2013 BUICK LACROSSE Complaints

Odometer Fraud. The contact purchased a 2013 Buick LaCrosse on March 3, 2024. The vehicle was purchased from the dealer. The odometer was reported at 118,000 during the sale. The vehicle was recently taken to an independent mechanic for service. The contact was provided with an auto report in which the latest odometer reading was reported in October 2023 at 115,670. The independent mechanic checked the hard drive. The contact was informed that the correct odometer reading was 221,855.

The contact owns a 2013 Buick LaCrosse. The contact stated that the vehicle experienced starting failures and was taken to Piedmont Tire & Auto, where the battery was replaced. The contact stated that while driving at an undisclosed speed, the vehicle made an abnormal sound, and felt like the vehicle had struck a bump, and the steering locked up. The vehicle was taken back to Piedmont Tire & Auto, where it was diagnosed and determined that the ABS wheel speed sensor ring on the passenger’s side rear wheel bearing had fractured, and the passenger’s side rear wheel bearing and hub assembly were replaced. Additionally, the contact stated that while attempting to start the vehicle, the vehicle failed to start, and the ignition key became stuck in the ignition switch. The contact jump-started the vehicle, which released the ignition key from the ignition switch. The vehicle was towed back to Piedmont Tire & Auto, where the battery was replaced; however, the failure persisted. The vehicle was then diagnosed with an electrical shorted starter and blown main fuses. The starter and the main fuse assembly were replaced; however, the failure recurred weeks later. The vehicle was again towed to Piedmont Tire & Auto and was being diagnosed. The vehicle was not yet repaired. The manufacturer was notified of the failure and advised the contact about unknown related recalls. The failure mileage was approximately 76,490.

My vehicles started experiencing a Service Power Steering Code and Service Stabilitrak warning after I Replaced my Sway Bar Bushings and Sway Bar Links and Started Giving Me A Code On My Scan Tool Of CO55C:00, and Lost Of Communication With Electronic Brake Module(UO121:00) Code. I Also Have A Multi-Axis Acceleration Sensor Code. Power Steering Module, When I Disconnect my Battery Completely It May Delete Itself and my Steering Sometimes Returns, but If I Relearn/Recalibrate The Steering Angle Sensor and Clear The Codes With My Scan Tool My Steering Will Return. It Has No Specific Road Conditions, Speed, or Turns That Makes It Return, It Just Picks and Chooses When It Wants To Come On. I Checked All My Grounds, Wires, and Connectors For Corrosion or Other Damage. I Have Had An Alignment Twice and That Doesn’t Fix It Either. I Know This Same Issue Was A Recall On Other Models. Please Contact Me Back So My Issue Can Be Resolved. Thanks and Have A Blessed Day. I Have Been Trying Everything To Figure Out The Issue and My Car Has Been Sitting Since Mid December and She Only Has 94310 Miles On My Buick.

Today is 8.26.2025, I took this car back and left it w/dealership: Let them figure it out! I told them 0ne month after purchase this car is constantly EMPTY with no/Oil. I should not be getting oil changes this often. "Oh, it just burns more Oil and you bought a USED car"...Months later I hear smalls sounds, engine light comes on, then goes away, smoke begans to continue spreading behind the BUMPER building a permanent black spot on bumper! It smells, from time to time, plus car feels sluggish when driving past 50mph almost SCARED it will cut off** Now, I gather my funds that I don't have to SPEND (CASH) no CREDITCARD and I proceed to BELLE TIRE! I am on file within their system. (Receipts) They do what they do... apparently no Leaks. But the car is burning too much oil!! too Fast! "Keep an Eye on your Levels"... hmmm* I also got a MAINTENANCE TUNE-UP on my next visit. So far roughly $2000 has been SPENT towards this VEHICLE (Buick). (New Battery also) plus AAA Cost *I have a Membership* Now time continues to move forward this car KNOCKING,CLOUDS of SMOKE, In the car, Outside the car, Around the Car, thru the vents, PULLING, STAHLING, KNOCKING, CLUNCK,CLUNCK,; EMBARASSING!!! My son and I, Oh no... *We the Meat Inside a Barbecue Grill* DROP OFF/ASAP (pulled over Called AAA). (7/24/2024 - 8/25/2025)Owned this car 1Yr!! I need a New Car they wont give me one...I made every monthly payment On time all by WESTERN UNION (receipts). I go into the same store each month 19th -22nd and PAY. They don't want to TRADE-IN either*

Well the belt tensioner and the hybrid motor Drive Motor Performance and Hybrid Power train Control Module Requested MIL Illumination Yes not just any mechanic can work on the car because of the hybrid system is to much voltage And the check engine light came on the car

My vehicles steering column locked up and I could not turn left this issue was recalled on other similar year make and models but my VIN number was excluded from the recall. I can not get a replacement part for it as the part is on back order in the meantime I can not drive this vehicle and have no recourse. I am seeking to get the manufacturer to produce the needed part so I can purchase and install it but they will not tell me when I can expect it it's been over a month and I can drive my car. How can I get some assistance in this matter. Please advise. Thank you. [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Power steering locked up. GMC Vacaville ran a scan and confirmed C055C steering gear performance malfunction. There has been a recall on this issue and we are being told our VIN is not a part of the recall. The car has 119489 miles.

On May 7th, I was informed the cause of load roaring noise was due to the failure of 2 front wheel bearing. After the work was completed I was informed both rear wheel bearings would need to be replaced. Four wheel bearings failed simultaneously. Yes the car is parked at the dealership and available for inspection. How was your safety or the safety of others put at risk? Potential for Accidents: Wheel Disengagement: The Buick dealership technician confirmed four wheel bearing needed to be replaced at the same time. One bad bearing would allow me the driver to possibly control the car until it is safely out of traffic. Four failed wheel bearings could cause the driver to lose all control of the vehicle and or the wheels to disengage from the vehicle which has the potential for serious injury or death. A disengaged wheel could fly off and cause harm to other drivers or pedestrians, or the driver themselves could lose control and crash. Yes, the service department at the Buick dealer confirmed four wheel bearings failed on May 7th. Yes I received another inspection from an independent auto repair servicer. No the vehicle has routine maintenance and a state inspection without any warnings of the need for four new wheel bearings.

The bolt that secures the Serpentine belt tensioner unit to the motor block has repeatedly snapped apart leaving the tensioner unit to dangle from the block. Not secured, which causes the belt to dislodge or break (both have happened) the spring is left to flail about as is the tensioner unit since it is no longer connected to the engine block. Not to say where the other half of the bolt could end up. So far each time it snaps in half the other half remains in the block. But the unit is no longer secured to the block. While driving when this occurs makes controling the vehichle unsafe. It loses power and or surges at will. A hope to make it to the side of the road without crashing or causing a crash is an issue. I cannot afford a repair establishment, a family member does my repairs. ... There has been no other inspection of the issue. As for warning lights. No. Everything is fine until the unit is jiggled away from the block after the bolt snaps in half. The force of the tensioner unit action (im assuming) is too much for the bolt - causing it to snap in two. It has occurred 2 times the second was the beginning of Feb 2025 and the first about 9 to 10 months earlier in 2024. The belt has also broken off before but the unit remained attatched to the block that time. I did see on youtube that others have had the bolt snap. Like it is not strong enough for the job it has to perform. Hope u can help

The contact's mother owns a 2013 Buick LaCrosse. The contact stated that while her mother was driving approximately 55 MPH, an unknown warning light illuminated, and the steering wheel was difficult to turn in either direction. The contact stated that her mother drove the vehicle to an independent mechanic who was able to retrieve a DTC fault related to a power steering assist failure. The mechanic informed the contact's mother that he was unable to repair the vehicle. The manufacturer was informed of the failure. The failure mileage was unknown.