1993 CHEVROLET LUMINA APV Complaints

RECALLS 94V027 AND 94V015 DO NOT COVER MY VAN, BUT DESCRIBE THE PROBLEMS I AM HAVING EXACTLY. SINCE WE BOUGHT THE VAN IN 1995 THE REAR SEATBELTS HAVE LOCKED UP AT THE ODDEST TIMES. ALL OF THE BACK SEAT BELTS (NOT JUST THE ONES DESCRIBED IN 94V027) LOCK UP AT TIMES AND WILL USUALLY UNLOCK WITH A FEW DAYS OF DRIVING. ALL OF THE REAR SEATBELTS WILL LOCK ON AN INCLINE (AS DESCRIBED IN 94V015) AND NOT UNLOCK UNTIL THE VAN IS MOVED TO LEVEL GROUND. MY KIDS KNOW THAT SOMETIMES THEY CAN NOT PUT ON THEIR SEATBELTS UNTIL THE VAN IS MOVING. MY CONCERN IS THAT THE RECALLS SHOULD COVER MORE SEATBELTS AND MORE VANS THAN LISTED. THE LEFT REAR SEATBELT (ONLY) OF MY VAN APPEARS TO BE COVERED BY A RECALL, YET ALL THE SEATBELTS ARE THE SAME. '94 SEATBELTS ARE COVER BY THE RECALL 94V015, BUT MINE ARE NOT, EVEN THOUGH THEY HAVE THE SAME PROBLEM AND APPEAR TO BE THE SAME SEATBELTS. CHEVROLET REPLACED ALL OF THE SEATBELTS UNDER WARRANTY ONCE MANY YEARS AGO, AND THE SITUATION IMPROVED UNTIL THE WARRANTY EXPIRED. *TR

TL*THE CONTACT OWNS A 1993 CHEVROLET LUMINA APV. THE CONTACT STATED THAT THE REAR SEAT BELT RETRACTORS LOCK AND WILL NOT RELEASE THE SEAT BELTS. IN ADDITION, THE SEAT BELTS THAT ARE CLOSEST TO THE SLIDING DOOR BECOME STUCK INSIDE OF THE DOOR. GENERAL MOTORS STATED THAT RECALL # 94V100000 (SEAT BELTS:FRONT:WEBBING) AND RECALL # 94V027000 (SEAT BELTS:REAR) ARE NOT RECOGNIZED AND DO NOT APPLY TO HIS VIN. IN ORDER TO USE THE SEAT BELTS, THE CONTACT MUST DRIVE OVER A FEW BUMPS IN THE ROAD FOR THE SEAT BELTS TO RELEASE. THE BODY STYLE WAS UNKNOWN. THE CURRENT MILEAGE IS 160,000 AND FAILURE MILEAGE WAS 30,000.

THE MIDDLE PASSENGER SEAT BELT FAILED TO RETRACT WHEN RELEASE. IT STAYED IN THE RELEASE POSITION. THERE WAS A RECALL ON THIS ISSUE BUT THE DEALERSHIP WAS UNABLE TO TELL IF THE RECALL APPLIED TO THE CONSUMER VEHICLE IDENTIFICATION NUMBER BECAUSE THE RECALL WAS 10 YEARS OLD. *JB ALSO, THE FRONT PASSENGER SEAT BELT FAILED TO RETRACT. *SC

THE TAILGATE LOCK FAILED TO LOCK OR UNLOCK WHEN APPLIED. CONSUMER DROVE THE VEHICLE TO DEALER FOR INSPECTION, AND MECHANIC DETERMINED THAT LOCK MECHANISM NEEDED TO BE REPLACED. CONSUMER INFORMED THE MECHANIC THAT THIS PROBLEM OCCURRED MORE THAN ONCE AND HAD NOT BEEN RESOLVED. *AK THE TAILGATE LOCK CYLINDER RETAINER CAME OFF WHICH RESULTED IN THE LOCK CYLINDER FALLING OUT OF THE TAILGATE. *NM

THE WINDSHIELD WIPERS IN MY VAN DO NOT WORK SOMETIMES. TAKEN TO MY MECHANIC TWICE FOR REPAIRS AND BOTH TIMES THEY WERE WORKING PROPERLY AND THE PROBLEM CAN NOT BE FOUND. HAS BEEN HAPPENING SINCE LAST SUMMER AND ONLY HAPPENS SPORADICALLY.

CONSUMER STATES FUEL TANK STARTED TO IMPLODE ON THE BOTTOM CAUSING THE PUMP PICK UP TO COME IN CONTACT WITH THE TANK BOTTOM CUTTING OFF FUEL SUPPLY RESULTING IN A NO START CONDITION. *TT *NLM

THE VEHICLE DOES NOT HAVE A MIDDLE BRAKE LIGHT, CONSUMER BELEIVES THIS IS A POTENTIAL SAFETY HAZARD. *YH

WHILE DRIVING ACCELERATOR WAS STUCK OPEN AT FULL THROTTLE. VEHICLE TOWED TO DEALER. FEEL FREE TO PROVIDE ANY FURTHER INFORMATION.*AK

THE FRONT TWO SEAT ANCHORS ON THE DRIVER'S SIDE HAVE SHEARED OFF. I COULD UNDERSTAND IF THE BOLTS CAME LOOSE OR SOMETHING, BUT THESE ARE CLEARLY STRUCTURAL FAILURE. SINCE IT IS THE SEAT WE ARE TALKING ABOUT IT IS CLEARLY A SAFETY ISSUE THAT THESE COMPONENTS HAVE FAILED. I CAN UNDERSTAND NORMAL WEAR AND TEAR, BUT THE METAL USED IN SEAT MOUNTS SHOULDN'T SHEAR UNDER NORMAL WEAR AND TEAR. AND NO, MY WIFE AND I DON'T WEIGH 400LBS OR SOMETHING. ;) THANX FOR ANY HELP YOU CAN PROVIDE.

A LARGE CRACK IN SUB- FRAME/ENGINE CRADLE FROM NORMAL USAGE IS A SAFETY HAZARD AND OBVIOUS FLAW IN INTEGRITY OF THIS PART.*AK