2017 JEEP WRANGLER Complaints

Clockspring failed. No horn, driver airbag, controls to cycle evic and radio stopped working.

The contact owns a 2017 Jeep Wrangler. The contact stated that while the vehicle was parked, he became aware of an oil leak underneath the vehicle. The contact stated that the failure had persisted. The dealer was notified of the failure and an appointment was scheduled for a diagnostic test. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 31,000.

Severe "death wobble" at speeds over 40MPH occurs at random times, usually at highway speeds. Have replaced steering damper, shocks, upper and lower control arms, front u-joints, etc....and these repairs have only masked the problem. The OEM suspension is completely unmolested...no lifts, etc. Tires were replaced around 55-60K miles with a slightly wider tire. Wobble started around 95-100K miles. Currently around 115K miles on vehicle.

The oil filter housing on this engine is made out of plastic and if you search online you will notice that it has failed for many many people. The housing cracks causing motor oil and coolant to mix and leak. We were fortunate to notice it before our engine seized up, but others have not been as fortunate. I believe this defect should be a recall, but there is no recall on this engine even though many many people have experienced this part failing prematurely. Ours failed when the Jeep was under 80,000 miles.

Driving at 65 mph on the highway the hood latches failed and the hood blew back into the windshield, shattered the windshield, and made driving a safety issue. The safety latch also failed. Not able to see out the windshield due to the hood. Spoke with jeep cares and they said the hood latches were not a warranty item. The dealer said it happens frequently that the latches break. I have pictures of the defective latches and filing an insurance claim this week. This is a factory defect that could cause serious injury or death if not fixed.

The airbag light is on. The clocksprin is the failure and is very expensive at the dealer.

2017 Jeep Wrangler Unlimited with 44,000 rear brake calipers sticking and burning smell. Had brake pads and calipers replaced on all 4 wheels. At approx 60K miles, rear brakes were sticking and smoking. Right brakes wearing unevenly compared to the left side, both front and rear. Caliper seals are leaking. Replaced 4 brake hoses, Calipers and Pads AGAIN. At 70K miles rear brakes locked up and caused a fire on the rear passenger wheel which created unsafe driving conditions with 2 small children on board. I had to stop on the side of a 2 lane road with small shoulder, quickly evacuate the children onto the shoulder of the road and extinguish the fire using an on-board suppression device. We then had to wait for towing assistance on the side of the road for 90 minutes. Brakes, Hoses, Calipers replaced all around. Again.

The airbag clockspring is defective. I know other years have a recall on the defective part. The cost of labor and the cost of the part is too expensive. I consider this a safety issue and feel like it should be under a recall like the previous model years.

2017 Jeep Wrangler, approx 46k miles, driven gently (only highway and city), well-maintained. Problems with Brake Calipers seizing. Back Driver calipers/lines/pad/etc replaced. ABS and brakes jammed last week. Front and Back Passenger calipers, rotors, brake fluid lines and brake pads advised by mechanic. Brakes temping 550 - unreadable (temp gun wouldn't register) Mechanic recommends unsafe to drive because brakes could seize and cause sudden stop and/or accident Dealer says too bad, normal wear and tear. This is our family's 10th Jeep, and NOTHING has happened like this before. Seems like a safety issue perhaps that Jeep should be addressing rather than putting on the consumer (who will no longer purchase Jeeps)

A check engine light came on and when diagnosed it was the Electronic Vacumn Pump which runs the braking system. I see there is a TSB from FCA (Fiat Chrysler Automobiles) about this problem.. Case Number: S1805000006 Release Date: 02/24/2020 Symptom/Vehicle Issue: ESC Light Illuminated. DTC C1252-92 VACUUM PUMP CONTROL CIRCUIT And Or P258B ELECTRONIC VACUUM PUMP PERFORMANCE Discussion: If ABS has C1252-92 Active or Stored do not replace the brake system module (ABS). PCM may also have set P258B-00. The faults are pointing to vacuum pump system having an issue maintaining vacuum levels. Please check the vacuum pump operation, fusing, wiring, and connector for proper functionality. Poor connections, spread pins, damaged connectors are possible causes. Perform the diagnostic for the DTC P258B regardless if it is set or not, since it is more compressive of a test than C1252-92. In addition when checking Vacuum lines, please ensure to check Vacuum hoses and check valves between the engine intake, booster and vacuum pump. Because the check valves only allow flow of air on one direction, each vacuum circuit must be checked separately to make sure there are no leaks, kinks or damages. Please refer to the correct vacuum diagram. For KL vehicles: inspect ALL under hood grounds for connection and contact issues. My Jeep is at the Ford Dealership I work at at this time. Didn't want to drive any farther than I had to at this time.