2011 CHEVROLET SILVERADO 1500 Complaints

The contact owns a 2011 Chevrolet Silverado 1500. The contact stated that while driving at an undisclosed speed, the brakes seized. The vehicle was not diagnosed nor repaired by an independent mechanic or the dealer. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline to file a complaint. The failure mileage was approximately 76,000.

Frame has excess rust due to inferior undercoating. This was pointed out to me at the last 2 oil changes at the dealer. Truck is currently available to be inspected.

The frame and cross member that holds fuel tank have rusted to the point of failure. It is available for inspection. Safety hazard exist when the the vehicle become uncontrollable and also when fuel tank comes loose possible ignition if fuel. Have not reproduced or been inspected. Frame rusting to failure is a known issue with these trucks.

The worst problem I have with this vehicle is that it will cut power to propulsion without any warning. I was driving down a suburban roadway, not on the freeway, thank God. When the truck's automatic gear shift wouldn't engage, I went from going 30 mph to 5 mph in seconds. The accelerator pedal wouldn't respond, I managed to coax my truck into a parking lot and restart the engine. Other times the head lights will not come on. Just today, I turned on the left turn signal and the Stabilitrack warning light came on, plus the radio made a brief noise of static. This particular issue appeared and disappeared in one second. I'm concerned that these problems are a manufacturer's mistake, and I want it fixed as soon as possible. My mechanic has tried repeatedly to find the cause but has been unsuccessful.

2011 Chevrolet Silverado Frame is disintegrating, cross member rusted apart from shock bracket. Truck is deemed dangerous to drive. Will have to get another vehicle.

While driving, all the sudden my check engine light came on (flashing), and my stabilitrack light came on. The engine started running really rough, and lost power. It is like major misfire. Upon reading up on this, it is a problem with this type engine. I saw about 2000 people with the same issue. Nothing works to resolve this problem. Coils, plugs, and wires were replaced, and still the same.

Rear fenders completely rotted through. Was told by certified auto technician that the amount of corrosion will not pass Massachusetts Vehicle Inspection. This is a massive problem for 2011 Chevrolet Silverado. The manufacturer used poor quality material in the rear quarter panels and should be held responsible.

The contact owns a 2011 Chevrolet Silverado 1500. The contact stated that he purchased the vehicle aware that the vehicle was included in NHTSA Campaign Number: 21V054000 (Air Bags) however, the front passenger’s side air bag, traction control, and stabilizer control warning lights were illuminated. The vehicle was not diagnosed or repaired. Neither the dealer nor the manufacturer was notified of the failure. The failure mileage was approximately 125,000.

The contact owns a 2011 Chevrolet Silverado 1500. The contact stated that following a state safety inspection, the vehicle was failed due to the frame being severely rusted. The contact stated that there was a hole on the subframe on the driver’s side large enough for a hand to go through the hole. The contact had not taken the vehicle to a local dealer or independent mechanic. The vehicle had not been diagnosed or repaired. The manufacturer had not been informed of the failure. The failure mileage was 105,482. The contact stated that they welded up the frame of the vehicle themselves and had the vehicle inspected.

Today I rear ended a car with the 2011 Silverado. The drivers airbag in the steering wheel did deploy but not fully, never made contact with me at all. I have kept the truck updated with any recalls done.