2006 NISSAN MURANO Complaints

The rear K frame member is rotted out causing the wheels to tilt in and seems like it’s ready to come off. I was told it was because there’s two holes in the front of the member causing water to get in and sit inside and rust out the frame.

Rusted/Rotted rear k frame. Vehicles rear end is collapsing. Wheels are coming off.

The contact owns a 2006 Nissan Murano. The contact stated while driving 65 MPH, he noticed that the vehicle was drifting. The contact was able to pull over to the side of the roadway. The contact then drove to an independent mechanic where the vehicle was diagnosed with a rusted rear wheel subframe that needed to be replaced. The vehicle was not repaired. The VIN was not available. The manufacturer was notified of the failure. The failure mileage was approximately 205,000.

this is the second transmission i have put in this.. these cvt's are complete garbage and nissan is aware of it. Stand behind your product for once and replace this transmission on your dime. Will drive perfect sometimes and then randomly 3k-5k rpms and wont shift. sometimes i can shut it off and restart it and it will work fine again. sometimes it wont and i have to drive around with excessively high rpms. Also what is this annoying air suction noise i hear under throttle, sounds like an intake or blow off valve. there are zero vaccum leaks,

Normal driving and the seat broke and has been for several years causing instability and oscillation. Recently my steering wheel will not align, brought it to a mechanic that informed me the rear sub-frame is cracked on both sides causing the tires to malign, creating un-even wear on the back tires and a hazard to drive.

Rear suspension making "banging" noise when turning. Mechanic states rear suspension cradle badly corroded resulting in passenger side sway bar being disconnected. Sway bar connection pulled away from frame leaving gap in frame. Mechanic states unrepairable due to extensive frame corrosion.

The contact owns a 2006 Nissan Murano. The contact stated while driving approximately 30 MPH, the vehicle inadvertently stalled. The contact stated no warning light was illuminated. The vehicle was towed to the contact’s residence. The manufacturer was informed of the failure and told the contact that the VIN was not under recall. The failure mileage was approximately 183,000.

Rear subframe is completely rusted out making the vehicle unsafe to drive. Extremely dangerous.

Rear Subframe split in half, without any warning. The tires inside edges were worn to the point of failing and the frame is detached from the body, creating potential crash and death.

My car horn recently stopped working when depressing the areas on the steering column with the horn icon. I almost got into multiple accidents, first when driving on the interstate and could not honk on aggressive drivers who sharply pulled in front of me when driving; and later when trying to park in a parking lot and another driver reversed into me because he could not see me and I could not honk to signal him that I was in his blindspot. I checked with my mechanic of 23 years and he found that there was no issue with the fuse or the horn itself - the horn activates when manually triggered. However, there is a problem with the relay from the steering column to the horn and with this Nissan model, that relay is integrated with the air bag in the steering column. It's possible that there's also an issue with the airbag but it's never had reason to deploy. Lodging this incident because the horn is a central part of any car safety system and there seems to be a manufacturer defect in the relay that is integrated into the steering column to trigger the horn.