2020 CHEVROLET SILVERADO 1500 Complaints

View complaints related to 2020 CHEVROLET SILVERADO 1500. The complaints found here are submitted by actual consumers with first hand experience. There are more than 670 complaints submitted for the 2020 CHEVROLET SILVERADO 1500. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2020 CHEVROLET SILVERADO 1500
    - Irving, TX

    During driving at low speed 15-30mph with 4 wheel drive set to auto. 4 wheel drive engaged and rear wheels locked up. Turned off 4wd no issue. Upon arrival at the dealer a bad sensor was determined to have caused the rear wheels to not perform as designed. After resolving the issue now I hear rubbing metal noise from the drive shaft. Spoke to Chevy about the issue haven’t heard back.

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Madison, AL

    My truck started acting sluggish like the parking brake was applied while driving. At a traffic light I put the vehicle in park applied and released the parking brake. I put the vehicle back in gear an let off the brake. The vehicle did not move so slightly pressed the accelerator. The vehicle still acted as if the brakes were applied. I could feel the slight movement and torque being applied but only slightly lurching. The traffic light turned green so I proceeded up to 45mph. A vehicle in front of me slowed to make a turn. Applied the brakes and nothing happened. I pressed the brake so hard that I lifted myself off the seat. I swerved to miss the vehicle avoiding a collision. Then warnings started popping up; "brake system failure max speed 62mph", "brake system failure max speed 42mph", Brake system failure", service traction control", "service trailer baking system". among others I was too busy to see all of them. I coasted to a stop in a nearby parking lot with visual and audible warnings still going. I shut the vehicle off then restarted it. Some warnings remained like traction control and the engine light. The vehicle appeared to be operating correctly so I drove it to a local dealer. they said there was a code for low voltage in the brake control module but couldn't get me an appointment for over two weeks. I took the vehicle to a regular mechanic who said what I described was impossible. That mechanic kept my truck for the balance of the day but could find nothing wrong. I no longer trust this vehicles brake system. In many scenarios the failure, were it to happen again could be catastrophic.

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Walnut Creek, CA

    What component or system failed or malfunctioned, and is it available for inspection upon request? Based on information from ODI Resume EA25007 & Safety Recall N252494002, it is more than likely engine connecting rod bearing failure. How was your safety or the safety of others put at risk? I was traveling at freeway speed, 70mph when it occurred. Has the problem been reproduced or confirmed by a dealer or independent service center? 11/25/25 at 12:33 (pacific), I am currently stranded 190 miles from home and waiting for the truck to be towed to the dealer. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? It has not. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Prior to Failure: Since I’ve owned the vehicle, I’ve notice slight ticking and slight knocking during cold start within the engine bay. At the time the noises seemed normal and not cause-for-concern. At Time of Failure: I was traveling on level grade on the highway when I heard a deep knock from the front, bottom left side of the engine bay. Within about a minute from the initial noise, I received a “check engine” warning light and a message of “ESC Warning” displayed on my instrument cluster. At that moment, I noticed the engine noise become more prevalent and constant. I immediately slowed and coasted to my next exit off the freeway.

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Ball, LA

    Brakes would not release after driving a little ways the brake system failure warning came on. I stopped and killed engine and restarted but it lunged and I lost all braking. I pulled over to side of road and again killed engine a couple minutes I restarted it released. Then drove normal. ????

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Pawtucket, RI

    The contact owns a 2020 Chevrolet Silverado 1500. The contact stated that while driving at various speeds, the tailgate opened independently without warning. Upon investigation, the contact discovered NHTSA Campaign Number: 24V060000 (LATCHES/LOCKS/LINKAGES) and linked the failure to the recall. The local dealer was notified about the failure, and the contact was informed that the VIN was not covered under the recall, and the contact was provided with an estimate for the repair. The manufacturer was also notified of the failure, but referred the contact to the NHTSA Hotline to report the failure. The vehicle was not repaired. The failure mileage was approximately 50,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2020 CHEVROLET SILVERADO 1500
    - Arlington, TX

    While driving it said "service ESC", "brake system failure" and then "trailer brake system failure" "max speed 62." Brakes when pressed would not work. Had to cruise to stop. When truck shut down and restarted it said "max speed 43" and check engine light came on. Truck was then towed to mechanic and waiting to be looked at/worked on.

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Von Ormy, TX

    There was a brake system failure and the brakes stopped working while going 50 mph

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Las Cruces, NM

    Making turn at slow speed. Possibly Transmission slipping and rear tire locking up. engine light turned on

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Norman, OK

    The transmission quite working while I was driving down the road. Took my foot off of the gas pedal and my truck bogged down completely and had no power to it. It is at an auto repair shop so I am unaware if it could be inspected under request. Took time but was able to safely get off the roadway and out of traffic. It did the out of no where. Started having some issues this summer but no warnings lights ever came on, so I didn’t think much about it. Completely stopped in the middle of the road and had little to no power from the transmission to the truck to move off of the road. My truck is currently in an auto repair shop waiting on a new transmission to be installed. I had it towed to an independent auto shop from where it stalled. There were not warning lamps or anything at the time of my transmission quitting. Truck started to run rough and shifting hard this summer but without warning lamps I didn’t take it anywhere. When running on the interstate it was shuttering which I thought was due to possible tire out of balance. It would also hesitate to take off when put into drive. It had several of the same issues that Chevy had on other transmissions that were recalled within this same time frame.

    Source: NHTSA WEB SITE
  • 2020 CHEVROLET SILVERADO 1500
    - Elkmont, AL

    The Engine began to make a knocking noise at ~62000 miles on the odometer. I assume it was bearing failure. MURREY CHEVROLET GMC diagnosed the problem as catastrophic engine failure with the repair being a replacement of the engine. There were no warning lamps. This is a 2020 Chevrolet Silverado High Country with the 6.2L engine.

    Source: NHTSA WEB SITE