2014 JEEP WRANGLER Complaints

Oil filter Housing and Intake Manifold had to be replaced dues a coolant leak. "Common" issue on Jeep's they said. But Despite knowing about this issue, the company has never issued a recall, instead, they redesigned the oil filter housing.

ABS anti lock break system , intermittent warning on the dashboard, brake and traction lights. Pep boys and auto zone both describe there is an internal malfunction with no specific codes , they can not prescribe a fix as the speed wheel sensors are working ok. Jeep forums say it may not be safe to drive as wheels may lock under hazardous driving conditions.

I have numerous warning lights all on at the same time and constantly chiming as I drive. These are the following lights that are all on: check engine, air bag, ABS, brake, and traction control. I have read past communication which addresses problems. I truly believe none of these issues were addressed prior to my purchase in 2020.

The contact owns a  2014 Jeep Wrangler. The contact stated the rear driver's and passenger's seat belts were ripped. The vehicle was taken to the dealer and confirmed that the seat belts were ripped and needed to be replaced. The manufacturer was made aware of the failure. The failure mileage was approximately 47,000. The VIN was unavailable.

Driving sometimes with cruise on and sometimes not or going up a slight inclined the car will lose RPM goes down and then back up. I Was merging on to a highway went to give it gas and RPM goes down and I had 2 semis coming up on me so had to pull over to shoulder. It is very unsafe because you just dont know when it is going to do it. Have had it in to dealership computer and no code. But very very frustrating. They have put computer on and drove around and of course it wouldnt do it. We are at our end of the rope we don't know what to do. Service dept just said if it doesn't throw a code cant do anything. I guess when we get hit they wiil do something.

There needs to be a recall on the 2014 Jeep wrangler oil filter housing immediately. My Jeep has the Pentastar oil filter housing used in these vehicles can crack and warp due to heat exposure and this can lead to serious oil leaks. Despite knowing about this issue, the company has never issued a recall, instead, they have discontinued the production of the Pentastar and redesigned the oil filter housing for newer vehicle models. My jeep was pouring out oil and the red oil light turned on. I immediately had my jeep towed to the dealer . They had already "fixed" this issue two times previously. It is beyond comprehension that this has not been a manufacturer recall. It is extremely dangerous.

The contact owns a 2014 Jeep Wrangler. The contact stated that the vehicle was experiencing electrical failures. The check engine warning light was illuminated intermittently, and the infotainment system failed to turn on. The vehicle was taken to the dealer, where the oil sensor pressure circuit was replaced due to an internal short in the oil-sending unit. Additionally, the PCM software was updated, and the infotainment system was replaced. The contact also stated that the fuel gauge provided inaccurate readings and would not read that the fuel tank was full. The vehicle was taken to the dealer twice for fuel gauge failure. The dealer performed a PCM software update for fuel sender recalibration and replaced the fuel pump module. The contact stated that the traction control warning light illuminated intermittently, and the vehicle was taken to the dealer, who replaced an unknown sensor. Additionally, the contact stated that the vehicle was experiencing an electrical draw, and the battery was replaced four times. The vehicle was taken to the second dealer McCord's - Dodge Chrysler Jeep Ram (990 Tennant Way, Longview, WA 98632) where it was diagnosed that the electrical draw was due to a failure of the instrument cluster electrical wiring or a failure of the electrical wiring underneath the dashboard. The vehicle was not repaired. The manufacturer was notified of the failure but did not provide any assistance. The failure mileage was approximately 46,000.

The contact owns a 2014 Jeep Wrangler. The contact stated the air bags, and the traction control warning light was illuminated. The contact took the vehicle to an independent mechanic, where it was diagnosed with needing the clockspring to be replaced. The vehicle was not repaired. A dealer was not contacted. Upon investigation, the contact associated the failure with NHTSA Campaign Number: 16V288000 (Air Bags) however, the VIN was not included. The manufacturer had been informed of the failure. The failure mileage was approximately 74,500.

The plastic oil filter housing cracked. So many have cracked you can’t find one to replace it. Metal ones are being made but can’t find those either. It’s a HUGE problem and with minivans.also. They need to recall all the plastic oil filter housing units.

RECALL # 16V-288 28 JUNE 28, 2016 CLOCKSPRING ON 2014JEEP , WRANGLER UNLIMITED SPORT 4X4. VIN: 1C4BJWKG3EL257078--- **RECALL - REPLACED CLOCKSPRING 22 AUG 2016 @ 73,416 MILES (N/C), *** REPLACED CLOCKSPRING 6 FEB 2019 @ 133,086 MILES (N/C) TEAM DODGE - THEY WARRANTY PARTS FOR 2 YEARS. **** REPLACED CLOCKSPRING @139,571 MILES 20 MAY 2019 -- COST $622.74, "SHOULD" HAVE BEEN NO CHARGE AS TEAM JEEP IN HUNTSVILLE TX 77340, WARRANTS PARTS FOR 2 YEARS ???? "LAST VISIT: 1 DEC 2022" TO DEALER @ 219,882, TO REPLACE FUEL PUMP, THE CODES READING, WHICH I REVIEWED, BESIDES WHEEL SENSOR & FUEL PUMP, ALSO READS CLOCKSPRING FAIL:- HORN NOT WORKING, ENGINE LIGHT ON, ELECTRONIC STABILITY CONTROL LIGHT ON, AND LEFT SIDE OF STEERING WHEEL CONTROLS NOT WORKING WHICH INDICATES CLOCKSPRING FAILED WHICH EFFECTS AIRBAG. ALL MECHANICAL REPAIRS WERE MADE AT THE DEALERSHIP WHERE VEHICLE WAS PURCHASED IN 2014. BACK ON 6 FEB 2019 I ASKED THE MECHANIC THAT WAS REPLACING THE CLOCKSPRING IF THE REPLACEMENT PART HAD BEEN UPGRADED, IMPROVED, A DIFFERENT NEW UNIT ----"ANSWER WAS NO", IT'S THE SAME OLD JEEP INSTALLED ORIGINAL PART BY CHRYSLER /JEEP COMPANY. "IT IS A SAFETY ISSUE AND A RECALL SHOULD BE ISSUED AGAIN" !!! MY QUESTION, IF I HAVE TO PAY FOR A REPLACEMENT CLOCKSPRING AGAIN, HOW MUCH I IT GOING TO COST ME AGAIN FOR THE SAME ORIGINAL PART THAT FAILS SO FREQUENTLY ??????