration. I was merging onto the Freeway and pressing on the accelerator, but it does not accelerate. It takes quite sometime to pickup speed, throttle body light has just started coming on along with the check engine light. Purchased Vehicle 8/2021, no acceleration from the beginning. Check engine and Throttle Body light 2-3 weeks ago.

The contact owns a 2016 Jeep Compass. The contact stated while driving 35-40 MPH, the vehicle began to stall. The contact depressed the accelerator pedal and the vehicle started sputtering. The contact pulled into a gas station and refueled the vehicle. The contact was able to continue driving; however, the failure reoccurred while driving. The electronic throttle control indicator warning light was illuminated. The contact veered to the side of the road. The dealer and the manufacturer were not notified of the failure. The failure mileage was approximately 104,000.