2020 CHEVROLET EQUINOX Complaints

We were driving on the highway and just exited. My husband hit the brakes and the pedal was hard to push. He basically had to put all his weight on the pedal in order to slow down. Once we were able to stop completely, we got the 2020 Chevy Equinox looked at and we were told that the vacuum pump that is attached the the cam shift exploded and pieces were in the engine. This has caused approx. $3000 in damage that me and my husband can't afford. The vehicle is still at Classic Chevrolet in Grapevine. We are going to have to tow it back to my brothers until we can afford the payment to fix it.

The contact owns a 2020 Chevrolet Equinox. The contact stated that while exiting the highway at 50 MPH, the brake pedal had hardened and the contact could not depress the brake pedal. Several brake warning messages appeared on the instrument panel. The contact shifted the vehicle into neutral(N) and pulled into a parking lot to allow the vehicle to coast to a stop. Once the vehicle slowed to a complete stop, the contact shut off the vehicle. The vehicle failed to restart after multiple attempts. The contact called a relative to the scene who used a code reader to determine the cause of the failure. The code reader showed that there was a defect with the vehicle's vacuum pump, brake sensor, and intake camshaft position timing. The vehicle's codes were reset and the vehicle restarted; however, the brake failure persisted. Due to the failure, the vehicle was initially towed to the relative's home and eventually to the dealer. The dealer performed a diagnostic where they discovered metal shavings in the engine camshaft which damaged several parts of the engine. The vehicle had yet to be repaired and remained in the possession of the dealer. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to file a complaint. The failure mileage was approximately 100,000.

Was driving (in July) through a parking lot when brakes became hard to push. After stopping car, it would not start and went into battery save mode. Car was towed to Chevy dealership in Paducah, Ky. Vacuum pump was replaced and damage to cam shaft and timing chain. Problem was fixed after about $5800 of repairs. Now 2 months later, was driving and noticed “service brake assist” light came on, and brakes were hard to press. Luckily was at a low speed and able to pull over on the side of the road. Car was towed to the local Chevy dealership in Hopkinsville, ky. It is currently waiting for diagnosis of probably the same issue. first incident happened in July, 2nd was at the end of august.

I have 149,000 miles in this car. In my lifetime of being the one owner and purchasing this car brand new the vacuum pump has failed five times. Twice now resulting in blown engines. And still no recalls.

The contact owns a 2020 Chevrolet Equinox. The contact stated while driving approximately 40 MPH, the vehicle went into LIMP Mode and failed to exceed 10 MPH. The check engine warning light was illuminated. The vehicle was taken to an auto repair shop to purchase a diagnostic tool; the diagnostic tool was used to diagnose the vehicle. The diagnostic scan tool determined that the ECM Module, air induction system, and oil pressure system needed to be repaired. A dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline. The failure mileage was 144,919.

I was driving home when I exited the freeway my car turned off on me. I tried to turn it back on since I was in the middle of a busy street it started for under a minute which it gave me enough time to merge jusr a little to the right. After that the car wouldn't start at all. This problem could've been a lot worse if it would've happened while I was on the freeway. My vehicle turned off without any warnings any vehicle would've slammed in to me at high speed if it would've shut down a minute prior to me exiting. I didn't get any warnings/ lights nothing it just turned off on me in the middle of the road. I had to get it towed to Autonation where they detected the Fuel Module was the problem. This item has been out of stock for sometime now. My car is still at a dealership and may be inspected if needed.

When pressing the gas pedal, my Equinox does not accelerate and move forward. It takes approximately 2-3 seconds for the vehicle to react to the pressing of the pedal and that reaction is slow despite applying full pedal movement. This happens intermittently and appears to be most notable during extreme high temperatures. It also has been noticed while trying to accelerate to pass in addition to trying to go from a stop. I was almost hit by another vehicle because my Equinox didn't go. When it did go, it took roughly another 5-7 seconds to get up to the 45 MPH speed limit.

Fuel pump modular went out and the car stalled out. The same issue is happening to the 2021 and 2022 models that have the recall not sure why the 2020s don’t have the sane

The contact owns a 2020 Chevrolet Equinox. The contact stated while driving at an undisclosed speed, the vehicle was erratically jerking. The vehicle was taken to the dealer where it was diagnosed with a failed torque converter. The contact was informed that the torque converter needed to be replaced. The vehicle was repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 60,000.

The contact owns a 2020 Chevrolet Equinox. The contact stated while driving approximately 45 MPH and approaching a red traffic light, the brake pedal was depressed but the vehicle failed to respond. There was no warning light illuminated. The contact swerved to the left and overtook the vehicle in front of her vehicle, drove off the road, and drove in circles on the grass until the vehicle stopped. The contact then parked the vehicle. The contact stated then resumed driving to the residence at slower speeds. The contact stated that the failure had been recurring while driving. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not notified of the failure. The failure mileage was approximately 106,070.