2006 NISSAN ALTIMA Complaints

I WAS DRIVING ON THE FREEWAY IN TEXAS GOING 70 MILES AN HOUR ON CRUISE CONTROL THEN TWO UNEXPECTED JERKS IN THE ENGINE HAPPENED AND LOSS OF SPEED AND THE SERVICE ENGINE SOON LIGHT CAME ON. *TR

THE CAR WAS AT THE DEALERSHIP FOR A SCHEDULED SERVICE. I WAS ASKED TO GO INTO THE GARAGE TO LOOK AT THE FLOOR BOARDS WHILE THE CAR WAS ON THE LIFT. THE DRIVERS SIDE IS SO BAD YOU CAN SEE THE CARPET. THE PASSENGER SIDE IS BAD ENOUGH THAT THEY TOLD ME THE CAR WOULD NOT PASS INSPECTION WITHOUT HAVING BOTH SIDES REPAIRED BY A BODY SHOP. I TOOK THE CAR TO A BODY SHOP TODAY AND THEY WERE SHOCKED AT THE EXCELLENT CONDITION OF THE CAR VS THE ROTTEN FLOOR BOARDS. I'VE BEEN DOING PLENTY OF INTERNET SEARCHES TODAY AND FOUND THAT THIS IS A COMMON PROBLEM. *TR

CHECK ENGINE LIGHT CAME ON ABOUT 2 DAYS PRIOR TO INCIDENT. WENT TO A FRIENDS HOUSE, WHILE SLOWING DOWN FOR A SPEED BUMP CAR COMPLETELY SHUT OFF. AFTER LEAVING HOUSE CAR ACCELERATION WAS VERY HESITATE, TOOK IT TO ADVANCED AUTO TO GET THE CODES READ ON THE CAR AND IT CAME BACK P0345 CAMSHAFT POSITION SENSOR MALFUNCTION AND P0430 CATALYTIC CONVERTER FAILURE AND CYLINDER 3 MISFIRE. SO I CALLED NISSAN BECAUSE I WENT ONLINE READING ABOUT RECALLS ON THE 2006 NISSAN ALTIMA ENGINES BUT THEY TOLD ME THAT MINES WAS NOT ONE OF THEM. CHANGED BOTH CAMSHAFT SENSORS AND CYLINDER 3 COIL. AND CAR STILL ACTING LIKE IT DOESN'T WANT TO START AND STALL. TOOK IT TO MY MECHANIC AND THE WAY IT LOOKS I MIGHT HAVE A HEAD GASKET BLOWN. CRAZY BECAUSE RESEARCHING ON THE INTERNET, I SEE A LOT OF ALTIMA OWNERS ARE HAVING THE SAME PROBLEM. *TR

TL* THE CONTACT OWNS A 2006 NISSAN ALTIMA. THE CONTACT STATED THAT THERE WERE HOLES CAUSED BY EXTREME CORROSION THROUGHOUT THE FRONT DRIVER'S SIDE FLOORBOARD. THE VEHICLE WAS TAKEN TO THE DEALER FOR DIAGNOSIS. THE TECHNICIAN STATED THAT THE FLOORBOARD WOULD HAVE TO BE REPLACED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 75,000. *TR UPDATED 07/10/13*LJ

UPON A ROUTINE OIL CHANGE MY MECHANIC NOTICED THE HUGE AMOUNT OF RUST UNDER MY DRIVER AND PASSENGER FLOORBOARDS. THE CARPET INSIDE CAN BE SEEN. UPON RESEARCHING THIS PROBLEM I FOUND NUMEROUS COMPLAINTS WITH THIS SAME PROBLEM WHERE NISSAN IS DOING NOTHING ABOUT IT. THIS IS A LOW MILEAGE WELL MAINTAINED VEHICLE. IM SHOCKED AT THE AMOUNT OF RUST IN THESE AREAS. NORMAL WEAR AND TEAR WOULD NOT CAUSE THIS. NISSAN SHOULD BE RECALLING THESE CARS. *TR

I HAD THE VEHICLE REVIEWED ON APRIL 23, 2013 WITH YOUR ELHART MICHIGAN NISSAN SERVICE DEPARTMENT. I CAN'T TELL YOU HOW DISAPPOINTED I AM. I WAS TOLD THAT THE REAR BRAKES PINS AND SLIDES HAD NO LUBRICATION IN THEM WHEN MY WIFE PERSONALLY WATCHED THE MECHANIC LUBRICATE THEM WHEN THE MOST RECENT PADS WERE INSTALLED 2 WEEKS AGO. ONE OF THE PINS IS AN AFTERMARKET BECAUSE THE EXISTING ONE WAS FROZEN AT THE SERVICING AND NEEDED TO BE REPLACED. I QUESTIONED THE NISSAN SHOP MANAGER WHO CALLED ME REGARDING THE RECOMMENDATION OF THE OWNERS MANUAL FOR MAINTENANCE OF THIS PARTICULAR AREA OF THE VEHICLE AND HE INDICATED THAT IT IS NOT MENTIONED. I AM NOW IN MY WORDS "STUCK" WITH A SAFETY PART OF MY CAR WHICH I MUST WATCH RELIGIOUSLY AND I CAN EXPECT TO SPEND $1000'S OF DOLLARS IN PARTS AND MAINTENANCE. THIS CAR DID NOT YET HAVE 60,000 MILES ON IT AND HAS ALREADY GONE THROUGH ALL 4 ROTORS 2 SETS OF FRONT PADS AND 4 SETS OF REAR PADS. MY FORD VEHICLE HAS 240,000 MILES AND IS ON ITS 3RD SET OF PADS AND SECOND SET OF FRONT ROTORS. I CANNOT BELIEVE THAT A PRESTIGIOUS BRAND OF NISSAN IS EXPECTING THEIR CUSTOMERS TO SWALLOW THIS. YES, I AM ALSO ONE OF THOSE CUSTOMERS WHERE YOU REPLACED MY ENGINE AT 11,000 MILES BECAUSE OF EXCESSIVE ENGINE OIL USAGE. I KNOW THAT DESIGN AND MANUFACTURING MISTAKES OCCUR, ITS HOW THE MANUFACTURER RESPONDS TO THE MISTAKES THAT DETERMINE THE DIFFERENCE IN OBTAINING CUSTOMER LOYALTY. I WILL BE CONTACTING THE CNN CONSUMER SITE TO REPORT THIS AS THE INTERNET IS FULL OF SIMILAR COMPLAINTS WHERE THE OWNERS ARE BEING TOLD THAT IT IS THEIR FAULT. *TR

DISCOVERED RUST UNDER THE DRIVER'S SIDE, SHEET METAL IS RUSTED OUT. WILL NEED REPLACED. UNACCEPTABLE FOR A GARAGE KEPT AND WELL MAINTAINED VEHICLE THAT IS ONLY 7 YEARS OLD! *TR

FLOOR BOARDS RUSTED THROUGH UNDER DRIVER AND FROM PASSENGER SEATS (FOOT REST AREA) BECAUSE OF POOR METAL COATING AND POOR DRAINAGE DESIGN. REST OF THE CAR IS PERFECTLY FINE. CAR HAS VERY LOW MILEAGE AND NO ACCIDENTS. HAVING HOLE BY THE FLOOR REST AREA IS A SAFETY HAZARD. WHEN RUST STARTED CAR WAS STILL UNDER WARRANTY BUT DEALER REFUSED TO CHECK, NOW FLOOR PANELS MUST BE COMPLETELY REPLACED. READING OTHER SIMILAR COMPLAINS ALL OVER THE WEB AND PERSONALLY KNOWING 3 OTHER ALTIMA OWNERS WITH EXACT SAME ISSUE, I AM VERY SURPRISED THAT NO ACTION TAKE SO FAR. *TR

THE FLOOR PAN ON MY 2006 NISSAN ALTIMA 2.5 SL IS RUSTING AND CORRODED UNDERNEATH THE PASSENGER SEAT AND COULD PRESENT A SAFETY ISSUE. I CONTACTED MY LOCAL NISSAN DEALERSHIP AND THEY WERE UNABLE TO ASSIST ME BECAUSE THE CAR IS OUT OF FACTORY WARRANTY. I FIND IT HARD TO BELIEVE THAT A CAR 6+ YEARS OLD WOULD BE RUSTING THAT BAD ESPECIALLY GIVEN THAT THE CAR HAS BEEN KEPT IN MY GARAGE AND WELL MAINTAINED. I HAVE SEARCHED ON THE INTERNET AND FOUND NUMEROUS 2002-2006 NISSAN ALTIMA OWNERS THAT HAVE THE SAME ISSUE. I BELIEVE THIS IS A DEFECT AND NISSAN SHOULD ISSUE A RECALL AND REPAIR THESE VEHICLES. *TR

'SERVICE ENGINE SOON' LITE CAME ON. DEALER SCANNED FOR TROUBLE CODES P0725,P0335. WAS TOLD THE "CRANKSHAFT POSITION SENSOR" NEEDS REPLACING, AND WAS CHARGED $130. THE DEALER WANTS TO CHARGE ME $425 TO REPLACE 'CPS'. WAS TOLD THAT THERE WAS NO RECALL FOR THIS SITUATION. FOUND OUT LATER THRU THE INTERNET THAT THERE WERE 600 INCIDENTS CONCERNING 'CPS'. THE DEALER SHOULD FIX THIS WITH NO CHARGE. NHTSA #07V527000 RECALL EXPLAINS THE PROBLEM. ALSO SEE RECALL ID #67654 FROM NISSAN. *TR