2019 MERCEDES-BENZ SPRINTER 3500 Complaints

The powertrain controller and the ignition switch module found to have water corrosion, due to moisture dripping from window condensation. This is a well-known and documented engineering/design flaw of 2019 and newer Sprinters, with the newer electronics located where they are highly susceptible to water damage from window condensation. This results in a sudden "kill" leaving passengers suddenly, unexpectedly, and without prior warning stranded, creating a serious safety issue. Possibly becoming stranded suddenly, without warning in an extreme cold or hot outdoor temperature, and in areas without cell phone reception is a serious safety concern. A tow is necessary to an authorized Mercedes Service Center. Our safety has unknowingly been put at risk, had this happened in an area of no cell reception and adverse weather conditions. Though well documented and known by Mercedes (Sprinter Source.com and Service Departments) this issue has not been escalated to a Recall level. There were no warning lamps, messages or other symptoms of the problem prior to the failure. We have since learned that this issue is not a matter of 'if it happens' but WHEN it will occur. Yet, warranty coverage is not available until until one becomes suddenly stuck and stranded with an inoperative Sprinter. Yes--this should be a Recall! Wilsonville, Oregon Mercedes Service Center says the above condition is well-known, and Mercedes has recommended a fix with a Mercedes plastic bag covering and a relocation of vulnerable electronics. Our corroded electronics were inspected and confirmed by above Wilsonville Service, and our Sprinter is currently awaiting parts for replacement, all under warranty.

The van rolled even though it was in park. the first time it hit multiple cars when it rolled. We took it to Mercedes but they insisted nothing was wrong with the van. Issue happened multiple times and each time Mercedes claimed nothing was wrong. Finally one day it just rolled back and turned over and was destroyed

Stranded and required towing due to condensation and EIS Module The 2019+ Mercedes Sprinter EIS (Electronic Ignition System) module is bolted under the driver side dash board to the base of the A pillar where it meets with the firewall. The electrical connector of the module is pointing straight up - this is an issue because any liquids that might spill on the dash (dash cupholder) or any humidity from windshield interior condensation will drip right down the wiring and into the EIS module causing it to short out. _ If the EIS module shorts out, the vehicle will be inoperable until a new unit is fitted. _ The EIS module retails at $1800+ from Mercedes _ Had Mercedes installed the EIS module with the connector facing DOWNWARD - this moisture related issue would not exist. _ There is no drip loop provisions in the wiring. _ Mercedes is aware of the issue as they have created a plastic bag with part number A 638 546 00 35 and they are charging $20 for it. As of right now, Mercedes refuses to fix this issue preventatively. They will only repair it AFTER the EIS module has shorted out. They are refusing to treat this as a warranty claim even though it is clearly a manufacturer defect.

It appears that driver pressed park and pulled the emergency brake. Its possible it wasn't pressed properly and dealer found no mechanical fault. Vehicle rolled forward and impacted another parked vehicle. This may be related to other issues at RemarkableFoods related to transmission being in "Park" or driver intending to put it in "Park". Video is available for review.

Driver reported that vehicle started rolling while the vehicle was in Park. The parking brake was engaged. Driver was able to stop the vehicle by physically keeping their foot on the brake. Vehicle sent to dealer. Dealer confirmed issue and repaired. Repair details and video of issue available. Other related issues have been identified on other vehicles.

The contact owns a 2019 Mercedes-Benz Sprinter 3500. The contact stated while the vehicle was stationary, the accelerator pedal was depressed however, the vehicle failed to respond. The contact stated that there was no warning light illuminated. The contact took the vehicle to the local dealer however, the mechanic was unable to duplicate the failure. The contact stated that the failure persisted. The manufacturer was informed of the failure. The failure mileage was approximately 10,000.

The contact owns a 2019 Mercedes-Benz Sprinter 3500. The contact stated while the vehicle was stationary, the contact was inspecting under the hood of the vehicle. The grommets under the hood detached and the hood fell and struck the contact on the head. The contact sustained bruising on the right arm which did not require medical attention. The vehicle was not diagnosed nor repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 3,400.

The contact owns a 2019 Mercedes-Benz Sprinter 3500. The contact received a recall notification for NHTSA Campaign number 21V055000 (Electrical System) and 21V152000 (Service Brakes, Hydraulic) however, the parts to do the recall repairs were not yet available. The contact stated that manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not informed of the issue. The contact had not experienced a failure. Vin tool confirms parts not available.

THE MERCEDES-BENZ DEALERSHIP CAN NOT REPAIR THE PROBLEM ON TEH "ECALL" OR THE "BRAKE PEDAL BOLT" BOTH WHICH ARE LIFE THREATENING THEY DEALERSHIP ADVICED ME ON CONTACTING YOU?

WHILE THE VEHICLE WAS NOT RUNNING, STATIONARY AND ON A LEVEL PAD AND ALL DOORS HAD BEEN ELECTRONICALLY LOCKED, THE AUTOMATIC SLIDING DOOR OPENED WITHOUT ANY ACTION BY ME.