2015 JEEP RENEGADE Complaints

When starting the car and letting it warm up for 2 minutes. The vehicle shifts hard or takes it time to shift into next gear, and while idling for less than 5 minutes, the car warms up 32 degrees. Which I do not believe the fan motor is working properly. Also took car to dealership blown trans and engine mounts.

The contact owns a 2015 Jeep Renegade. The contact stated that while driving at an undisclosed speed, the vehicle was consuming an excessive amount of coolant, and there was white smoke coming from under the hood. The check engine warning light was illuminated. The vehicle was taken to a local independent mechanic, where DTC: P0481"Engine Cooling Fan Fault" was displayed. The local dealer was contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 50,000.

After I filled up my tank, I drove and turned onto a busy highway. As I was turning, it felt like my car went into neutral. I had to take my foot off of the gas and looked to see if the shifter switched gears, but it was still in drive. After about 10 seconds it shifted into gear. If I did not wait for the road to be clear I could have gotten into a major accident.

p 215/65 R16 98H SL BSW. date of Manufacture 0919. Made in Canada. What happened the car four tires became a hazard to drive after 6 years from installing the tire . The problem is the deterioation of the rubber was unknowable only by experts. Furthermore, I did not consider my experience enough so I had to confirm it with local shops belle tire and a small local shop . However, In my experience other than the visual.To get accurate analysis I need to apply multiple tests, like chemical component analysis to be verified as manufacture deficiency .Those expansive lab resting over my budget. I had replaced all tires on 06-14-2025 with Cooper tires.P.S. Many drivers don't check their tires they just trust a brand .

Complaint Summary: I brought my 2015 Jeep Renegade Trailhawk (VIN: [XXX] ) to AutoNation CDJR Roseville on May 17, 2025, for the U90 emissions recall. The catalytic converter was replaced, and the PCM software was updated. However, the U0402 diagnostic trouble code (implausible data received from TCM) remains stored. This code has been persistent and prevents the vehicle from passing California emissions, which is required for my registration as the car was transferred from out-of-state. The service advisor initially stated that the TCM was updated, but later corrected himself and admitted the TCM already had the latest version and was not reprogrammed. I have not been given written confirmation that the TCM software or wiring was verified or addressed. I am concerned the dealership is refusing to properly resolve this under recall and is instead recommending a full transmission replacement without supporting mechanical codes or verifying the emissions system software/communication is compliant. I’m requesting FCA’s assistance, and the BAR in California to enforce the complete and proper execution of the U90 recall and resolution of the U0402 code under recall scope. Please help ensure the vehicle is brought into emissions compliance. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

When adding fuel at the gas station through vehicle Cap-less fuel fill tube, gas pump nozzle could not be removed without pulling on it which snapped the small thin plastic tabs holding cap-less fuel port in place. According to the manufacturer and repair Shops the entire fuel filler tube system has to be replaced and requires the gas tank to be removed to install the new tube This is a very poor design with poor quality materials and will cause fuel spills and combustion

The 2015 Jeep Renegade has had a vibrating sensation since I purchased it used in 2021 from an auto dealership. The vibrations got stronger as time went on. The issue was finally determined what caused the vibrations in May, 2025 and confirmed by an independent mechanic. The vehicle was inspected by a Jeep dealer previously. The vehicle was not inspected by the police or insurance representatives. The auto needed a new Engine Motor Mount. A new one was installed on the front right side, engine mount. The auto is available for inspection. My safety and the safety of others was put at risk because a failed mount leads to excessive engine movement, which can damage other components, affect handling, and lead to accidents.

The Evaporative Emissions System (EVAP system), including components such as the charcoal canister, purge valve, and/or fuel tank venting system, appears to be malfunctioning. The vehicle is available for inspection upon request. After refueling the vehicle completely, it will stall or shut off unexpectedly while driving, which could cause a collision, particularly in traffic or at highway speeds. This sudden loss of power places myself, my passengers, and other drivers at significant risk. The vehicle has been inspected by an independent mechanic, but not by the manufacturer, police, or insurance representatives. No warning lights, error messages, or advance symptoms were present prior to the vehicle stalling. The issue first occurred around 2022.

The contact owns a 2015 Jeep Renegade. The contact stated that after having an oil change, the engine started to misfire. The contact stated while driving 75 MPH, the vehicle decelerated to 15 MPH and failed to accelerate as needed. The check engine warning light was illuminated. The vehicle was taken to the local dealer where it was diagnosed that a multi-air actuator replacement was needed. The part was on backorder. The vehicle was not repaired. The contact stated that DTC: P0304, P106B, and P1064 were retrieved and were related to the failure. The manufacturer was contacted, but no additional assistance was provided. The failure mileage was approximately 145,000.

The contact owns a 2015 Jeep Renegade. The contact stated that while driving at an undisclosed speed, the vehicle suddenly shifted into neutral independently. The contact was able to pull over to the shoulder of the roadway, where the failure persisted. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the shifter assembly tower lever. The vehicle was repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA hotline for assistance. The failure mileage was 86,000.