2014 RAM 3500 Complaints
View complaints related to 2014 RAM 3500. The complaints found here are submitted by actual consumers with first hand experience. There are more than 200 complaints submitted for the 2014 RAM 3500. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.
-
2014 RAM 3500- Dundee, NY
The contact owns a 2014 Ram 3500. The contact stated that while the contact's husband was driving at an undisclosed speed, the driver's side rear outer tire detached. The vehicle was driven to the shoulder of the road. The contact's husband inspected the vehicle and noticed that only one stud was attached to the wheel, and the wheel was tilted sideways. The vehicle was towed to an independent mechanic, where it was repaired; however, the failure reoccurred. The vehicle was towed to the independent mechanic, who informed the contact that the driver's and passenger's side rear outer tire studs had detached. The vehicle was repaired; however, the failure persisted. The vehicle was towed to an independent mechanic, where the contact was informed that the passenger's side rear outer tire studs had detached again. The vehicle was repaired; however, the contact stated that the rear axle, rims, and rear tire hubs were also damaged. The vehicle was driven to the residence. The contact stated that the failures occurred while hauling horses. The contact referenced an unknown recall with a similar failure description, stating that the vehicle was taken to the dealer three years ago for the recall repair, but the vehicle was only inspected and no repairs were completed. The manufacturer was made aware of the failure, and a case was filed. The contact was advised to take the vehicle to the dealer for inspection. The failure mileage was approximately 120,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2014 RAM 3500- Colorado Springs, CO
Norcold N641.3FL refrigerator (serial #XXX) installed in an Arctic Fox truck camper caught fire on June 2, 2026 due to cooling unit failure. This model is subject to a known Norcold fire risk recall. The unit had not been repaired under the recall. I extinguished the fire myself. I have photographic evidence and have reported the incident to Thetford/Norcold at [XXX] . Norcold LLC filed for Chapter 11 bankruptcy in November 2025 with over 10,500 similar fire-related claims. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Source: NHTSA WEB SITE -
2014 RAM 3500- White Plains, NY
the recall number is 14V-635 or P65\n\nsays electric defect causes fires from heater Year: 2014\nMake: RAM\nModel: 3500\nTrim: N/A\nSeries: N/A
Source: NHTSA WEB SITE -
2014 RAM 3500- Enterprise, AL
We were traveling on a highway doing 70mph and the whole truck started to shake really badly. My husband could not steer the vehicle safely, nor could he brake without losing control. He had to slow down until the shaking stopped. When we got back on the road, the vehicle did the same thing three times. This is known issue with Dodge, yet they don't have a fix for it. They call it the "death rattle"
Source: NHTSA WEB SITE -
2014 RAM 3500- Belleview, FL
ABS is not working and no part is available. Towing an RV without trailer brakes is dangerous. The ABS malfunctions at random and we never know when this will happen. ABS control deactivates traction control, as well as trailer breaks, and effects transmission functions as well.
Source: NHTSA WEB SITE -
-
2014 RAM 3500- Arnold, NE
The heater core in this model with the Cummins motor and of those around the same year plug constantly. I have to flush mine every couple of weeks in cold weather otherwise it will not keep moister off of the inside windows including the windshield as it just blows frigid air. A complete repair is $2,400+ and it will continue to plug even after the repair. It's common to need to frequently pull off of the highway and wipe down the inside glass to keep the windows clear.
Source: NHTSA WEB SITE -
2014 RAM 3500- Arlington, TX
The contact owns a 2014 Ram 3500. The contact stated that while driving 50 MPH, the Electronic Stability Control (ESC) and brake assist warning lights were illuminated. The vehicle was taken to the dealer, where it was diagnosed that the ABS module had failed and needed to be replaced; however, the part was not available. The dealer informed the contact that the ABS module was under engineering review and there was no estimated availability date for availability. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 63,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2014 RAM 3500- Dover, PA
The contact owns a 2014 Ram 3500. The contact stated while driving 65 MPH, the "no turbo signal" warning light illuminated, and the vehicle shifted into LIMP Mode. The contact stated that the vehicle slowed to approximately 20 MPH on the highway. The contact pulled over and turned the vehicle off and detached the positive and negative battery terminals. The contact stated that he touched the ends of the cables and reconnected the terminals to the battery and was able to return to normal vehicle functionality. The contact stated that the failure was intermittent but occurred at various speeds. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that the turbo actuators needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 116,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2014 RAM 3500- High Springs, FL
The contact owns a 2014 Ram 3500. The contact stated that while operating the vehicle at highway speeds, the steering wheel felt loose, and the steering was unstable, causing the vehicle to become difficult to control. The vehicle was taken to the local dealer who diagnosed that the outboard steering linkage jam nut had become loosened. The vehicle was not yet repaired. The manufacturer was notified of the failure. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 19V021000 (Steering). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 139,000.
Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE -
2014 RAM 3500- Chesapeake Beach, MD
The V06 Drag Link recall of welding the adjuster doesn't allow a complete front end alignment to be done correctly. If you have had the adjuster welded, you cannot re-center the steering wheel with the adjustments that have been provided by the manufacture. This itself presents a safety issue with the steering wheel now being off centered! I have not had the welding done and have been trying to get the drag link replaced since it has become loose again! Independent repair shops won't touch a RAM truck that has been welded or not do to liability. The replacement parts are now in stock and they should be replaced since the way that RAM says to now do an alignment only allow toe and camber but not re-centering of your steering wheel. I have confirmed that with RAM service. Ram Cares has not helped in this matter. Have a previous Request #1273536 with NHTSA. This is a major safety issue for myself and others on the road. Thank you for your time.
Source: NHTSA WEB SITE