2021 JEEP WRANGLER Complaints

March of 2023. Vehicle started hesitating and skipping. P0001 was logged. Dealership found terminals to connector to fuel pressure regulator were not crimped properly and loose. Repair was made. Aug 2023. Symptom have resurfaced this time logging code and shutting off while accelerating through an intersection. Logged code again P0001 Fuel Volume Regulator Control Circuit/Open.

Serious steering wobble while driving on highway in Denver at approx. 65 mph yesterday plus same serious wobble at lower speed (~60 mph) while passing car on country road. Took nearly a mile to stop the wobble and speed reduction to around 35 mph to stop! Very dangerous situations in both cases.

As I review events in chronological order, I see that a possible disconnect might be caused by clumping the symptoms together and treating as the “death wobble,” when in fact I may be experiencing two separate issues, the first being a failed steering damper and the second being caused by possible bad ball joint[s]. I first started to experience an issue around 7,000 miles in where the Jeep would pull to the right. It was a strong pull because my steering wheel would be turned to the left at about 15-25 degrees to the left in order to keep straight. had them check the alignment. The invoice said the alignment was checked and it was “ok,” December 24 – Florida gets a cold front and we experienced temperatures in the low 20’s with the high temperature peaking at 32 or 33 degrees for a couple days. I drive my normal route on the highway and as I am approaching 65 mph, I go over a transition from asphalt to concrete bridge and the car starts to do the death wobble, where a strong vibration from the front end shook the car until I let off the gas and slowed down to about 40mph. my sister-in-law also experienced in her 2020 Jeep, the same day the freeze set in. Ive had steering gearbox changed and two stabilizers replaced already, JEEP TSB once stated: JL JT have unique torque values for ball joints as compared to prior JK models due to material (aluminum knuckles) and design changes. I guarantee its the crappy ball joints and they REFUSE to admit it. Jeep still claims they cant duplicate the issue or i need to replace tires (that are wearing unevenly bc of ball joint issues) befor they can continue diagnosis. 4 different dealerships. 4 different outcomes. even [XXX] from their corporate office stopped responding to me. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2021 Jeep Wrangler. The contact received notification of NHTSA Campaign Number: 23V116000 (Power Train) however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated while driving at an undisclosed speed, the clutch and transmission failed to operate as needed. The vehicle was not diagnosed or repaired. The failure mileage was 30,500. VIN tool confirms parts not available.

The upper spring perch located at passenger rear is welded to the frame on one side and a crossmember on another. The two vertical welds failed with the remaining welds being at the top of the spring perch. The only indications of a problem were an occasional knocking sound when going over a bump and severe vibration coming from the rear of the vehicle. The noise was caused by the spring perch flexing and tapping the bottom of the body. I believe the welds broke early this year but the source of the noise wasn't found until July 2023. With prolonged use in this condition the spring perch can completely fail causing the spring and perch to fall out and make the driver lose control. The dealership submitted pictures and the manufacturer has agreed to replace the entire frame. There are a handful of other people that have reported the same problem (always on the passenger rear) but because of the design, I suspect as these vehicles age stress fractures in the weld will make this issue more prevalent.

I had the front wheels “wobble”. I had shocks replaced and a steering damper installed. The front end still bounces up and down, or wobbles, on every interstate overpass at interstate speeds.

Fuel Sensor is way off. Have ran out of gas less than 2 mins after dropping below a 38 mile range twice now. Drive 20 miles round trip everyday and go through a 60 mile range on my vehicle. I watch the range decrease by four or five miles while in idle.

Today doing approximately 65 to 70 miles per hour on highway 20 in Ft Worth just hit approximately 1 1/2 inch transition in pavement where they had added an extra layer of asphalt in the lane I was in the vehicle started wabbeling so bad I thought it was going to change lanes, approximately 10 miles later it did the same thing again felt like the front wheels were about to come off the vehicle. I have called Meador Jeep in Ft Worth and they recommended I park the Jeep and not drive it until they can get it in and check it on 8-25-23

Persistent death wobble vehicle is stock with no modifications. Driving at 65 on the highway a single small bump will cause violent shaking of the steering wheel and the front end. The shaking is aggressive enough to make you lose control of the vehicle and cause an accident. The vehicle has been for service multiple times for this issue. Every time the issue persist without resolve.

6 - 29 - 23 when engine was started several warning lamps lit up including service electric stability control . as i drove the vehicle the power steering was out and vehicle was hard to control . had vehicle towed to dealership service dept. vehicle in warranty . no repairs done to vehicle and as of 8 - 7 - 23 vehicle is still in the shop. safety of me and others at risk if vehicle continues in this condition without repair.