2021 BMW X3 Complaints

The contact owns a 2021 BMW X3. The contact received notification of NHTSA Campaign Number: 26V438000 (Electrical System). The local dealer confirmed that the remedy was not yet available. The vehicle was not diagnosed or repaired. The manufacturer was not contacted. The contact had not experienced a failure.

The contact owns a 2021 BMW X3. The contact stated that while attempting to start the vehicle, the engine hesitated while turning over. The contact received notification of NHTSA Campaign Number: 26V438000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. The failure mileage was 76,494.

The engine mounts on my BMW X3 have failed. It is a known national issue with the car, it can be exacerbated by the star/stop feature. There are no warnings or recalls and the repair is several thousand dollara.

I am writing to report a known safety-related defect on my 2021 BMW X3, VIN [XXX]. 1 The vehicle was diagnosed at BMW of Manhasset, an authorized BMW dealer, with a coolant leak originating from the heat management module and oil filter housing. This is not ordinary wear and tear. BMW's own service bulletin SIB 11 10 25 identifies this failure mode as a known issue affecting B46/B48/B58-equipped vehicles, which includes my X3. 3 4 5 The same defect is also the subject of an active U.S. class action, XXX. v. BMW of North America, LLC (D.N.J.), covering the same engine families. This defect presents a genuine safety risk, not merely a cost issue. The oil filter housing's internal wall structures, which separate the oil and coolant passages, are prone to failing or warping, and the gaskets sealing those passages are prone to premature failure. When this occurs, coolant can leak into the oil sump or drain externally, which can cause sudden engine overheating and/or engine failure, sometimes within minutes of the leak developing. If oil escapes and contacts the hot exhaust, it can also create a fire risk. A vehicle experiencing this failure is not safe to continue driving, and the risk of sudden, catastrophic engine damage or fire warrants a recall rather than leaving affected owners to discover and pay for this known defect on their own. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

There is an open safety recall for the engine starter on this vehicle. I contacted the local BMW dealer on 7/10/26 to have the recall fixed they advised me that they cannot address the recall because BMW North America has not sent the parts out for them to do so. I would like this on record in case there is any future damage to my vehicle due to the recall.

2021 BMW X3 M40i VIN# [XXX] Starter failed with the following BMW codes: [XXX] Starter Malfunction was displayed on the Dash and car took multiple attempts or waiting 10 seconds to start. I had the starter replaced by the Dealer, who confirmed the starter required replacing. I was told it was not part of the recall based upon VIN of car? INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Lane keep assist performance has been degrading to the point that it very quickly disables itself when overcorrecting or an oscillation of the steering wheel is developed while system is trying to keep the car inside the lane (which eventually also disables the system). System always had a bit of “bounce” between the two sides of the lane and struggled to keep the vehicle exactly in the middle of the lane. But it is much worse now and I am now more often than not disabling it. System feels unsafe now. The KAFAS (camera) module is having random faults now that disable the system but go away and Lane Assist can be re-engaged without any change in the performance I described above. As an engineer I would simply call the Lane Assist control algorithm unstable with an oscillation that gets amplified. I’ve done simple tests where I center the vehicle inside the lane, engage the feature, and take my hands off the steering wheel (vehicle has some limited hands free capability—goal is to eliminate any disturbance from my hands to be the potential trigger for the oscillation). I used to be able to do this and now it rarely works and forces me to quickly take over. Another observation has been that the camera is also used to follow a vehicle ahead of me (in lieu of centering in the lane) and this rarely works now to the point of trusting it. Nothing recent has changed on the vehicle. At first I thought it may be a wheel alignment problem but when the camera module started to have sporadic errors I eliminated that root cause (recall that Lane Assist system always oscillated when engaged, but was definitely usable before). Seems like both problems originate at the camera module. Vehicle did have a windshield replacement and camera was recalibrated many months before this problem developed. Performance was the same immediately before and after replacement.

The contact’s wife owns a 2021 BMW X3. The contact stated that while attempting to start the vehicle on several occasions, the vehicle failed to start. The message "Vehicle Failed to Start - Contact Dealer" was displayed. The contact stated that for the vehicle to start, the contact had to turn the power off in the vehicle power, lock and unlock the doors using the key fob, and then, after several attempts, the vehicle eventually started. The contact associated the failure with NHTSA Campaign Number: 26V056000 (Electrical System). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 50,000.

Car suffered a complete electrical failure when stopped at a traffic light. No warnings on dash, wipers made one swipe then vehicle completely shut down. Hazards did not work. Car was towed to dealership

The contact owns a 2021 BMW X3. The contact received notification of NHTSA Campaign Number: 25V636000(ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The local dealer was contacted and it was confirmed that the part was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced the failure.