MAZDA Complaints

I have a 24 CX-90 that is experiencing the steering issue (Recall 24V022) where the steering effort feels like it binds up and locks during slow to medium speed turns, primarily when turning left. No warnings, no codes thrown.

The system that failed was the acceleration. This how it happened the first time, because after that it has happened at least two more in one year. I was leaving my office parking area, and I was waiting for the cars in front of me to continue moving. Then I was ready to start moving and put my foot on the accelerator and just went to a high acceleration. Which I immediately slammed the brakes because otherwise I would have smashed the rear part of the vehicle in front of me. My safety was in jeopardy because if I would have hit the car in front of me and my airbags would have deployed. And the speed of the acceleration was so, that the driver in front of me would have definitely felt it in his neck and God forbids what else!!! Yes, I reported to my dealer, and they said that nothing showed in their computer system, and mentioned something of a throttler not been wrong, (which I don't know what that is). There were no warning lamps or messages in the dashboard prior to the failure. This happened to me again in random occasions where I was just getting my car out of my parking in my condominium, also lucky, it was early in the morning and no cars around. AND the other instance also in my condominium parking area, but this time arriving, and also, lucky no cars near!!!! Your website describes a similar complaint for the same make and model of my car, thus implying that there is a problem with the system.

At only about 6,100 miles and during my vehicle’s first service, the technician found grease leaking from the left front CV boot. The dealer stated this was caused by an external puncture, but they were unable to provide clear evidence, detailed photos, or a written diagnosis proving that the damage was external. The mark they referenced was extremely small and not consistent with a clear impact. A CV boot should not fail at such low mileage, which raises concerns about a potential early-life component failure or material defect. A torn CV boot can lead to CV joint wear, loss of power, or loss of vehicle control if it progresses. Because the root cause is uncertain and the failure occurred unusually early in the vehicle’s life, I am reporting this to NHTSA in case this represents a broader quality or safety issue affecting other vehicles of the same model.

Happened at US 101 Southbound 0.1 MILES SOUTH of RENGSTORFF AVENUE. “Power Steering Malfunction” light came on, then suddenly after 1 second, the car’s steering went stiff and suddenly braked while at freeway speed flow of traffic. Car then sharply veered left into center divider due to automatic sudden braking with no control of the steering wheel

Vehicle: 2025 Mazda CX-50 Hybrid Mileage at first failure: ~6,000 miles Component: Front CV boot / axle assembly — loss of grease Safety Concern: Early-life component failure with unresolved uncertainty in root cause Description: At approximately 6,000 miles, the left front CV boot of my vehicle was found leaking grease. The dealership initially stated the failure was due to “external impact,” but no conclusive evidence was presented to support this determination. The photos and inspection notes did not identify a clear puncture or specific point of impact. Mazda Corporate later informed me that their engineering team concluded the issue was not related to a material or manufacturing defect, and offered a goodwill repair. However, the underlying root cause remains uncertain due to the lack of definitive evidence. Safety relevance: A CV boot failure at such low mileage is extremely unusual for a modern vehicle, and premature loss of grease from the CV joint can lead to: joint degradation, reduced steering stability, potential loss of vehicle control. If similar early-life failures occur on additional Mazda vehicles, this may indicate a broader design, material, or assembly concern. Requested Action: I am submitting this report for documentation purposes in case a pattern emerges or if the issue recurs on my vehicle or others.

I have put on over 20,000 miles since I purchased new in September 2024. The entire time of ownership, I have dealt with false blind spot warnings. With a clean car/clean sensors, it doesn't matter the time of day/night... when driving at highway speeds, the right rear blind spot warning comes on intermittently even when driving in the right lane of interstate with only the shoulder of the interstate next to me and no other obstructions. When this happens while in the passing lane and believing there is nobody next to me and I put on the blinker and try to switch lanes.... it alarms me saying there is something in my blindspot. These are false readings, that make this "safety feature" a safety concern. Sometimes, the car even tries to pull me back in my current lane even though there is nothing in sight in the lane I'm trying to switch to. The I have had the car to the dealership approximately 4 times for this ongoing issue and they claim they are unable to replicate the problem. I have read numerous other complaints reporting the same issue, and Mazda has not developed a fix to date.

I am reporting a safety concern involving multiple loose windshield header bolts and cowl panel fasteners on my 2022 Mazda CX-9. The issue was discovered on 1/28/26 at approximately 44,000 miles. Several bolts securing the windshield header and cowl panel area were found loose. These components support parts located at the base of the windshield. Loose fasteners in this area raise concern about potential windshield instability, movement of the cowl panel, and possible detachment or structural compromise over time. This condition could create a safety risk, particularly at highway speeds, including driver distraction from vibration or noise, potential windshield instability, and possible failure of components mounted near the base of the windshield. The Mazda dealer is aware of this issue. I was informed that they have repaired at least 15 similar vehicles, including those associated with a Roman Service member, indicating a possible pattern. Despite this, Mazda did not cover the repair cost. Given that multiple bolts were improperly secured and that the dealer has seen numerous similar cases, this appears to be a potential manufacturing or assembly defect affecting multiple vehicles. I am requesting that NHTSA review this issue for possible investigation and recall consideration.

Oil is leaking from the front timing chain cover and the vehicle is available for inspection upon request. The issue was caught early enough before it was an acute safety issue, however this issue can cause smoke while driving and cause the vehicle to lose function while driving, endangering those in and around the vehicle in motion. The vehicle only has 35,000 miles on it, has been confirmed and documented by an independent service center, and this is a widespread well-known issue - the service center has had three vehicles in this week with the same exact issue, and Mazda issued a technical service bulletin detailing the issue and stating the root cause is a lack of sufficient sealant applied during manufacturing. The vehicle has not yet been inspected by the manufacturer, police, or insurance representatives - only a service center. There were no warning lamps or messages of the problem prior to failure - I was lucky to have this caught during a routine inspection.

I brought my vehicle to Modern Mazda of Thomaston, CT on Friday January 30, 2026 due to a front-end passenger clunking noise that occurs during left turns. The master tech test-drove the vehicle to duplicate the noise and video of the damage. I was informed that the front passenger axle was leaking grease in video and recommend to replace the front axle. I was told the necessary parts are on back order 6-8 weeks. I was told Mazda is aware of the manufacturer workmanship defect in the CV axle parts. The service manager did provide written documentation ordering the parts. I did file a complaint with Mazda Corporate, documenting the issue and the dealership's findings as well as I was informed the fact Mazda is seeking a new supplier of CV parts. A Mazda corporate case number was assigned. I believe this is a safety issue and a recall should be issued.

I noticed smoke filling the inside of my car. I looked over at the passenger seat, and my coat was on fire. I poured my drink on it, pulled over, and threw the coat out of the car. I saw a large hole in the lumbar area of the passenger seat, and it was glowing red and putting out a lot of heat. The seat heater was on, so I immediately turned it off. It was obvious that the fire has started inside the seat, and there was no other fire source in car--ie. lit cigarette, lighter, etc. If someone had been sitting there, they would have serious burns. The seat will need to be replaced.