2013 RAM 1500 Complaints

The vehicles power steering randomly stopped working. I checked the fuse box 10amp and 125amp battery connection and no power issues with it. There is power to the rest of the vehicle.

On 08/29/2026 while traveling on the interstate the electronic power steering light activated on the cluster of the 2013 ram 1500 truck. After hearing the warning and seeing the warning, there was no power steering on the vehicle as I was traveling at 70 mph down the interstate. The wheel was difficult to turn and the vehicle was hard to maintain control while driving. This presented a safety issue for myself and other motorist traveling on the same interstate as myself. The only warning I received was the warning when the power steering completely failed and was inoperable. no other symptom or warning was triggered. I have a scheduled appointment for the dealer to check the vehicle on Friday Sept 4, 2026 at 0800. I am a sworn sheriff's deputy and the vehicle displays a red steering wheel with a red exclamation mark beside it on the dash with a warning that reads "service power steering" power steering will begin to work again after shutdown of the truck and fail after a few minutes of driving and stays out.

I had gone into my local Walmart after work and turned the truck off. After I came back out and turned the truck on, my power steering had gone out completely.

A ton of 2013 ram 1500’s are having ABS module problems or needing repairs. Very unsafe to travel without it working properly. Unable to get a new part because Mopar discontinued making them. For what reason? I think this is the exact reason. Something needs to be done about it. To many reports of ABS modules being broken or not working/ functioning properly. Mine is broke and can not find a replacement.

The contact owns a 2013 Ram 1500. The contact stated that while driving approximately 15-20 MPH and attempting to make a left turn, the steering wheel became difficult to turn, and the contact stopped the vehicle and activated the hazard lights. Another driver assisted the contact in moving the vehicle to the side of the road. The vehicle was towed to the dealer, where it was diagnosed and determined that the electric power steering rack and pinion had failed and needed to be replaced. The vehicle was not repaired due to the cost. The contact associated the failure with NHTSA Action Number: RQ23003 (Steering). The manufacturer was not notified of the failure. The failure mileage was approximately 140,000.

The anti-lock braking system (ABS) and electronic stability/traction control system on my 2013 Ram 1500 have malfunctioned. The Serious incident occurred when another vehicle pulled out in front of me and I had to brake hard. Dash immediately displayed the ABS and brake warning lights, The normal hydraulic brakes operated, but ABS did not activate. The wheels locked and the vehicle skidded sideways during the emergency stop, significantly reducing directional control and creating a significant risk of collision and rollover. Diagnostic scanning identified DTC C2200-49, indicating an internal electronic failure of the ABS control module. The problem has progressively worsened. The warnings now occur at normal temperatures and may appear immediately after ignition. The vehicle also displays “Service Integrated Electronic Brake System,” and traction control becomes unavailable. On another occasion, while accelerating on a dry road at approximately 70°F ambient temperature, I heard a click and felt a slight jerk immediately before the ABS/brake warning lights illuminated. The ABS control module is available for inspection upon request. The identified ABS control module is Mopar part number 68196035AA. I have found that obtaining a new replacement module may be difficult because the original part appears to be discontinued/unavailable through normal OEM sources. The failure has progressed from intermittent to persistent and has resulted in the actual loss of ABS, traction control, and electronic stability functions. The vehicle retains conventional braking, but the emergency braking incident demonstrated that wheel lock and loss of directional stability can occur when ABS is unavailable. The vehicle/component has not yet been inspected by the manufacturer, police, or insurance representatives. The diagnostic code and warning behavior have been reproduced repeatily.

I am receiving code C2200, and the ABS, brake, lights on confirmed by my local Jeep, Dodge, Ram dealership. The dealership wants to sell me aftermarket ABS module telling me it's a 50/50 chance of it working with electronic flush. All other ABS modules are on backorder with the current safety recall for 2019, 2021-2024 Ram 1500's.

see it’s a known things with rams that the electronic power steering goes out randomly because of how dodge made it and the dealerships don’t do recalls for it and it’s absolutely absurd to spend 2-4k$ for a fix

In December 2025, my check engine light came on. Diagnostic codes read P0128 (coolant thermostat) and U1467 (module communication). I took the vehicle to a mechanic, who diagnosed and repaired the issue. Shortly after, the check engine light returned, so the same mechanic replaced the ECM (plug and play). This repair did not resolve the check engine light. The mechanic recommended I take the vehicle to a dealership and identified a related service bulletin tied to Safety Recall N25 / NHTSA Campaign 13V-177 (three-way coolant valve). To confirm this diagnosis, I sought a second opinion from another independent mechanic. That shop purchased the coolant valve part directly from a dealership, installed it on my truck, and the same issue persisted. They also were unable to resolve it and advised me to take the vehicle to a dealership. I researched NHTSA Campaign 13V-177 (Chrysler Manufacturer Campaign N25) and confirmed that Chrysler recalled certain 2013 RAM 1500 trucks built between June 25, 2012 and December 12, 2012, because the coolant bypass valve may stick in a position that prevents coolant flow to the heater core. The official remedy for this recall is replacement of the coolant valve along with an updated module calibration, performed by a dealer. I was told by dealership staff that there is no active recall on my vehicle. However, my truck matches the affected description, and I have not had the calibration portion of the recall remedy performed, only the physical part replacement, which two independent mechanics have already completed without resolving the underlying issue. My vehicle is currently at Landmark Dodge in Morrow, GA. Despite this being an open federal safety recall (13V-177/N25) with a remedy that includes a required software calibration update, the dealership is attempting to charge me for this repair, even though I have already paid to have the physical part replaced twice by independent mechanics.

Power steering has failed. The vehicle is available for inspection. The steering without power assist is worthless. There is no way to avoid any kind of emergency incident. An independent repair shop has verified that the steering doesn't work. No one else has inspected the vehicle. In the dashboard information panel there is a flashing red warning light that was on when the vehicle was started. The symbol is a steering wheel and an exclamation mark. This first appeared on July 10, 2026.