2002 DODGE RAM 1500 Complaints

I bought this truck new I still own problem is the cooling system does not function properly I have put new radiator and all heat and cooling in it the heat and air does not operate properly I have talked with crysler several times and they will help with issue it’s been like this about as long as I have had it please help me and there’s a whole lot more people with same issue and it’s a very bad problem with the windshield keeps fogging up can not see the road or traffic

Dodge Ram 2002 ABS brake module failure. No recourse for repairs. Dodge has rendered this part obsolete and although they have the technology to repair or replace it they neglect to help thousands of vehicle owners.

The contact owns a 2002 Dodge Ram 1500. The contact stated that while driving at an undisclosed speed at night, he became aware that the external lights and turn signal lights were not functioning properly. The lamp out warning light was illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was unknown.

The heat stopped working so i replaced the blower motor and blower relay the heater switch and still have no heat. The wire gets hot to the touch. The heater only use to work on high then all of a sudden it just stopped all the way around

To put it as simple as I can describe it is a death wobble. that occurs every time you hit a bump in the road, hole, or pot hole. This truck has always had this death wobble from factory. The reason why this is a safety issue is because it causes the steering wheel to go out of balance and go into other lanes in the road and potentially cause an accident.

The contact owns a 2002 Dodge Ram 1500. The contact stated while attempting to turn on the heat in the vehicle, the HVAC system failed to operate as needed. The vehicle was taken to the dealer and the contact was informed that the instrument panel needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and stated there was no recall for the failure. There was no additional assistance provided. The failure mileage was 50,000.

I was driving on the highway at about 65mph and at first I noticed that it felt like my tie rod ends were going bad. And then all of a sudden I felt an explosion and my truck made a sharp right dive into the right hand lane and caused the car in that lane to swerve right. I was then able to gain back control and gradually came to a stop on the right hand berm of the highway. The right rear tire appeared just as it does in the attached photos. The tire size is p264/70R17 no authorities were notified and the tire has not been inspected by anyone.

While traveling at normal speeds approximately 40 mph a car ran a stop sign I t-boned them on their passenger side with my front end I hit them at approximately 40 mph my airbags did not deploy my face and chest hit the steering wheel and dash

Pinion nut became loose. It was caught before it totally fell off, however if it did fall off the rear axle could possible seize up and cause loss of control of the vehicle. This is a 2002 Dodge Ram with the 9.25" rear axle and they appear to still have issues to this day with that axle model. The recall Dodge had in 2009/10 does not even begin to cover the number of Dodge Ram/Dakota vehicles with this issue. The axle in this vehicle was replaced in 2009 for another issue with an axle retainer clip falling off and causing the internal assembly to grind on the boss for the axle. So as the original owner, and with only 137,140 miles on the vehicle in 19 years, it has had multiple problems fixed under warranty, including total axle replacement and now it will have rebuilt again. There should be a real safety concern for all Dodge pickups with the 9.25" rear axle and a recall for every one of them, not just 2009/10. This has been happening for 20 years. When will NHTSA step up and hold Dodge to task for this issue. Regards, [XXX] Minden, NV INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).

The brakes failed due to corrosion of the brake line from the master cyl. to the LH front brake flex hose. The brake fluid simply came out of the line. There was insifficient fluid pressure to do any wheel braking. Luckily, I had just moved off from a stop and was applying the brakes to slow down on a bend. The corrosion occured under a plastic clip that is there to keep adjacent brake lines from vibrating against each other. The corrosion occured in an area that is not inspectable unless the front wheel and wheel arch cover is first removed.