2009 DODGE RAM 1500 Complaints

The brakes locked up twice since purchased the vehicle. The left side locking up would have caused me to veer into oncoming traffic. Years late when the right side locked up would've have veered right causing an accident. This last time the brakes aren't releasing. This happening 3 times has reproduced itself. The 1st time I took it to a dealership. No warning lamps were showing or any symptoms for this happening. I've purchased the lifetime warranty on this vehicle.

The rear axle pinion nut came off and the rear axle locked up. Driveshaft dropped to the street, breaking the transfer case. Incident resulted in an immediate loss of control. Driver behind me saw the driveshaft fall and braked to avoid contact with my vehicle. Luckily, I was driving about 25 miles per hour and was able to come to a stop on the roadside without wrecking. I later learned that in late 2015, Chrysler was supposed to notify owners of the defect concerning the rear axle pinion nut. I never received that notification or any other recall notice regarding my vehicle. The local Dodge dealer has told me to have my vehicle towed to them. They said the damage will be evaluated and Chrysler will determine if they should pay for the necessary repairs. I believe they should, since I was never notified of the problem with the rear axle pinion nut. The consumer stated the District Manager at the dealership refused to repair the vehicle. The reasons for not repairing the vehicle were the necessary parts couldn't be found, the recall was too long ago, and you should have brought it in for repairs earlier when the recall notice went out.

The contact owns a 2009 Dodge Ram 1500. The contact received notification of NHTSA Campaign Number: 18V160000 (Fuel System, Gasoline). The contact stated that the sub frame was rusted. The vehicle was taken to the dealer and to Hudson Chrysler Jeep Dodge RAM (625 NJ-440, Jersey City, NJ 07304) on two separate occasions and the dealers declined to perform the recall repair because the sub frame was rusted. The manufacturer was made aware of the failure and informed the contact that he was responsible for the sub frame replacement. The failure mileage was 165,851. Case number [XXX] . INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).”

HAD TRUCK IN FOR SERVICE AT THE LOCAL DODGE DEALERSHIP. WAS INFORMED THAT THE FRAME WAS SEVERELY RUSTED THROUGH AND WAS UNSAFE TO DRIVE. THE TRUCK HAS 80,000 MILES ON IT GARAGE KEPT. THIS SHOULDN'T BE HAPPENING ON A 12 YEAR OLD VEHICLE. CONTACTED DODGE AND WAS ASSIGNED A CASE NUMBER 79046014. HOWEVER I WAS TOLD BY THEM SORRY FOR YOUR BAD LUCK. NOTHING TO BE DONE HERE. I FIND THIS UNACCEPTABLE. THANKS FOR ANY HELP

TL* THE CONTACT OWNS A 2009 DODGE RAM 1500. THE CONTACT STATED WHILE DRIVING 30 MPH, THE VEHICLE LOSS MOTIVE POWER AND STALLED. THE CONTACT HAD THE VEHICLE TOWED TO BLUEBONNET CHRYSLER DODGE (547 S SEGUIN AVE, NEW BRAUNFELS, TX 78130) TO BE DIAGNOSED. THE CONTACT WAS INFORMED THAT THE FAILURE WAS AN ELECTRICAL FAILURE AND AN UNKNOWN MODULE FAILURE. THE VEHICLE WAS REPAIRED HOWEVER, THE FAILURE RECURRED AFTER SEVERAL MONTHS. THE VEHICLE WAS TOWED BACK TO THE SAME DEALER HOWEVER, THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 198,000.

IN 2020 MY 2009 DODGE RAM 1500 4X4 BEGAN CHUCKING AND LURCHING WHEN CORNERING. I PARKED THE TRUCK AT HOME AND HAD IT TOWED TO THE SHOP. THE MECHANICS PULLED THE REAR AXLE APART AND FOUND SHAVINGS AND LARGE CHUNKS OUT OF THE PINION GEAR AND SUBSEQUENTLY MANY OF THE OTHER GEARS AND COMPONENTS IN THE REAR AXLE. THE MECHANIC SAID I WAS LUCKY IT DID NOT LOCK UP WHILE DRIVING. BEING THAT I PURCHASED IT USED DODGE DID NOTHING TO HELP ME. MY AFTER MARKET WARRANTY WAS OUT, SO I HAD TO PAY OVER $2,200 OUT OF POCKET TO HAVE IT REBUILT BECAUSE DODGE STOPPED MANUFACTURING THE AXLE ASSEMBLY OF THE 3.92 GEAR RATIO. I GOT IT BACK AND DROVE IT MINIMALLY FOR THE PAST SIX MONTHS. TODAY 3/16/2021 I DECIDED TO DRAIN AND REFILL THE REAR AXLE WITH THE SPECIFIED DODGE LUBRICANTS. WHILE DRAINING THE AXLE FLUID I FOUND A SHARD OF METAL APPROXIMATELY 1" X 1/8" X 1/16". VERY DISAPPOINTED. NOW I AM LOOKING AT ANOTHER $2,200 REBUILD AND THE LOSS IF MY VEHICLE AGAIN FOR SEVERAL WEEKS. THIS IS A SAFETY ISSUE AND DODGE NEEDS TO ISSUE A RECALL TO ALL DODGE OWNERS WHOM THIS AFFECTS, NOT JUST ORIGINAL OWNERS. I HAVE REPAIR RECIEPT DUCUMENTATION IF NEEDED.

THE KEY FALLS OUT OF IGNITION WHILE DRIVING ,ALSO THE SHIFTER CAN BE MOVED WITHOUT KEY IN IGNITION IT IS THE SAME PROBLEM AS 10V200000 RECALL BUT MY TRUCK ISN'T INCLUDED IN RECALL SEARCH BUT IT SHOULD, I KNOW DODGE RETOOLED IN THE MIDDLE OF THE 2009 YEAR AND THE PARTS ON MY TRUCK MATCH A 2010 YEAR MODEL FOR WHICH THE RECALL IS INTENDED.THIS IS A DANGEROUS SITUATION THAT ISN'T BEING ADDRESSED BY SEEMINGLY A CLERICAL ERROR.

WHILE DRIVING MY TRUCK IT JUST SHUT OFF, DIED AND WOULD NOT START BACK UP. THIS WAS VERY DANGEROUS! GOING 65 MILES AN HOUR, IN THE CENTER LANE TRYING TO GET OVER TO THE SIDE OF THE ROAD...SAFELY! I TRIED TO START THE TRUCK...EVERYTHING CAME ON AS NORMAL, BUT WOULD NOT CRANK. I HAD TO HAVE THE TRUCK TOWED $$. THE ALTERNATOR WAS REPLACED $$. TRUCK STILL WOULD NOT START. IT WOULD NOT CRANK, YOU COULD HEAR CLICKING UNDER THE HOOD AND YOU COULD HEAR THE FUEL PUMP COME ON. I WAS TOLD IT WAS THE WIN MODULE WHICH COST ME $870.00!! (WIN MODULE AND PROGRAMMING) EVIDENTLY THIS IS A COMMON PROBLEM WITH DODGE TRUCKS. WHAT DOES IT TAKE TO HAVE A RECALL ON THIS PART?!! DOES IT TAKE A CERTAIN NUMBER OF CRASHES OR DEATHS? ALL IN ALL IT COST ME ABOUT $1500, BUT IT COULD HAVE COST ME MY LIFE, MY GIRLFRIENDS LIFE, AND POSSIBLY PEOPLE IN OTHER VEHICLES THAT WERE DRIVING AROUND ME. I HAVE RESEARCHED AND FOUND THAT OTHER DODGE VEHICLES WERE AFFECTED WITH THIS FAULTY PART AND THERE WAS A RECALL PUT OUT. THERE AGAIN, I ASK DODGE....WHAT DOES IT TAKE TO HAVE A RECALL ON THIS PART FOR RAM 1500 TRUCKS?? I HOPE THAT ALL OWNERS THAT HAD OR IS HAVING THIS PROBLEM TO FILE A REPORT! PLEASE! READ ALL THE DISCUSSIONS SIMILAR TO MINE ON DODGE FORUM. AGAIN, PLEASE REPORT THESE TYPES OF PROBLEMS, THEY WILL NOT KNOW HOW MAY VEHICLES ARE AFFECTED IF IT'S NOT REPORTED. YOU MAY SAVE SOMEONE'S LIFE.

THE VEHICLE DIES AND EVERYTHING BECOMES DISABLED INCLUDING ALL OUTSIDE LIGHTS INCLUDING THE EMERGENCY FLASHERS. ENGINE TURNS OFF AND THEN WILL NO RESTART. SOMETIMES THIS PROBLEM IS INTERMITTENT BUT LATER COMPLETELY FAILS. THIS IS THE SECOND TIME IN 2 YEARS THAT THIS TRUCK HAS DIED. THE FIRST TIME IT HAPPENED ON A FOGGY NIGHT. TH ENGINE AND ALL LIGHTS TURNED OFF AT CRUISING SPEED LEAVING ONLY SOME INSTRUMENT CLUSTER LIGHTS ON WHICH ENDS UP BEIN EVEN MORE OF A DISTRACTION FROM THE SUDDEN OUTSIDE DARKNESS. AFTER TRYING TO FIND THE SIDE OF THE ROAD IN THE DARKNESS, THEN YOUR EMERGENCY FLASHERS DO NOT WORK LEAVING THE TRUCK JUST A DARK TARGET IN THE ROAD. THIS IS EXTREMELY DANGEROUS. RECENTLY THIS SAME TRUCK DIED A SECOND TIME BUT THANKFULLY AFTER FILLING UP A A GAS STATION. AFTER A QUICK SEARCH ONLINE, THIS HAS HAPPENED TO MANY MANY DODGE RAM OWNERS FROM 2009 TO 2016 MAYBE NEWER VEHICLES AND ALSO OTHER MODELS. THE DEALER REFERS TO THE PROBLEM BEING WITH A TOTALLY INTEGRATED POWER MODULE (TIPM). I JUST READ THAT THERE HAVE BEEN MANY COMPLAINTS FILED ALREADY EVEN WITH THE NHTSA. PLEASE CONTINUE TO INVESTIGATE, THIS IS A MAJOR SAFETY ISSUE.

CLICKING NOISE UNDER DASH EVEN WHEN THE TRUCK IS OFF, NO HEAT, STEAMING UP WINDOW, CHECKED HEATER CORE AND ITS GOOD HAD THE WHOLE SYSTEM FLUSHED. STILL NOT RITE. ALSO CRUZE CONTROL NOT WORKING.