2013 JEEP WRANGLER Complaints

ABS, dash lights have come on. BRAKE, ABS, Traction. When needing to do sudden braking on wet road tires lock up and Jeep slides. When asked a dealer I was told that the ABS had an internal fail and that replacements are Not aviable. After researching they can not be found or repaired and was told to buy a used replacement. When one was located they said it was no warranty and that it would most likley fail also because they "all fail". Doing an online search this is a wide spread problem and dealers have no fix.

My ABS, Brake and Traction Control lights all came on 1 month ago. Error code from shop is C2200 indicating a faulty ABS Module. They cannot find a replacement from any Jeep dealers. My online search also unsuccessful as none of the sites have them in stock. Been told by everyone that there is a national shortage and none are available due to Jeep not making them either anymore or cannot keep up with the demand. Now I cannot drive my Jeep safely and there is no timely help. This is a HUGE issue!

The ABS Module for my 2013 Jeep JK Unlimited is not functioning anymore and the manufacturer discontinued the ABS Module and its chip, not allowing repair services to fix them. So I am stuck driving my Jeep with no ABS brakes and placing the car at risk of driving.

The ABS Control Module failed. After checking with the dealer, the part is unavailable unless you agree to pay 4x the price. After further research, blogs, online info, it appears this part is back ordered because of a widespread failure. This is dangerous and should have been recalled. Instead they are releasing small amount of part for the purpose of gouging.

ANTILOCK BRAKE CONTROL MODULE FAILED BRAKE LIGHT/ ABS LIGHT/ TRACTION CONTROL LIGHT ON BRAKES SPONGEY- LOW PEDAL-NOT RESPONSIVE-, FRONT & REAR END WOBBLEY-UNSTABLE "UNSAFE TO DRIVE" NATIONAL BACKORDER FOR REPLACEMENT PART- DEALER SAID THEY HAVE BEEN WAITING FOR A YEAR 1/2 ALREADY WITH NO ESTIMATED PARTS REPLACEMENTS. NO WRECKING YARDS HAVE PARTS, AND NOT AVAILABLE ONLINE, AS WELL AS NO ONE CAN REBUILD

The contact owns a 2013 Jeep Wrangler. The contact stated that the ABS warning light was illuminated, and a message indicating that the brake light bulb had failed was displayed even though the bulb was operable. The vehicle was taken to an independent mechanic, where it was diagnosed, and determined that the ABS module had failed and needed to be replaced; however, the part was not available. The contact stated that the mechanic contacted several dealers and was informed that the part was on backorder or had been discontinued. A local dealer also informed the contact that an ETA for the part could be provided, but the part would not be available on the expected date based on past experience. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 95,000.

The contact owns a 2013 Jeep Wrangler. The contact stated that while operating the vehicle, the air bag warning light remained illuminated. The contact was concerned that the air bag might not deploy in a crash. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 18V021000 (Air Bags). The contact stated that the vehicle had experienced the failure listed in the recall. The cause of the failure was not yet determined. The manufacturer and local dealer were not contacted. The failure mileage was 70,450.

ABS system has failed and Jeep dealer said the parts are on back order and has been for over a year. Depending on who your speaking to at Stellantis they are either re-engineering the part or they are no longer manufacturing it. While my Jeep still drives, there is a major safety concern due the ABS and traction control being unavailable. There is a whole thread set up online and this problem is affecting many people. [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Oil pressure sensor failed. Fixed that. Check engine light came back on with battery light. New alternator. Check engine returned for oil pressure sensor. Temp gauge is fine. Changed oil twice within 3 months. When replacing jeep alternator melting of wires to alternator had occurred. This seems to be an issue with this model.

My 2013 Jeep Wrangler Rubicon, has a non-functional horn and steering wheel controls, including cruise control and audio buttons, which stopped working in. I suspect a faulty clockspring, as these symptoms match issues in prior Jeep Wrangler recalls for 2007-2012 models (NHTSA campaign 11V528000), where clockspring failures also disabled horns and risked airbag malfunctions. My vehicle shows. This poses a safety risk, as the horn is critical for avoiding collisions. No repairs attempted yet, but similar complaints appear online from other 2013 Wrangler owners. Please investigate for a potential recall.