2012 TOYOTA PRIUS Complaints

While driving 60 mph in highway, ABS, traction control and brake lights lit up and vehicle lost its effective braking power. There were no prior warnings prior to this failure. It was a sudden incident. Since it wasn't rush hour, I could safely reduce speed and bring the car to stop. Situation could have been much different if it was normal hours. After taking the car to dealership, it indicated DTC code 1391, Brake Assembly Failure. The car was fixed at dealership at cost of $3,000. When researched further, it appeared that there is broader pattern of failures. Numerous reports have been made by owners of 2010–2015 Toyota Prius, Prius PHV, 2012–2015 Prius V, 2012–2014 Camry Hybrid, and 2013–2015 Avalon Hybrid vehicles, all of which share the same brake booster pump assembly design manufactured by Advics Co., Ltd. Dealerships, including Capistrano Toyota and Claremont Toyota in California, have previously petitioned NHTSA regarding this very defect. Their 2019 letter to the agency documented that Toyota: * Knowingly excluded hundreds of thousands of hybrids from prior safety recalls (DOH 13V-235 and KOL 19V-544) despite identical failures. *Issued “post-failure” repair programs (Warranty Enhancements ZJB, ZKK, ZKC, ZLM, 20LE03, 23TE06 and 23TE07) only after owners experienced brake failure. * Identified the same DTC codes (C1252, C1253, C1256, C1391, U0293) in both recalled and unrecalled vehicles—codes that correspond to accumulator leaks, loss of brake pressure, and failure of brake assist and stability control systems. * Admitted through Technical Service Bulletin TSB-0130-19 that these defects caused loss of hydraulic pressure, increased stopping distance, and total loss of brake assist in affected hybrids. In short, the defect pattern across multiple hybrid models is identical to those already recognized by Toyota and NHTSA under prior recall campaigns, but for reasons unexplained, Toyota limited the recall population and left many consumers unprotected

After 13 years and 112,000 the brake booster and brake booster pump went out on my car. Toyota extended the warranty to 10 years because of this issue. Now just outside of the 10 yr mark my car has this issue and Toyota will not cover it. This is a huge expense and also a major issue with this year and model of car.

2012 Toyota Prius. The brake system malfunctioned and my daughter was almost in a wreck. The ABS, traction control, and brake warning lights on the bashboard all illuminated at the same time. The brake pedal feels soft and is less responsive requiring more effort to stop the vehicle. The brake actuator assembly is making a hissing noise. Ran a ABS test using a scan tool and received a C1391 error code. The Code points to a leak within the brake actuator system. Upon research I have found that this is a very common and costly repair that Toyota has known about for many years. Toyota issued a customer support program related to this issue that ran for 10 years or 150,000 miles from the vehicle's date of first use. This car, being a 2012, is beyond the support program. I contacted Toyota, hoping they would do the right thing and cover the repair. I was told that they would not cover the repair or supply the parts to cover the repair. I told the Rep. for Toyota that I did not feel like it was fair for Toyota to continue to put millions of drivers at risk for a product that they clearly realize for years now is defective and could hurt or kill someone. The code and the braking issue did not appear until after the customer support program ended and therefore we had no warning or way to anticipate this braking issue or the danger to my daughter and anyone else riding with her in the car or on the roadway near her travel routes. I traveled 300 miles, rented a Uhaul car tow trailer and brought the car back home. My mechanic confirmed the code C1391 and the fact that the brake actuator has failed. The mechanic has ordered the parts (the same defective parts) to replace the broken ones. Toyota is still selling the same part as a replacement part clearly knowing that it is not safe and no warning came with the replacement part explaining the potential for a braking issue. Based on internet research this same part is in many 2005 to 2013 Toyota and Lexus

I have a Prius v 2012, and the lights for abs turned on and when I checked on internet Toyota was repairing the part for 150k miles and 10 years but this is a safety feature my car is now at 149922, And while I was on road suddenly the signs came up and I the brakes were hard, and this is a problem for my safety and for others too since It doesn’t brake well

I own a 2012 Toyota Prius C with approximately 156,578 miles. The vehicle has been diagnosed with C1391 – Abnormal Leak in Accumulator, which causes the brake actuator to lose hydraulic pressure. This results in frequent buzzing from the actuator pump, illuminated warning lights (BRAKE, ABS, Traction Control), and loss of ABS and stability control. The condition increases stopping distance and creates a serious safety hazard. Toyota previously acknowledged this exact defect under Customer Support Program CSP 21TE01, which covered brake booster and pump assemblies for certain Prius and Prius C models when codes such as C1391 were present. However, the program expired on November 30, 2022, and my vehicle is just over the 150,000-mile coverage limit. Despite this, my Prius exhibits the same defect that Toyota has already recognized as a safety-related issue. Toyota Carlsbad confirmed the diagnosis and quoted $3,399.55 plus tax for repair, with a reduced courtesy estimate of $2,817.86 plus tax, but declined goodwill assistance since CSP 21TE01 expired. Given the widespread reports of brake actuator failures in Prius models, I believe this represents a systemic safety issue that warrants NHTSA investigation and potential recall/extended coverage.

While pulling out of a parallel parking spot going slightly uphill, I braked as I looked around the back of a double parked truck. I saw a car coming, braked hard, and suddenly my car surged forward across the street and hit a parked car. I looked down and saw that my foot was squarely on the brake pedal pressing down as hard as I could. The parked car was unoccupied, and I was uninjured. There were no warning lamps, messages, or other symptoms of the problem. I turned my car into the dealer for repairs and a fix to the sudden unexpected acceleration. They could offer no fix until a Toyota representative examined the car. On August 14, by an emailed letter, Toyota claimed it found no defects and it must be the result of driver error, specifically, my mistakenly hitting the accelerator. This is gaslighting denialism. (a) The EDR data sent to me does not indicate that I hit the accelerator unless that data is in the page of hexadecimal numbers. (b) Toyota's claim that I hit the breaks at "-0.2 seconds prior to the collision" is physically impossible. No one can move their foot from the accelerator to the brake that fast. (c) Toyota's claim is contrary to what I experienced and observed.

The contact owns a 2012 Toyota Prius. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The contact stated that the check engine and the hybrid warning lights were illuminated, and the vehicle decelerated. The contact received notification of NHTSA Campaign Number: 18V684000 (Hybrid Propulsion System). The vehicle was taken to the dealer; however, the contact was informed that parts were not yet available for the recall repair. The contact was informed that the parts might be available within a week. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 137,000.

Brake getting stuck on the floor would have to press on brake really hard just to get a response, this will happen out of the blue! Driving in highway or just driving off the driveway. I almost hit a car in front of me due to lack of brake, i had to swerve to the side! First appear 1 day after buying the car..This issue needs to be worked on right away.

While driving on the freeway I applied the brakes and the brakes suddenly felt soft and not very responsive. At that moment 3 dashboard lights turned on: ABS, BRAKE, and the slip indicator lights. I carefully got out of the freeway, parked the car, and had the car towed to an independent mechanic. The mechanic detected brake booster and actuator problems, code C1391.

Brake Actuator and ABS Accumalator failed. It is a common failure reported by multiple owners on these cars. I was on the high way going 70 when it failed and lost any brake boost I had putting me in a very dangerous situation where I narrowly avoided an accident. Upon scanning the car's codes I got code C1391 which I looked up and saw a bunch of other people who were also struggling with this issue.