2006 CHEVROLET SILVERADO 1500 Complaints

TL* THE CONTACT OWNS A 2006 CHEVROLET SILVERADO 1500. THE CONTACT STATED THAT WHILE DRIVING APPROXIMATELY 40 MPH, THE VEHICLE STALLED WITHOUT WARNING. THE VEHICLE WAS TOWED TO A PRIVATE MECHANIC WHERE UNKNOWN REPAIRS WERE MADE TO THE VEHICLE. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 3,000 AND THE CURRENT MILEAGE WAS 36,000.

MY MECHANIC TOLD ME THAT MY BRAKES WILL FAIL FROM RUSTED BRAKE LINES AT ANY TIME. A PROBLEM HE SEES EVERY WEEK.THE UNDER SIDE OF MY TRUCK IS COMPLETELY RUST FREE AND THE BRAKE LINES LOOK LIKE THE CAME FROM THE BOTTOM OF THE OCEAN! I AM AFRAID TO PUT MY SELF AND MY FAMILY AND OTHER PEOPLE AT RISK DRIVING THIS TRUCK.THE REPAIR COST IS OUT OF MY GRASP.I ALSO HAVE A 2002 SUBARU WITH MANY MORE MILES ON IT DRIVEN ON THE SAME ROADS IN THE SAME WEATHER AND YOU COULD TAKE THOSE LINES OFF AND SELL THEM FOR NEW!I AM 62 AND HAVE OWNED ALOT OF CARS AND TRUCKS IN MY LIFE AND NEVER HAVE SEEN ANY THING WITH THAT POOR OF METAL USED ON SOMETHING YOU USE EVERY DAY.I ONLY HAVE TO MENTION TO A SERVICE CENTER WHAT TRUCK I HAVE AND BEFORE I TELL THEM WHY I AM CALLING THEY ASK I STILL HAVE BRAKES. *TR

TL* THE CONTACT OWNS A 2006 CHEVROLET SILVERADO 1500. THE CONTACT STATED THAT WHILE DRIVING IN REVERSE AT APPROXIMATELY 5 MPH, THE BRAKES FAILED TO RESPOND WHEN DEPRESSED. THE GEAR LEVER WAS SHIFTED INTO PARK HOWEVER, THE VEHICLE DID NOT RESPOND. THE CONTACT WAS A CERTIFIED MECHANIC AND STATED THAT THE FRONT AND REAR BRAKE LINES WOULD NEED TO BE REPLACED DUE TO CORROSION HOWEVER, THE REQUIRED PARTS WERE NO LONGER BEING PRODUCED BY THE MANUFACTURER. THE VEHICLE WS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE PROBLEM. THE APPROXIMATE FAILURE MILEAGE WAS 60,000. THE VIN WAS UNAVAILABLE.

TL* THE CONTACT OWNS A 2006 CHEVROLET SILVERADO 1500. THE CONTACT STATED THAT WHILE DRIVING 4 MPH, THE VEHICLE MADE A LOUD POPPING SOUND AS THE CLUTCH PEDAL SANK INTO THE FLOORBOARD. THE VEHICLE WAS TAKEN TO THE DEALER WHERE THE TECHNICIAN DIAGNOSED THAT THE MASTER CYLINDER HOUSING FAILED. AS A RESULT, THE HOUSING AND CLUTCH ASSEMBLY NEEDED TO BE REPLACED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE AND CURRENT MILEAGE WAS 98,000. UPDATED 04/22/14*LJ *TR

THE WHEEL SPEED SENSOR FOR THE ABS SYSTEM IS AFFECTED ON MULTIPLE TRUCKS CHEVY PRODUCED FROM 99-06. THIS CAUSES THE BRAKING BELOW 10 MPH TO CAUSE PULSATION AND ABS MALFUNCTIONING CAUSING ME TO ALMOST REAR END VEHICLES AND BE UNABLE TO SLOW DOWN CORRECTLY. CHEVY KNOWS OF THE ISSUE YET IT IS NOT A RECALL FOR MY VEHICLE. *TR

BRAKE LINES ARE SEVERELY CORRODED AND NEED TO BE REPLACED BEFORE THEY FAIL AND RESULT IN AN ACCIDENT. *TR

DESCENDING SMALL HILL TO MAKE TURN AND BRAKES FAILED. WAS ABLE TO GET VEHICLE STOPPED, BUT WAS IN-TOWN SITUATION AND VERY DICEY FOR A FEW MOMENTS. INVESTIGATION REVEALED ROTTED BRAKE LINE(S). REPAIRED REAR LINES FOR $500 . . WAS FRI AFTERNOON AND 100 MILES FROM HOME AND COULDN'T GET BRAKES REPAIRED UNTIL TUES. MECHANIC SAID ALL LINES SHOULD BE REPLACED AND I AGREED FRONT LINES STILL NEED DOING. $300-500. I HAVE HAD THE LOW SPEED ABS ISSUE IN THIS VEHICLE AS WELL. THIS IS AN ISSUE THAT IS WAY PREMATURE! THIS IS A SERIOUS SAFETY ISSUE AND GM NEEDS TO STEP UP! IT'S OBVIOUSLY COMMON. PEOPLE WILL BE KILLED OR SERIOUSLY INJURED. BUT THE PERSON KILLED WON'T BE WRITING THIS LETTER, EH? NHTSA--WHERE ARE YOU? *TR

BRAKE LINE TO THE REAR DRIVER'S SIDE BRAKE FAILED AND BROKE AND LOST HYDRAULIC PRESSURE TO BRAKING SYSTEM. PULLED OVER INTO A GAS STATION AND HAD THE VEHICLE TOWED TO LOCAL DEALER FOR REPAIR/REPLACEMENT. *TR

STEPPED ON THE BRAKES, THE BRAKE PEDAL WENT TO THE FLOOR. I WAS FORTUNATELY ABLE TO EXIT THE ROAD AND, UPON INSPECTION, SAW FLUID LEAKING FROM A HEAVILY CORRODED FRONT LEFT BRAKE LINE. I HAD TO HAVE BOTH FRONT BRAKE LINES REPLACED BY THE DEALER AT A VERY SIGNIFICANT COST. I HAVE N EVER HAD A CORRODED BRAKE LINE ON ANY OTHER VEHICLE. I BELIEVE GM SHOULD TAKE RESPONSIBILITY FOR THIS PROBLEM ? IT IS A SAFETY ISSUE CAUSED BY THE USE OF INFERIOR MATERIALS OR IMPROPER BRAKE LINE PLACEMENT/LAYOUT. *TR

I WAS DRIVING ON THE HIGHWAY, AND APPROACHING A RED LIGHT, STEPPED ON THE BRAKES. UPON DOING SO, THE BRAKE PEDAL WENT TO THE FLOOR. I WAS ABLE TO PUMP THE PEDAL, AND DRIVE INTO THE NEXT PARKING LOT. I WALKED AROUND TO THE REAR OF THE TRUCK, WHERE I SAW A PUDDLE OF BRAKE FLUID. I LOOKED UNDER THE TRUCK, AND SAW THE FLUID LEAKING FROM A HEAVILY CORRODED BRAKE LINE. WHEN I GOT THE TRUCK HOME, I DID A MORE THOROUGH INSPECTION, AND DISCOVERED THAT ALL THE BRAKE LINES WERE HEAVILY CORRODED, AND WOULD NEED REPLACEMENT. I ORDERED AN AFTERMARKET, PRE-BENT STAINLESS LINE KIT. I TOOK THE TRUCK TO A LOCAL MECHANIC WHO WAS ABLE TO REPLACE THE LEAKING LINE, AND A FEW OTHERS, BUT WAS UNABLE TO REPLACE THE LINES GOING INTO THE ABS MODULE DUE TO THEIR LOCATION ON TOP OF THE FRAME, UNDER THE CAB. I AM ABLE TO DRIVE THE TRUCK NOW, BUT WILL NEED TO FIND ANOTHER MECHANIC WHO IS WILLING TO SEPARATE THE CAB FROM THE FRAME TO REPLACE THE REST OF THE LINES. I HAVE OWNED MANY VEHICLES OVER THE YEARS, AND NONE HAVE EVER HAD A CORRODED BRAKE LINE. THE LAST TRUCK I OWNED WAS A 1993 CHEVY SILVERADO, WHICH I HAD FOR 15 YEARS, AND RACKED UP 300,000 MILES, WITH NO BRAKE OR FLUID LINE ISSUES, AND DRIVEN IN THE SAME NORTHEAST CLIMATE AS THE 2006 SILVERADO. JUDGING BY THE AMOUNT OF COMPLAINTS I HAVE READ ONLINE, DESCRIBING THE SAME PROBLEM I AM EXPERIENCING, I BELIEVE GM SHOULD TAKE RESPONSIBILITY FOR THE REPAIRS. THIS PROBLEM IS A SAFETY ISSUE CAUSED BY WHAT I BELIEVE TO BE THE USE OF INFERIOR MATERIALS. *TR