2000 TOYOTA TUNDRA Complaints

The contact owns a 2000 Toyota Tundra. The contact stated that there was an abnormal clicking sound coming from the front end of the vehicle while depressing the brake pedal. The vehicle was taken to an independent mechanic and was diagnosed with upper and lower ball joints failure. The contact was informed that the upper and lower ball joints and the axle needed to be replaced. The manufacturer was not notified of the failure. The vehicle was not yet repaired. The failure mileage was approximately 51,000.

On February 19, 2026, I contacted Hendrick Toyota Apex (1210 Laura Village Rd, Apex, NC 27523) to schedule repair for two open safety recalls on my 2000 Toyota Tundra (VIN: [XXX] ) under NHTSA Campaign #09V444, Toyota Campaigns BXD and BZD. The dealership incorrectly refused to perform either recall, stating that neither could be done in North Carolina because they only apply to cold climate states. This is incorrect — Campaign BZD was specifically created as a supplemental campaign to allow Toyota dealers outside the 20 cold climate states to inspect and repair covered vehicles. I was turned away on my first call. Only after calling back a second time to lodge a complaint did a different representative look up the recalls and confirm that Campaign BZD can in fact be performed at their location. Had I accepted the initial refusal, I would have been denied a free safety recall repair on a vehicle with 255,656 miles and visible frame corrosion. The dealership's staff appear to be untrained on recall Campaign BZD and are likely turning away other affected Tundra owners. I have call recordings documenting the incorrect refusal. I am requesting NHTSA review this dealership's handling of recall #09V444 to ensure other consumers are not wrongly denied safety recall service. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

2000 toyota tundra SR5 4door 4.7 liter V8. Sunroof glass blew off on freeway at 65mph almost hit car behind me. No police report, no person injured. November 3, 2025.

Excessive frame rust that is quickly progressing despite efforts to remedy. There was a recall due to this issue but I was told a few years ago by Toyota that my VIN was not covered. All the 2000 Tundra's have this issue with the frame rust but I was told I am not in the north east and would not be covered.

The brackets supporting the right rear brake line were severely rusted and failed. The brake line cracked at the juncture of the wheel cylinder attachment nut. Subsequently,there was a total loss of braking action on all wheels. The dual cylinder master cylinder failed to actuate the front brakes.THERE WAS NO BRAKING ACTION. The emergency brake had to be deployed in order to stop the vehicle.

The contact owns a 2000 Toyota Tundra. The contact stated that while driving approximately 30 MPH and hauling a boat, the subframe nearby the transmission cross member detached from the vehicle. The vehicle was towed to the residence. The contact was able to inspect the vehicle and became aware of severe rust on the subframe with several areas where the subframe had rusted through and had holes. The vehicle was not taken to a dealer or independent mechanic to be diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 230,000.

This complaint is to document severe frame damage due to corrosion my 2000 Toyota Tundra. The rusted frames of the 2000-2003 Tundra’s are a well-documented problem that the Toyota Corporation has tried, unsuccessfully, to remedy in the past but continues to be a safety hazard to passengers and other innocent people when the frame finally fails. Some owners have been fortunate enough to have their frame replaced while others, like myself, have been told there is nothing available to remedy the problem. As seen in the attached pictures, I have significant corrosion along the frame walls where two pieces of steel were sandwiched together to reinforce the frame from where the gas tank is located to the rise where the bed attaches. These areas are crucial as the cross members of the frame attach to one another to form a solid body. Failure of this area would cause the truck cab to separate from the bed in the event of a crash, or even a deep pothole. It would also likely drop the gas tank out of the frame and impact the pavement with disastrous consequences for anyone around. I have reached out to my local Toyota dealer who stated “your vehicle is part of a class-action lawsuit and we cannot do anything without the Toyota Corporation’s approval.” They gave me the phone number of Toyota Customer Relations who kept repeating to me that “the truck is out of warranty and are no recalls available for my VIN number”. I have researched my VIN [XXX] ) and it does indeed appear to be included in a frame replacement program. When pressed about the inclusion of my truck in the program, they once again reference the warranty expiration and VIN exclusion. There were an estimated 110,000 trucks impacted by the faulty metallurgy process of the frames and Toyota was awarded a settlement from the Dana Corporation that manufactured the frames but not all owners have been recipients of the award. Please advise. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2000 Toyota Tundra. The contact received notification of NHTSA Campaign Number: 09V444000 (Structure); however, the part to do the recall repair was not yet available. The contact stated that the rear cross member was rusted. The local dealer was contacted and informed the contact that the recall repair could not be performed at their location. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure and contacted the dealer; however, the dealer advised that the recall repair could not be performed at the dealer location. The failure mileage was approximately 327,000. Parts distribution disconnect.

Frame of truck rusting apart Rust problem identified by independent dealer. I was told by repair shop that the frame could twist apart at any moment.

Frame of the vehicle is starting to rust, clear coat paint is wearing off and is starting to chip with small spots of rust on the roof and hood, lower ball joint failure due to corrosion and degraded components. Unknown why the lower ball joint failed. Vehicle is not in the rust belt but definitely experiences corrosion and suspension issues.