2013 JEEP WRANGLER Complaints

The components in the N28 / NHTSA 13V-234 recall did exactly what they were recalled for. My check engine light came on a few months back so I brought it to be diagnosed at a parts store and diagnostic scanner listed P codes for possible O2 sensor. I brought my 2013 Jeep Wrangler Sport into a Jeep dealership(#1) in Friday, November 1st, 2024 and upon the first inspection, they found a couple of issues and printed an quote for $127.33, I signed off on that quote. Then another hour or 2 passed by, they brought me a revised quote for over $600, which I was still okay with and signed off to have repaired. Then they offered to bring me home after hours of sitting in the lobby. The next day, I get a link to review the revised inspection and it was over $2400. The engine charge was over $1900 caused by the N28 recall. I asked them to just do the recall because I could not afford it the remaining. Upon looking into forums, documents & diagrams researching online specific to the N28 recall, I reached out to the manufacturer quite a few times by phone and email. I was working with someone who I thought would be helpful, since he suggested I call a different Jeep Dealership (#2) Service Dept. and speak with a mechanic there. I spoke with a mechanic at #2 and sent #1's inspection report, and #2 dealership's mechanic confirmed the issues are connected & caused by the recall. The manufacture's contact (that I thought was more helpful than the ones I spoke with prior) was emailing me. I reported back to the contact on November 14th, 2024 what dealership #2 said and he never responded. I followed up for a response on November 21st, 2024. I still have no response as of January 30th, 2025.

The contact owns a 2013 Jeep Wrangler. The contact stated while the vehicle was parked, the air bag warning light intermittently illuminated. The failure occurred on several different occasions. The vehicle was taken to an independent mechanic to be diagnosed; however, the diagnosis was still pending. The contact researched and was made aware of NHTSA Campaign Number: 16V288000 (Air Bags); however, the VIN was not included. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 167,000.

The contact owns a 2013 Jeep Wrangler. The contact stated while driving at an undisclosed speed, there was an engine misfire, with the check engine warning light illuminated. The vehicle was restarted; however, the failure recurred. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure and confirmed that the VIN was not included in TSB: 09-002014 Rev. B (Engine). The approximate failure mileage was 95,000.

The contact owns a 2013 Jeep Wrangler. The contact stated while driving approximately 30 MPH, while depressing the accelerator pedal the vehicle failed to respond. The contact stated that it felt as if the transmission had seized. The contact stated that the RPM was revving however, the vehicle failed to respond. The contact stated there was no warning light illuminated. The contact stated that during a state inspection, the contact was informed that the passenger’s side rear axle shaft seal was leaking. The contact had taken the vehicle to a local dealer; however, the vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 116,000.

ABS module has gone bad and Jeep Chrysler dealership has told me that they only have nine parts in the nation to replace it and the engineers are not confident in the replaced part, they won’t know when the part would be available and I was also told that if I continue to drive it I could potentially damage other components of the Jeep Wrangler. I was also told by personal mechanic that I shouldn’t drive it as I don’t not have Anti lock breaks..

Clock spring assembly had to be replaced. Horn would not work due to this. This appears to be a problem in jeeps but no recall yet on this specific model

The contact owns a 2013 Jeep Wrangler. The contact stated while driving at approximately 40 MPH the "air bag" warning light illuminated and the horn became inoperable. The contact stated that the failure occurred at various speeds. The contact stated that the failure was intermittent. The contact was aware of an Extended Warranty for the clockspring. The contact had driven the vehicle to a local dealer however, the dealer was unable to retrieve diagnostic trouble codes associated with the clockspring, and the vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 115,000.

While I was attempting to park my jeep across the street from my grandson's school to pick him up at 3:18, as I proceeded to pull in front of the apron so I could backup to a parking spot. In the process of going forward before I got a chance to put the jeep in reverse my brakes failed, hitting a parked car in front of me. I had my jeep towed to Old Center Island Auto Service. The mechanic removed a defective power brake booster and replaced it with a new one.

The fuel supply line that attaches to the fuel rail at the engine sprung a leak at the seam were the plastic tube is sealed together. This is a high pressure line. This resulted in fuel being sprayed directly on the hot cylinder head creating a potential fire hazard.

The oil pressure sensor, I was in traffic and the vehicle came to a stop with scared the hell out me and this has hall a couple of time and came to find out it was caused by the oil pressure sensor. Why this is not on recall