2025 RAM 3500 Complaints

When I was going to torn off the truck won’t stop the engine, dash said not in parking and the PRND light start flashing I had to remove a relay to shut down the truck and disconnect bought batteries half and hour later reconnect everything and truck work but with many lights on in dash board From what I investigated it’s a common problem with no solution at this time Dealer said it’s a rear speed sensor What should I do

The contact owns a 2025 Ram 3500. The contact received notification of NHTSA Campaign Number: 26V059000 (EXTERIOR LIGHTING, ELECTRICAL SYSTEM). The contact noticed the failure on the drive back after the vehicle was purchased. The contact stated that on a separate occasion, while driving at an undisclosed speed, the brake lights and turn signals failed to function as intended. The contact lived in a rural area and stated that at night it is dark, and the brake lights nor the turn signals were operable. The contact felt that the vehicle was unsafe to drive. The local dealer was contacted, and the contact was informed that the parts for the recall repair were available. However, the parts were allocated to unsold vehicles first, and there was no estimated time for the recall part to be available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed with the dealer about the part not being available. The contact was informed that the recall part was blocked from manual ordering. The failure mileage was approximately 500.

There is a recall for the trailer brake control and trailer wiring for light. I bought the truck to tow my 5th wheel trailer and have travel plans starting in march of this year.. ram has put a stop sale on 450k trucks because of this recall. The dealers are fixing the unsold trucks on the lot before they fix customer vehicles that have already been purchased. All the dealerships in Arizona are telling me it could be 3-6 months before my truck is fixed.. so I can’t safely tow a trailer or go on my trips. So basically I have a 1 ton truck that is useless to tow a trailer

Contacted local Dodge dealer for repair of the below known part issue. They stated they are only receiving 1 unit/week to be able to replace and the repair could be weeks out. I use my truck for towing frequently and am not comfortable doing so with the upcoming recall known. Manufacturer Recall Number03D NHTSA Recall Number26V-059 Recall StatusRecall Incomplete

While driving down the street between 0 and 35 mph, with no load in the truck and no trailer attached, the trailer brake controller quite working completely and a service message appeared. The dealership ended up replacing the trailer brake gain adjustment switch. Had I been towing a trailer at the time, I would have had zero trailer brakes. I've had this message reappear several times since then. I've attached a picture showing both the message on the gauge cluster as well as a scan of the trouble codes at that time.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

Multiple times at random the vehicle will display an alert on the dash that the 4X4 system, anti lock breaks, adaptive breaking as well as forward and rear collision sensors and cruise control are all disabled. This has happened 5 times now. I have taken the vehicle into the dealership and they stated that the rear Wheel Speed Sensors" were bad and replaced them. Since the wheel sensors have been replaced ( less than 200 miles ago) this system has triggered the same alert and conditions 2 more times. This is a very dangerous situation for a vehicle that is made for towing heavy trailers and loads.