2016 RAM 1500 Complaints

Transmission won't shift out of second gear,and a code showed up U0402 in order for it to shift gear you have to disconnected the battery cable wait a few minutes then connect the battery back this will reset the computer then it will shift gear, while driving at 45 the truck suddenly stop making it feel like the transmission was about to fall out Now the EPS system while driving the steering wheel lock up, when I took it to dealership it sat in the shop about 45 minutes to and hour and they said ok you ready to go don't give me a copy of what was supposed to be done

The contact owns a 2016 Ram 1500. The contact stated that while driving 25 MPH, the message "Check Brakes" was displayed, and the ABS and traction control warning lights illuminated. The vehicle was taken to the dealer, where it was diagnosed, and the dealer determined that the ABS module needed to be replaced; however, the part had not been available for eight months. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 70,000.

Antilock brake system module failure. The system controls the anti-locking brake system as well as vehicle stability control, both federally mandated for this year vehicle. The ABS, stability control, and brake lights are illuminated on the dash. The message “service antilock brake system” is displayed on the message center as well as “service electronic braking system” The part is not available for inspection at this time as it is still on the vehicle and cannot be removed without causing complete failure of the braking system. The vehicle is still being driven as there is no other option at this time. Failure of the system puts anyone operating the vehicle in danger due to the ABS & Stability systems being inoperable. Failure confirmed by independent auto repair technician. ABS system reset and re-initialize without resolution of the issue. The part has not been inspected by the dealership who did not wish to inspect it as it was known issue. No accidents involved with my vehicle due to this as yet. The system failed in November 2023. I contacting the Ram dealer to replace the part and I was informed there were no modules available because it was on “Engineering Hold”. This was explained that the part had to be redesigned due to a continuous failure/problem. I was told it would be available in March 2024. Re-contacted the dealership in March 2024 and was advised it would not be until after June or July. The Part became available sometime after August 2024. However, due to the backlog of vehicles the dealership had to repair, none were available clear into 2025. As I understand, this is a widespread problem that has affected 10’s to 100’s of thousands of vehicles. Part numbers 68295368AA & 68295368AB with the redesigned part being 68295368AC. I also understand that this part has failed on the Durango, Charger, and Challenger vehicles as well.

Dealer wants $7259.20 to repair 2 air bags Is this a recall item? Truck start leaning to one side and is lope sided. We noticed that there are recalls on other 2016 Rams 1500 trucks and now we are having this problem. We would appreciate your help. [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I was involved in a crash that resulted in a fatality on [XXX]. My truck was towed to Five Star Collision Center in Hurst, TX. The repairs were made to the body of my truck. I picked up the truck and ABS warning lights came on. I called Fove Star Collision Center and spoke to my point of contact- Nathan Hultquist. Nathan advised that I should drive the truck back immediately. I took the truck my to Nathan. He advised that I should drive the truck to the closest Dodge dealership. I did so. My ABS Module is out on my 2016 Ram.The warning lamps came on- service brake system, service trailer brake, ABS light stayed illuminated. This appeared 150 days ago. It has been at Grapevine Dodge for over 150 days. It is in limp mode and has been declared unsafe to drive. I have been in communication with Stellantis/MOPAR for the 150 days. There is no resolution. They claim there is no material to manufacture the part? It appears to be made of plastic? I feel that this is a safety concern due to the fact that if the brakes are applied in an emergency situation, the ABS fails and the brakes lock up. The truck can go into limp mode which is at 35 MPH. On a state highway, moving at that speed- that is NOT safe. There are plenty of these trucks out on the road that could have this same problem and cause serious accidents including a death. I ask for your assistance in this matter. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I was driving my 2016 ram 1500 on the highway when my steering gave out due to a faulty electronic power steering rack. I lost control of the vehicle and it almost ended in an accident. I had my family in my vehicle. This is completely unacceptable. I talked to Chrysler about this issue and they said it does not fall under the recall. Although I believe it should due to the rack going bad because of water getting in due to a faulty seal.

ABS Control Module is throwing a code. I have spoke with my mechanic and countless others along with representatives of Mopar/Chrysler and this ABS Control Module has been on back order know for 2 years that I know of. From research I have done the part has been on back order longer than that. In my research I have also found that Mopar/Chrysler does not seem to be manufacturing this part anymore. This issue is effecting 100s if not 1000s of people who have spent a lot of money on these pickups and Mopar/Chrysler could seem to care less about it. 2 years of being on back order is absolutely ridicuous.

This vehicle has a faulty ABS module that Ram doesn't make the part for. The part 68292756AA been shown on backorder for over 1yr. After chatting with a Ram customer service agent I found out this part has been discontinued and was advised that I try an aftermarket part. Guess what ? The aftermarket part is not compatible with the program download. ??This is unacceptable. There seems there is forums after forums with people in the same predicament. This issue really needs to be investigated .

ABS Module is failing preventing other systems to work properly (cruise control). This part has been on order since February. The service technician said there are people who have been waiting on this part for over a year and a half. Looking on line this is a problem of enormous proportions on multiple model years. If this part is not available to make this repair, it leaves us with a dangerous braking problem which can effect multiple other functions of our vehicles. If Stellantis knows this part is such a needed safety module, what can be done so owners can have their vehicles repaired?

2016 RAM Ecodiesel in shop with crankshaft position sensor error. Vehicle available for inspection at Sarasota RAM. Vehicle shut down on highway. Restarted but only would operate in limp mode which enabled me to drive to dealer. Warning lights indicated crankshaft position sensor issue. I had W58 recall performed but not selected for W68 fix. I spoke to Phil (844-378-0573 Ext: 4060587) at RAM customer care, who stated "Our primary focus is your satisfaction" (customer care case #[XXX]). This problem is very evident by the many 1500 drivers complaints. Action to reimburse me for the repairs is required. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)