2011 TOYOTA TUNDRA Complaints

My power steering is leaking fluid, I didn't have anymore and had a loss of steering power while driving. So far I have just added more fluid, but haven't driven it since.

On 11/25/22 I meet with American Auto Mall to buy a used truck I was assured through text, website and window sticker that the truck was in excellent condition inside and out.. I have all this documents proofing this.. I did van limited inspection at the lot and a test drive.. found nothing that stuck out.. other than the radio not working but the dealership said he would reimburse me if I got it fixed..so after that a down payment was made of $5550 dollars and paperwork was signed.. I drove the truck home and the next week I got in it and it wouldn't start, turns out it needed a battery and alternator, so I took it to a shop and was told that this vehicle was badly rusted and had a lot of hidden rust damage.. and improperly installed brakes., coolant leaks and exhaust leaks.. after finding this out I tried to call the dealership and he hasn't been replying.. I was also told this truck wouldn't pass a legal VA inspection.. so the current one was fraudulent I have all documents that support my case. I will like to turn this vehicle back in and given a full refund

Engine light, 4Lo light, and ASC light on with code P2442. Vehicle in limp mode.

The contact owns a 2011 Toyota Tundra. The contact stated that upon starting the vehicle, the steering wheel was difficult to maneuver. There was no warning light illuminated. The contact was able to drive the vehicle to his residence using physical force to steer the vehicle. An independent mechanic met the contact at his residence and diagnosed that the power steering gear was leaking oil into the boot. The vehicle was then towed to the dealer but was not diagnosed or repaired. The contact associated the failure with NHTSA Campaign Number: 21E103000 (Steering) however, the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was approximately 79,000.

1. The secondary air injection valve and/or air injection pump. 2. Sometimes the vehicle will go into "limp" mode and only go 35 mph. If the switch valve is stuck "closed" like mine, the car may not be able to dilute the exhaust fumes and the fumes and travel into the cabin of the vehicle. 3. Yes, check engine light code was read as P2441. 4. No, the vehicle can not be driven at this time. 5. No, and around July 24th the check engine light came on. The symptoms continued to get worse. In short, Toyota has issued extended warranties and reimbursements for this design flaw for Tunda's 2007-2010. The design flaw being the air pumps allow water and debris to be sent into the air injection valves. My truck being a 2011 was never alerted to this issue or covered due to the year of my vehicle. The issue is my truck is the SAME generation truck as the 2007-2010 trucks. Which means I too have the design flaw as well but Toyota is refusing to fix their mistakes. After further inspection of my truck, see attached pictures, there is obvious water in the valve system and it has been rusted as well (unable to clean it). My issue is Toyota only covering half of the generational years for a design flaw that is also in the other half. These repairs can range from $2k-$4k and it seems as Toyota only made the extension to the most relevant truck years at the time and left everyone else behind. It is very distributing that a large manufacturer would cut corners like this, for a flaw that was their design.

The contact owns a 2011 Toyota Tundra. The contact stated that while a routine inspection was being performed on the vehicle, he was informed that engine oil was found on the heat shield. The dealer diagnosed the vehicle and determined that the passenger’s side cam-tower was leaking oil and needed to be replaced. The vehicle had not been repaired. The manufacturer was made aware of the failure. The approximate failure mileage 32,000.

The contact owns a 2011 Toyota Tundra. The contact stated while driving approximately 55-70 MPH, the check engine warning light illuminated and the vehicle started losing power. The contact veered to the side of the road and turned off the vehicle. The contact restarted the vehicle and was able to continue driving. Additionally, the contact stated that upon starting the vehicle, the accelerator pedal was depressed; however, there was a delay in the vehicle response. The contact stated that the failure reoccurred several times while driving. The contact stated that the vehicle shifted into LIMP mode. The vehicle was taken to a local Pep Boys who provided diagnostic test codes to the contact but did not physically diagnose the vehicle. The vehicle was taken to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and informed the contact they could not assist as the vehicle had not been diagnosed by the dealer. The failure mileage was approximately 165,000.

The contact owns a 2011 Toyota Tundra. The contact stated that the truck bed bolts that secured the truck bed to the subframe were rusted. The vehicle was taken to the dealer however, the contact was informed that the VIN was not under recall relating the failure. No additional assistance was provided. The manufacturer was contacted and notified of the failure. The failure mileage was 104,000.

I have reached out to Toyota multiple times this month. I have severe rust developing und the bed of my truck where the bed bolts fasten the bed to the frame. After some research I have found where other tundra owners with the same year have similar issues. My fear is over time the bed is going to be unsecured from the chassis. Rust is bubbling the line-x up. I have never seen anything like this before. Toyota refuses to accept responsibility that they have a parts/material/metal issue for this year truck.

The contact owns a 2011 Toyota Tundra. The contact stated that while driving at an unknown speed, the steering wheel was difficult to turn with an unknown warning light illuminated. In addition, the contact noticed that the power steering fluid was leaking out on the passenger’s side of the vehicle. The vehicle was taken to an independent mechanic where it was diagnosed that the rack and pinion needed to be replaced. The vehicle was repaired however, a power steering fluid leak recurred. The vehicle was taken to another independent mechanic to be diagnosed; however, the contact was unaware of the cause of the failure. The vehicle was not repaired. The dealer was not contacted. The manufacturer was not notified of the failure. The approximate failure mileage was unknown.