2018 MAZDA MAZDA3 Complaints

The driver side if the door handle metallic wrap has begun peeling, I reached for my door handle and was cut by the wrap as it had torn away from the glued seems. It is small enough to cut my hand but barely visible to the naked eye. I had to put tape over the door handle to prevent further cuts from happening on my fingers. I took 2 photos as soon as the injuries happened and I realized what it was that was causing me to bleed from my scrape. The vehicle currently has a class action suit for the gas fuel pump and i contacted mazda to fix the pump and replace the door handle.

NHTSA: #23V-487 This recall has not been resolved yet despite it being established in July 2023. States no remedy available, and this is very frustrating.

The contact owns a 2018 Mazda Mazda3. The contact stated while reversing, the rearview camera image was flickering and occasionally failed to display an image. The vehicle was taken to the dealer several times. The dealer recommended that the rearview camera be replaced. The vehicle was not repaired. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 25,000. VIN tool confirms parts not available.

Recall 23V-487 has been un-remedied for over a year. And it sounds like a zip tie would fix it. That's too long.

I was parked in a downtown garage, and the vehicle would not start after many attempts, after about 45 minutes of trying (waiting 5 minutes between tries). The engine would turn normally and sounded like it was trying to start, but didn't fully engage. It finally did after 45 mins, and I drove it to the local Mazda dealer in Honolulu. I noticed the check-engine light was on at that time (but not before the incident). They ran a diagnosis, and couldn't replicate the issue, and said it may be a battery problem with low voltage, due to the engine's error codes. But I questioned that since the engine was able to turn normally and adequately at all starting attempts. And the battery was only 2 years old. So I replaced the battery at their recommendation. About 2 hours after picking up the car from the dealer, the same issue happened again. I recorded the issue on my phone this time, and gave it to the dealer. And this time I didn't want to chance it, so had the car towed back to the same dealer. They couldn't replicate the issue immediately, but after several attempts (over a day), they finally experienced it. They said the issue is the fuel pump. I am the original owner, and had purchased the car new from a Mazda dealership, and it has less than 26K miles on it. I researched previous recalls with this same issue on Mazdas, even the same year and model, and it appears to related: [XXX] [XXX] No one was physically harmed due to this issue, but it was certainly a safety risk. If the fuel pump fails while driving, the driver could lose control of the vehicle while in motion. I have attached the invoices for the repairs. I have contacted Mazda Customer Experience and they assigned a case number # [XXX]. However, I was informed that the repairs are unlikely to be covered as there is no open recall on the VIN regarding this issue. Thank you. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2018 Mazda Mazda3. The contact stated that while reversing, the camera was flickering on and off and the camera was fuzzy. There were no warning lights illuminated. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 60,000. VIN tool confirms parts not available.

The wipers randomly stopped working. No matter which wiper setting was chosen, the windshield wipers would not activate. I took my car to the nearest Mazda dealer and they fixed it by replacing the Body Control Module.

I was officially notified of a known defect in my vehicle "which relates to motor vehicle safey". The defect is the "rearview camera wiring harness" which displays a "distorted or flickering image". My vehicle is experiencing this defect. The letter was sent to me in September 2023. The letter stated that repair parts are not currently available. I have checked and repair parts are STILL not available, even though it is now August 2024, almost a full year later. This is unacceptable as this is a safety concern.

Mazda issued a recall for backup camera failures on specific vehicles over 1 year ago on July 14 2023 (Mazda Recall 6023G, NHTSA #23V-487). According to Mazda dealerships I contacted, parts are still not available. Drivers impacted have been waiting for repair components related to this safety recall for over a year. Simply submitting this as a complaint about an ongoing recall resolution.

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention). The contact stated that on several occasions while in reverse (R), the backup camera flickered and was inoperable. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 130,000.