2010 DODGE CHALLENGER Complaints

Was driving and a tick was present then over heated sat on side of road until cooled down added coolant drove home . The next day car was drivable. Drove to school and car was sounding funny so took it to a repair shop and they told me the particular engine in the vehicle has a fuel efficient component where it shuts down the cylinders on the freeway, and the lifters are supposed to open, but our lifter did not open. It got stuck and grind the camshaft in the motor. Needless to say I had to have the car towed home. It’s just sitting in my parking lot. I tried calling Dodge. They wouldn’t help me. I tried calling multiple agencies to help. I looked up on the Internet and there is multiple complaints about the same problem it’s called the hemi lift so hopefully one day this can be recalled because I’m still paying on the car. I had a year and a half. No one will help me. My kids were driving the car. What if the thing blew up on them on the freeway and somebody hit them because Car wouldn’t move anymore . Or if they were taking the car through the desert and there is no phone calls and no one around. If they were going around corners of a mountain and just stopped on them or blew up because can’t drive the car anymore. very bad and scary and sad that the builder of that motor won’t fix their mistake and leave countless people stranded and in a predicament

The contact owns a 2010 Dodge Challenger. The contact stated that upon starting the vehicle, there was an abnormal sound coming from the instrument panel. The vehicle was taken to a dealer where it was diagnosed that the instrument panel was damaged and needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The contact stated that the battery was replaced. The contact had received notification on NHTSA Campaign Number: 16V352000 (AIR BAGS). The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was 185,000. Parts distribution disconnect.

I need to address a serious issue regarding the car I purchased in 2020 from a private vendor. Upon taking the car to Crown Dodge Dealership in Ventura County for repair, I had to pay roughly $700 out of pocket for the service and rented a car from Hertz for the days I was without my car. However, upon receiving the car back, it still had unresolved issues with the electrical components and dashboard noise. It is unacceptable that the manager at the dealership did not prioritize my safety or the quality of the car I purchased. Since this car is my sole mode of transportation, I demand a prompt resolution to this matter. I expect immediate assistance in addressing these concerns. Thank you.

Was driving normally going 65 mph on the highway when white smoke was emitting from inside the steering wheel. Between the dashboard and steering wheel. Engine was fine and no warning lights came on. Everything ran great except for the white smoke. I don’t know what it could be. Luckily it didn’t catch on fire

I experienced a catastrophic timing chain failure despite prior recall work being performed by Dodge that supposedly resolved their known timing chain issues with the 5.7L hemi with automatic transmission. This failure occurred without any prior warning at a cruising speed of about 65 MPH rendering the car undrivable. There were no warning lights, drivability issues, or signs of the impending failure. This is a well-maintained car with only 80,000 miles, never missing a required oil change and other maintenance tasks. Timing chains should not fail at such low milage - indeed, timing belts will last longer before they fail. This failure occurred on a major highway placing me and other motorists in danger from the car being unmovable and potentially causing a high-speed collision on a 70 MPH highway. If this had occurred less than 0.5 miles down the road, both shoulders of the roadway were closed due to road widening construction. A certified letter with pictures of the timing chain and timing chain guide failures with a receipt for associated repairs was sent the to the manufacturer in December 2023 but they have not given me the courtesy of a reply. The engine was replaced by an independent mechanic at an out-of-pocket cost of $13,217.38 and the pictures were taken at that time by the repair shop.

The contact owns a 2010 Dodge Challenger. The contact stated that while driving at an undisclosed speed, the vehicle lost motive power and stalled. Additionally, the low engine oil warning light was illuminated. The contact stated that the failure had reoccurred approximately three or four times. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 40,000.

ABS Module Failure. All repair parts discontinued from 2008-2014 for Manual Transmissions. Safety issue will not allow operations of Anti lock brakes

The Gen III hemi has an inherent design flaw in which the rollers making contact with the camshaft will fail, causing damage to the camshaft and causing the engine to misfire. This is due to the camshaft being moved away from the crankshaft as it causes oil starvation. After extensive research it appears to affect cars of various miles and workload. There is no single cause that makes this happen other than a grievous design flaw. The main complaint is that you experience total power loss at higher revs, making it dangerous to drive on the interstate or attempting to merge into traffics as the engine begins to shudder and lose most power. Whether it’s 40K miles or 110K miles, the flaw does not discriminate. After numerous attempts to reach Chrysler technical service on how to prevent this, I’ve been ignored and case numbers deleted. Now this is very important. This causes a misfire which not only destroys catalytic converters, but arrives with no notice. It’s very possible someone may be attempting to pass someone on the interstate and suddenly lose power. My mechanic inspected it and confirmed that the rollers failed, causing causing lifters to not make proper clearance. This needs to be investigated as this engine is in millions of cars. And even if 1% of these failure occur on an interstate, the potential for fatalities is absolutely nothing to ignore. I kindly ask that this matter be investigated. As not everyone can afford the 5K to fix this problem like I can. And due to its high prevalence in trucks, this could cause those who use their trucks for work to be put in a tight spot. I understand normal wear and tear, but by no means should a cam and valve train fail this soon in a car. Giving the Gen III hemi by Chrysler and their infamous timing chain defect, I believe this is also a dangerous flaw and something Chrysler ignored. Hoping it would outlast warranties. Best regards.

The contact owns a 2010 Dodge Challenger. The contact stated while driving at an undisclosed speed, the tire sensor, battery, and check engine warning lights were illuminated. The vehicle was taken to an independent mechanic and diagnosed as a powertrain control module failure, which caused the battery and alternator to fail. The mechanic informed the contact that the powertrain control module needed to be replaced. The dealer was made aware of the failure and referred the contact to the manufacturer. The vehicle was not repaired. The manufacturer was made aware of the failure and referred the contact to file a complaint with NHTSA. The failure mileage was approximately 57,000.

Car stall no warning lite. Car has stalled when driving on the freeway, when exiting the Freeway as well at making turns. This has been happening for about 3 years. Seems to only happen during the summer months. The dodge dealership said that they would not be able to identify the problem unless a warning lite was on or they test drive and it happens. The problem doesn't happen all the time it's sporadic.