2007 DODGE CALIBER Complaints

VERY BAD DESIGN OF MUFFLER. IT IS VERY DANGEROUS. THE MUFFLER HAS A HOLE ON TOP. THAT HEAT EFFECT THE BATTOM TRUNCK, THE HOOD GET MELTED, HEAT SHEILD GET BURNED AND THE ROAD ASSISTANT TIRE GET MELTED AS WELL. I WAS LUCKY I WAS ABLE TO SMELL IT. ALSO ALL BODY GET VERY RUSTED AND LOOK HOURRIBLE.

The contact owns a 2007 Dodge Caliber. The contact stated that after driving approximately a block from her residence, she noticed that the vehicle was unable to exceed 15 MPH while accelerating. The contact stated there was no warning light illuminated. The vehicle was driven back to her residence and then the vehicle was towed to an independent mechanic. The contact stated that the vehicle was diagnosed, and she was informed that the intake manifold needed to be replaced. Additionally, the vehicle subframe was rusted. The contact stated that she was informed of an unknown recall however, she was informed that the VIN was not included. Neither the dealer nor the manufacturer was notified of the failure. The approximate failure mileage was 79,000.

Rear subframe is badly rusted making the vehicle unsafe to drive. Don’t know how long it been like this, just noticed it while doing brake work. I’ve owned the car since 2008 and was never notified of the extended warranty.

The contact owns a 2007 Dodge Caliber. The contact stated while driving at various speeds, the front end of the vehicle emitted abnormal sounds and the vehicle was vibrating. The vehicle was taken to an independent mechanic where it was diagnosed that the front passenger's side and the front driver's side tires were wiggly and the front lower ball joints had failed. Additionally, the independent mechanic diagnosed that the front subframe was severely rusted and had a hole. The vehicle was then taken to another independent mechanic who diagnosed that the rear subframe was severely rusted as well. The vehicle was not repaired. The dealer and the manufacturer were not notified of the failure. The failure mileage was approximately 133,000.

I had brought my 2003 Stratus and 2007 Caliber in to the dealership for their 3000 mile oil change and check-up. When the Stratus was done, I switched it out with the Caliber. The receptionist came into the waiting room to inform me that my vehicle was dangerous to drive. The engine cradle had rotted out. The manager had asked her to tell me: "If you hit a big bump, your engine could fall out." She showed me a picture of the area in question. I asked what I was supposed to be looking for and was shown where the cradle was supposed to be. A post-it note was on the picture saying that the manager "will do some pricing". The invoice states: "We question the structural integrity of it being able to hold up much longer." When I did not hear anything for a few weeks, I called in and was told that it had not been done but the manager would get right on it. I had asked the manager how this could have been missed during all the years I had been bringing it in for any kind of maintenance and was told: "It probably looks worse that what it should because I poked it with a screwdriver a few times to see how bad it was." Invoice total: $1884.20. I have since spoken with a general manager for Magna Corporation who produced the cradle for the Caliber. They were aware of the design flaw of the cradle that did not allow for drainage of water/road chemicals from the cradle. A lawsuit was filed by Magna against Dodge which Magna won. The particulars of the lawsuit were not made known to me other than Magna charges $42 for the cradle, but I was billed $859. I have found numerous customer complaints online over the corrosion of the cradle in other Dodge model years as well. The 2007 Caliber seems to have more overall customer complaints that all othe model years combined.

My throttle body keeps going in and out which cause me to have to get an alternator replaced twice plus a crankshaft twice. Now my car is smoking which is the valve cover gasket . Also my car lights went out one at a time so my driver side lights wnt work at all in the front and the passenger side front won't work just my signal on the passenger side. Also my dashboard won't work properly it keeps goin on and off as I turn on other lights in my car . When I signal left my car light on the roof comes on. I spent $12000 on this car from a dealership and have done nothing but put money into it more than I paid for it.

Bought the car 04/21 had throttle issues the dealer replaced it kept noticing after that i was still having problems with car take it to tire shop entire buttom of car is rusted needs new sub frame sway bar lower arms was very dangerous deiving car want stay straight

Passenger side headlight and driver's side tail light not working. Bulbs have been replaced and tested as to being good. Went on internet and found this to be a very common problem with Dodge and Chrysler vehicles, many times requiring replacement of the TPIM. Grounds have been checked as good. Dealer says repair requires replacement of the TIPM for $1,600.00!! Vehicle lighting are safety items covered by vehicle laws. These are safety issues and customers should not be held hostage for ransom for their poor design. Dodge and Chrysler should be replacing these TIPMs when they start failing without cost to customers.

Both front and rear subframes have been replaced due to excessive dangerous rust. Also rear trailing arms were replaced due to the same issue. Many other components were replaced as well due to bad bushings. Had to drive the vehicle on the highway to get it home and was lucky to make it. Vehicle did not move after that for almost 2 months until the parts could be replaced. Stalantis received a claim from me in regards to the issues however they were not willing to proceed any further with any actions. These claims need to be looked into because there are quite a few instances that are posted online with videos and or user blogs that are describing similar incidents with Dodge calibers. Someone is going to get hurt from this rust issue. Not everyone is mechanically inclined and it will only take one incident and someone will get hurt or maybe even kill not to mention other people that are on the road who are innocently driving and other vehicles. Chrysler new this wasn't issue and has failed to take care of it completely. I have spent quite a bit of money to replace these parts as to make my car safe for my child and myself and my girlfriend. There needs to be a final recall just like there was and still is on airbags. You have a dangerous problem that needs to be taken care of. Please Force stalantis to recall and or compensate all owners who have these vehicles. I have included three pictures of just the front subframe. I have kept the subframe in the front and the rear and the trailing arms. If pictures are needed please let me know.

The contact owns a 2007 Dodge Caliber. The contact stated that while driving at an undisclosed speed, there was an abnormal sound coming from the rear passenger side. The contact looked in the rearview mirror and saw sparks coming from the rear passenger side. The contact pulled over, and upon inspection, the contact noticed that the rear passenger's side tire was inward and the cross member was corroded. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The contact related the failure to TSB Number: 23-012-14 Front And Rear Crossmember Corrosion (X58 10 Years Unlimited Mileage). The failure mileage was unavailable.