2018 CHEVROLET SUBURBAN Complaints

The contact owns a 2018 Chevrolet Suburban. The contact stated that while starting the vehicle, the engine experienced rough idling. Additionally, the engine also made rattling sounds while driving with the check engine warning light illuminated. The vehicle was taken to the dealer and two other dealers, Penske Chevrolet of Cerritos (18605 Studebaker Rd, Cerritos, CA 90703) and Camino Real Chevrolet (2401 S Atlantic Blvd, Monterey Park, CA 91754); however, all three dealers were unable to duplicate the failure. The vehicle was not repaired. Upon investigation, the contact related the failure to the Active Fuel Management (AFM). The manufacturer was made aware of the failure but refused to buy back the vehicle. The failure mileage was approximately 60. The VIN was unavailable.

Had to replace transmission at 103000 miles. Regularly maintained no harsh driving. No warning signs it was going out till it happened

Vehicle first start sometimes when pushing the start stop button. Dash illuminates but then goes black as if no power. P129D code appears after being able to start.

The 2nd row of the vehicle has 2 captain chairs and both seatbelt retractors failed.

Rim corrosion resulting in loss of air pressure. The inner portion of the rim is corroding causing the tires to loose pressure. Depending on the amount of corrosion this could lead to a catastrophic failure at some point due to sudden loss of pressure. I took my vehicle to a tire shop thinking there was a puncture causing it to loose pressure. The manager explained to me that the pressure loss was due to corrosion of the alloy rim and that it is common with Chevrolet vehicles with factory alloy rims. The only solution to the problem is to have the rims possibly refurbished or replaced.

I bought this vehicle in January 2019 . I had to have the AC worked on in April 2021. I was advised that the year 2017 had a recall on the same is mine is having… now in 2024 my AC has to be fixed again for the same thing … this is not a cheap fix. It should be under a recall .. please if u can help in any way i would very much appreciate it.. thank u

The Trailor brake system, engine light, stabilitrak control system and antilock brake system is on due to the wiring of this vehicle.

Car abruptly lost power while driving causing rapid deceleration and requiring immediate action to steer vehicle off the active roadway without hitting other vehicles or causing property damage. There were no warning lights or signs until this occured. The vehicle was later towed to chevrolet who informed us that this was a KNOWN ISSUE these cars have where their "lifters fail and sometimes even damage the camshafts" If this was a known issue why would it not have been addressed in a recall. After speaking with the dealer I searched the internet for the same issue and it is widespread across several GM cars including mine. GM now wants $3,100 to repair a dangerous manufacturer defect.

TECHNICIAN - Was unable to perform test drive of vehicle. Inspected operation & found; Vehicle will not turn over, battery very weak. Removed battery, put on charger for approximately 45 minutes. Reinstalled battery. Vehicle had power but did not start. Was unable to get shifter into neutral. Found engine still not turning over. Found starter motor making clicking sounds. Got to turn over once but was very labored, but did not start. Disconnected shift cable at transmission and rolled vehicle into shop for diagnostic. - Scanned computer control modules & found; Approximately 30 codes total in multiple modules, with high and low voltage codes. - Inspected & found; Performed basic electrical faulty tracing. Performed battery test, voltage was low at 16%.Battery(new FY22) failed load test. Found starter making "thunking and clicking" sounds. Unable to move shift lever out of park position. Let battery charge an additional 1 hour and found battery failed testing. Tester states "short" which indicates internal failure. Tested starter draw, found excessive draw at 400amps, spec is 70-120amps. After testing tried to start. Engine turned over slowly for approximately 1 second and then made clicking sounds. Found body module voltage codes returned. Verified engine does turn over when manually turned with breaker bar. FURTHER SHIFT LOCK ISSUES OR OTHER ISSUES. Technician removed and replaced the starter assembly and the battery. Found engine started up and ran. Verified repair. Found shift lock still not working. Shifter will not leave the park position. Performed testing. Verified transmission will shift to drive and to reverse. Verified brake switch working properly and sending signal out to ABS module. Verified shift cable not frozen. Found no fault tracing available for this type of shift lock. Eliminated other possibilities which indicates the issue is with the shift lock actuator/gear shifter. Determined/Suspect; The shift lock actuator/gear shifter is faulty.

9/29/22 (123k miles) TECHNICIAN: - Test drove vehicle, inspected transmission operation & found gear train noise / L3, in approximately 1st through 3rd gears. Tach was jumping up to about 200 rpms when converter locked up and then would go back down. Monitored on scanner and found converter slipping in and out of lock up. - Scanned computer control modules & found no codes. - Inspected transmission fluid level & condition, found transmission fluid was full and red, note; customer noted fluid was changed recently and was dark and burnt with metal shavings in it during the change. (photo of metal shavings). - Inspected exterior of transmission for leaks & damage, found no leaks or damage. - Determined there is a lack of lockup pressure or hydraulic pressure and internal damage to the transmission assembly. - Recommends replacing the transmission assembly with a unit with an improved torque converter. (We replace).