GMC SIERRA Recalls

Aug 28, 2007 – CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY.

Oct 31, 2006 – CERTAIN VEHICLES ORIGINALLY BUILT WITH CLOTH SEATS THAT WERE EQUIPPED WITH AN AUTOMATIC AIR BAG PASSENGER SENSING SYSTEM AND LATER REUPHOLSTERED WITH AFTERMARKET LEATHER SEAT COVER KITS ARE INVOLVED. TESTING HAS INDICATED THAT THE AFTERMARKET LEATHER SEAT COVERS CAN CAUSE THE PASSENGER SENSING SYSTEM TO MALFUNCTION.

Aug 11, 2006 – CERTAIN SPORT UTILITY VEHICLES AND TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES HAVE AN INCOMPLETE TIRE RIM DESIGNATION ON THE CERTIFICATION/TIRE LABEL LOCATED ON THE DRIVER'S DOOR EDGE. IN ADDITION, THE LABEL MAY ALSO BE MISSING THE TIRE LOAD RATING ON THE LABEL. ALTHOUGH THIS INFORMATION IS NOT REQUIRED BY THE STANDARD, IF A TIRE OF A LESSER LOAD RATING IS INSTALLED, THE TIRE MAY NOT BE ABLE TO SUSTAIN THE LOADS ENCOUNTERED DURING USE.

Aug 03, 2006 – ON CERTAIN TRUCKS EQUIPPED WITH AN 8.1L V8 (RPO L8-VIN G) ENGINE HAVE A CONDITION IN WHICH THE ENGINE FUEL RAIL PULSE DAMPER RETAINER CLIP MAY FRACTURE RESULTING IN INADEQUATE RETENTION OF THE DAMPER.

Jun 06, 2006 – CERTAIN FEDERAL-MOGUL NATIONAL AND CARQUEST AFTERMARKET HUB ASSEMBLIES, P/N 515058, SOLD FOR USE ON 2001-2006 GENERAL MOTORS 1500 AND 2500 4WD TRUCKS. ON THE SUBJECT HUB ASSEMBLIES, THE ABS SENSOR CORD DEPARTS FROM THE HUB ASSEMBLY AT A 90 DEGREE ANGLE. AS A RESULT, THERE IS A FIT ISSUE WITH THE BRAKE ROTOR DUST SHIELD INTERFERING WITH THE ABS SENSOR CORD. IF THE HUB ASSEMBLY IS INSTALLED DESPITE THIS INTERFERENCE, THE GAP BETWEEN THE ABS SENSOR AND THE TONE WHEEL MAY BE ALTERED. THIS MAY WEAKEN THE OUTPUT OF THE ABS SENSOR. DIMINISHED OUTPUT COULD RESULT IN AN UNWANTED ABS ACTIVATION AT LOW SPEEDS AND STOPPING DISTANCE COULD BE AFFECTED.

May 19, 2006 – CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

Mar 08, 2006 – CERTAIN PICKUP TRUCKS HAVE GALVANIZED-BRAIDED-STEEL TAILGATE SUPPORT CABLES USED TO SUPPORT THE TAILGATE IN THE FULL OPEN (HORIZONTAL) POSITION. OVER TIME THESE CABLES CAN CORRODE AND FRACTURE WHEN LOADS ARE APPLIED TO THEM.

Feb 01, 2006 – CERTAIN FABTECH AFTERMARKET REPLACEMENT PITMAN ARMS, P/NOS. FTS71000 AND FTS71001, INSTALLED FOR USE ON CERTAIN 2001-2006 GM C/K 2500 PICK UP TRUCKS AND SPORT UTILITY VEHICLES. THE PIN LOCATED INSIDE THE PITMAN ARM CAN SHEAR OFF DUE TO A REVERSE BENDING FATIGUE CONDITION, RESULTING IN A TOTAL LOSS OF STEERING CONTROL.

Dec 07, 2005 – CERTAIN TRUCKS AND SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, "TIRE SELECTION AND RIMS." THESE VEHICLES WERE SHIPPED WITH TIRE AND LOADING INFORMATION LABELS LISTING AN INACCCURATE VEHICLE CAPACITY WEIGHT.

Oct 05, 2005 – CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH A POWER STEERING HOSE THAT IS NOT TO SPECIFICATION. UNDER EXTREME STEERING MANEUVERS, SUCH AS TURNING THE STEERING WHEEL FULLY TO THE LEFT OR RIGHT WHILE BRAKING, THE HOSE MAY FRACTURE AND LEAK FLUID.