2017 RAM 3500 Complaints

The truck has had the HCU not working for at least two years, with no success at repair due to part unavailable. Truck has low miles due to the brakes being a safety concern. Reached out to RAM customer care several times with the response being parts unavailable. January of 2025 a case number was issued !00Dj001qsDF.!5007y0tkhWy. We had been notified of the recall Jan 2025 and told parts would be available April 2025. Contacted 3 RAM service departments, and no parts are available.

Recently I was informed about a possible engine failure involving a "Grid Heater Bolt". Upon my query, I learned the following: The RAM grid heater bolt failure can lead to serious engine damage. Here are some key points: 1. The grid heater nut can melt and fall off inside the intake plenum, often due to the grid heater relay sticking "on". Or fall off due to vibration. 2. A bolt in the 2007-2023 RAM 6.7L intake air heater can cause severe engine damage, and a warning code (P2609) may indicate this issue. 3. The grid heater bolt/nut can wear from heat or vibration, potentially dropping into the cylinder and destroying the engine. The risk related to this can be minor to catastrophic. Any potential engine failure during operation could cause damage, fire, injury or death. Upon researching this issue, I found the Internet full of warnings, but yet since 2007 to 2023 no factory solution or recall has been made. A recall has been made for simuliar issue. See attached. As a preventive measure, I am replacing mine with a aftermarket device. Something Ram or Cummins engine should have done since 2007. I have not been in a collision or a engine failure. But I am sure since 2007, someone has. There are two or three aftermarket repairs that the manufacturer should have resolved.

The contact owns a 2017 RAM 3500. The contact received notification of NHTSA Campaign Number: 24V896000(Service Brake, Hydraulic); however the part to do the repair was not yet available. The contact stated that while driving 60 MPH, the message "Service Electronic Brake system" was displayed, and the ABS and traction control warning lights were illuminated. The contact stated that upon driving over a bumpy road surface, the brake pedal was depressed but stuttered, and the vehicle failed to respond as intended. The contact stated that while an independent mechanic was in the process of replacing the front driver's side brakes at the residence, the mechanic noticed that the front driver's side brake was grinded. The brake calipers were replaced and the brake line was bled, but the failure persisted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the failure. The failure milage was approximately 165,000. VIN tool confirms parts not available

The contact owns a 2017 Ram 3500. The contact received notification of NHTSA Campaign Number: 24V896000 (Service Brakes, Hydraulic); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

While test driving a 2017 RAM 3500 6.7L Cummins diesel at Cherry Hill Dodge Chrysler Jeep Ram in Cherry Hill, New Jersey, both the check engine light and the regen warning light came on simultaneously. I returned to the dealership, looked up the regen warning, then retrieved my BlueDriver OBD2 scanner from my own vehicle. I scanned the truck on-site and ran live data. The scan confirmed the diesel particulate filter (DPF) was 100% full, and the regeneration system was not functioning. Permanent fault code P242F was stored, and the exhaust backpressure reading was over 25 PSI at idle — indicating a severely blocked system. These faults were not disclosed by the dealership, and no inspection or documentation from a diesel technician was available. I later discovered the truck also has an open safety recall (Manufacturer Recall Number: C4B / NHTSA Recall Number: 24V-896) for a potential failure of the Brake Hydraulic Control Unit (HCU). This recall involves the loss of ABS, Electronic Stability Control, and Traction Control, and the recall status is listed as incomplete with no remedy available as of the test date. I offered to purchase the truck for $35,000 out-the-door on the condition that the emissions system was repaired and certified. The salesperson spoke with the manager, then returned and told me the vehicle was no longer for sale. I then overheard the manager say they planned to wholesale the vehicle, likely without disclosing these active safety and emissions system failures. I am filing this report to ensure the vehicle is flagged for unresolved safety and emissions violations before it is sold or auctioned in its current condition. I have full diagnostic scan data, photographs, and written communication from the visit available upon request.

I am filing this complaint regarding an unresolved safety recall for the Hydraulic Control Unit (HCU) on my 2017 Dodge Ram 3500, VIN ending in [XXX] , under Recall Number C4B/NHTSA 24V-896. We received the recall notification months ago and have been waiting ever since for further instructions or a remedy from FCA US LLC. After more than six months, we still have no resolution. Recently, the vehicle was towed to Patterson Dodge in Tyler, TX, where it was inspected by the dealership. They confirmed that there is currently no remedy available for the HCU issue and stated they have no idea when a fix will be provided. This is not just a matter of inconvenience — this is a critical safety concern. FCA's own recall notice clearly states: “The loss of ABS/ESC/Traction control may cause a vehicle crash without prior warning.” We purchased this truck specifically to tow our 5th wheel camper, which we now cannot safely operate due to the safety risk posed by this unresolved recall. Without proper braking and stability control systems, towing a heavy load would be incredibly dangerous, not only to us but to everyone else on the road. We understand that vehicle recalls can take time to resolve. However, it is extremely concerning that: FCA has offered no timeline or remedy after many months. The vehicle remains inoperable for its intended purpose due to the unresolved recall. We were never proactively contacted with updates and had to follow up on our own. The dealership confirmed the part is not only unavailable but with no estimated time of arrival. We respectfully request that NHTSA investigate whether FCA is meeting its obligations under the National Traffic and Motor Vehicle Safety Act to provide a timely and effective recall remedy. A known safety defect has been identified, but the remedy is indefinitely delayed, and the manufacturer is not offering alternative solutions (loaner vehicle, buyback, etc.) while we are left with a vehicle we cannot safely use. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF IN

Unknown. Not for certain. Dash message says “see dealer. Electronic brake control unit malfunction” - to that effect. HCU/ABS recall needs addressing. No parts available currently.

The contact owns a 2017 Ram 3500. The contact received notification of NHTSA Campaign Number: 24V896000 (SERVICE BRAKES, HYDRAULIC); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated while operating the vehicle, the message "ABS Failure" was displayed with an audible alarm activated. The vehicle was taken to the local dealer who replaced the ABS module; however, the failure reoccurred. The contact stated that the ABS module was replaced three times. The failure mileage was 44,000. VIN tool confirms parts not available.

The contact owns a 2017 Ram 3500. The contact received notification of NHTSA Campaign Number: 24V896000 (Service Brakes, Hydraulic); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the automatic braking system warning light illuminated approximately 3 times within 60 miles. The contact stated that the failure occurred while driving at various speeds, causing the cruise control to deactivate. The dealer was contacted. The manufacturer was not made aware of the issue. The failure mileage was approximately 120,000. VIN tool confirms parts not available.

The contact owns a 2017 Ram 3500. The contact received notification of NHTSA Campaign Number: 24V896000 (Service Brakes, Hydraulic); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.