KIA Complaints

I was driving the Forte and my steering wheel started to feel loose. It would click when I turned it. When I would go over a speed bump or hit a pot hole, my steering would jolt and make a loud noise. While driving on the highway, steering seemed loose and wasn't stable. I drove slower because I was afraid the problem would become worse or I would lose control of the steering.b

Windshield wipers are not strong enough to deal with even small amounts of snow. The gap between the windshield and the hood is unusually large which allows snow to accumulate and get packed into the gap. The wiper motor stops functioning even with a small amount of snow accumulation in that gap. Even when completely cleared before driving, when snow gets pushed down from the wipers or slides off the roof into those gaps, the wipers stop functioning immediately and view is completely obstructed. Took me 10 minutes with a garden spade and my finger nails to dig out every piece of snow before starting my drive, then had to pull over twice during the drive to do the same thing again. Even when a small chunk of snow slipped down (the size of a hand), the wiper couldn’t push it back up and off. This is extremely dangerous where winter snow is a daily problem.

The contact owns a 2019 Kia Optima. The contact stated while driving at undisclosed speeds, the check engine warning light was flashing, and the vehicle went into LIMP Mode. The vehicle was towed to the local dealer, where it was diagnosed and determined that an unknown sensor needed to be replaced. The vehicle was repaired, but the failure recurred. While driving 65 MPH, the driver came to a stop, and upon accelerating, the check engine warning light started flashing. The vehicle was consuming an excessive amount of engine oil. The contact used a code reader and determined the failure was with the knock sensor. The vehicle was taken back to the local dealer, who determined that the knock sensor needed to be replaced. The dealer informed the contact that there was no warranty coverage on the vehicle for the failure. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 92,000.

Engine failure after a pass sc147 safety recall. Vehicle has a rebuilt title and does not qualify for manufacture warranty. Does this engine not still qualify for the sc147 recall,

Battery keeps dying even after replacement. I would drive it then park it overnight and the next day it would dead. this put my safety at risk because at any time my car could die and I wouldn’t know until I sat in it. I would then have to figure out what to do next since the last 3 times it has died i was stuck with important work to do. There were no warnings or symptoms that first appeared. We have taken it to the dealership and they replaced the battery, but it has died again even after battery replacement.

I purchased my car 10/12/24. On 11/2/24, one of the first times I had used cruise control, I was traveling between 40-45mph in a residential area and turned on my cruise control. The car immediately set the CC speed to exactly 110 mph and would not respond to the down arrow to adjust speed down. I paused CC and resumed and the setting remained at 110mph. I am not sure what caused the setting to finally clear as I was pretty frantically pressing buttons at that point. I do have a photograph of this instance and I have added it to this report. A brief google search confirmed multiple Kia drivers reporting the same issue with this line of vehicles. On 11/5/24 I took my car in to Olathe Kia's service department, asking them to investigate this issue. The service department reported that they found no error codes and had no repair to offer for the CC issue.

Gauge cluster is completely black. I am unable to tell the speed I am going, see how much gas I have or use features like the blind spot detection.

While driving a red wheel icon with exclamation mark appeared on the dash. This caused for my car steering wheel to become increasingly hard to maneuver and drive while on the highway driving about 60mph.

Previous Complaint# 11618337. Additional Information: Engine is full of oil yet Oil Light comes on due excessive crankshaft & connecting rod bearing wear and knocking loud. Yet the recalibrated knock sensor will not pick up the issue and put the vehicle into derate with a code P1326 as it did before the Kia Dealership performed this recalibration. This is consumer fraud by purposely hiding a known defect and preventing the warranty from replacing the engine with a redesigned new engine that corrects the issue with larger oil ports. It is also a safety issue!! Now that the oil light is coming on and the engine has a bad knock, it can fail at anytime while driving causing lose of power steering, brakes and the ability to safely pull the car over to a safe location. The original P1326 code automatically determined the engine developed wear from lack of oil volume based on the known defect of too small oil ports. This recalibration doesn't address the wear the engine already has and based on what the dealer stated, they will not replace the engine until that code comes back. Which now can't happen due to this parameter change and elimination of the knock sensors ability to perform it's job correctly. Please investigate and resolve, Thank you!!

The contact owns a 2009 Kia Optima. The contact stated while driving at approximately 35 MPH, the vehicle was making an abnormal knocking noise and then stalled. The contact stated that the battery and check engine warning lights were illuminated. The contact was able to restart the vehicle. The contact drove the vehicle to an independent mechanic and the vehicle stalled several times while driving to the mechanic. The mechanic had diagnosed the vehicle and determined that there were metal shavings in the oil pan and that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 152,000.