2001 DODGE RAM 2500 Complaints

THE FUEL LIFT PUMP FAILED WHILE PASSING A VEHICLE, AND WAS ALMOST HIT BY ANOTHER VEHICLE. VEHICLE FAILED WHEN PASSING OTHER CARS OR HEAVY ACCELERATION.*AK *BF *NM

1. THE FIRST INCIDENT, MAY 11,2000 WAS A RECALL FOR THE REPLACEMENT OF THE TRANSFER PUMP DUE TO PREMATURE INTERNAL ARMATURE SHAFT BUSHING WEAR. THIS WAS A RECALL BY DODGE. THE SECOND INCIDENT OCCURRED AUGUST 24,2004. 2. THE FAILURE CAUSES THE VEHICLE TO RUN EXTREMELY ROUGH, AND MAKES THE VEHICLE WAS NOT DRIVABLE. FAILURE AT HIGHWAY SPEEDS WOULD CAUSE A SUDDEN SLOWDOWN OF THE VEHICLE. 3. IN BOTH INSTANCES, THE TRANSFER PUMP HAD TO BE REPLACED. CURRENTLY, THIS VEHICLE ONLY HAS 31,000 MILES ON IT. THE COST TO REPLACE THESE PUMPS CAN BE EXTREMELY EXPENSIVE TO THE VEHICLE OWNER. THIS APPEARS TO BE A SIGNIFICANT PROBLEMS WITH DODGE TRUCKS WHICH HAVE THE CUMMINS DIESEL ENGINE.*AK

REPEATED FAILURES OF DODGE COMMINS DIESEL FUEL LIFT PUMPS AND INJECTION PUMPS MAY LEAD TO ENGINE STOPPAGE AND LOSS OF STEERING AND BRAKES. DODGE WILL NOT ADDRESS THESE PROBLEMS ON 1998 TO 2002 DIESEL ENGINES. *JB

WHILE DRIVING 55 MPH VEHICLE STARTED TO PULLING TO ONE SIDE. HAD STOPPED VEHICLE, CHECKED OUT TIRES AND NOTICED THAT RIGHT FRONT TIRE WAS LOSING AIR, LIKE A SLOW LEAK. PUT AIR IN TIRE AND STARTED DRIVING, BUT TIRE CONTINUED TO LEAK. ARRIVED HOME, TOOK CLOSER LOOK, AND DISCOVERED THAT ALUMINUM ALLOY RIM FROM MANUFACTURER, HAD A CRACK THAT CAUSED THE LEAKING PROBLEM. CHECKED OTHER RIMS AND THEY WERE ALSO CRACKED. HAD NOT TAKEN VEHICLE TO DEALERSHIP.*AK

WHILE DRIVING AT ANY SPEED DRIVER HEARD A LOUD KNOCKING NOISE COMING FROM THE FRONT, AND THE VEHICLE VIBRATED UNCONTROLLABLY. VEHICLE WAS TAKEN TO THE DEALER FOR INSPECTION, AND MECHANIC DETERMINED THAT STEERING COLUMN NEEDED TO BE REPLACED. *AK

I REMOVED THE SPARE TIRE TO FIX A FLAT. IT WAS THE ORIGINAL SPARE AND HAD NEVER BEEN USED BEFORE. AFTER HAVING TIRE REPAIRED I TRIED TO RETURN THE SPARE TO IT'S STOW AREA UNDER THE BED BUT THE WINCH WOULD NOT LIFT IT. IT WILL WORK WHEN THE CABLE DOES NOT HAVE WEIGHT ON IT BUT IT WILL NOT LIFT THE SPARE. THE WINCH APPEARS TO HAVE PLASTIC PARTS. I FEEL THIS COULD BE A SAFETY ISSUE IF IT WOULD FAIL WHILE DRIVING DOWN THE HIGHWAY. *JB

DODGE RAM 2500 SERIES 2001, NUMEROUS PROBLEMS WITH VEHICLE STEERING MECHANISMS. *BF THE CONSUMER STATED HE WAS CONSTANTLY OVERCORRECTING THE VEHICLE LEFT AND RIGHT. THE CONSUMER HAD MANY ALIGNMENTS DONE BUT TO NO AVAIL. IT WAS DISCOVERED THAT ALL THE BALL JOINTS NEEDED TO BE REPLACED DUE TO RUST AND NO LUBRICATION, THE STEERING SHAFT AND TRAC BAR WAS REPLACED AND THE STEERING BOX WAS ADJUSTED. THE VEHICLE WAS TAKEN TO ANOTHER MECHANIC AND IN HIS OPINION ALTERNATE VALVE LOCATED IN THE STEERING WAS NOT PERFORMING AS IT SHOULD, WHEN THE MECHANIC REMOVED THE VALVE IT EXTREMELY BURNT FROM OVERHEATING. THE CONSUMER STATED HE NO LONGER HAS ANY PROBLEMS STEERING THE VEHICLE. *JB

DODGE RAM 2500 SERIES 2001, NUMEROUS PROBLEMS WITH VEHICLE STEERING MECHANISMS. *BF THE CONSUMER STATED WHILE TAKING A 2 MILE DRIVE, HE NOTICE HE HAD TO CONSTANTLY OVERCORRECT TO THE LEFT AND THEN THE RIGHT. THE DEALER REPLACED SEVERAL COMPONETS ON THE VEHICLE TO TRY AND RESOLVE THE STEERING PROBLEM, THE REPLACED ALL THE BALL JOINTS WHICH WERE SEVERELY RUSTED AND HAD NO GREASE, THE STEERING SHAFT WAS REPLACED, THE TRAC BAR WAS REPLACED DUE TO SEVERE MOVEMENT. IT WAS FINALLY DETERMINED THAT A ALTERNATE VALVE IN THE STEERING BOX WAS NOT PERFORMING AS IT WAS DESIGNED TO DO, WHEN THE MECHANIC TOOK THE VALVE OUT IT WAS BURNED FROM OVERHEATING. *JB

FRONT END VIBRATION, AND VEHICLE WILL NOT PASS STATE INSPECTION. THE FRONT BALL JOINTS ARE DEFECTIVE.*AK *TC

THE CONSUMER STATES AT 45,000 MILES THE FRONT UPPER AND LOWER BALL JOINTS NEEDS TO BE REPLACED. THE CAUSE HAS NOT BEEN DETERMINED. PLEASE PROVIDE ADDITIONAL INFORMATION. *JB