2008 DODGE RAM 2500 Complaints

driving down the highway at 70 mph and the drivers door came opened it was caused by a faulty door lock actuator

I want to apologize for the lengthy description but I feel this is quite possibly the most critical area to not be vague in. **This problem occurs every time, NOT an intermittent condition.** REAR SEAT/CENTER SEAT BELT RETRACTOR; will not extend out from the retractor. The belt is locked in the fully retracted (unoccupied) position. The vehicle can be on a flat surface, an incline, or a declined position when this occurs. There's nothing obstructing any part of the belt and retractor. In order to use that position/seat belt, I must repeatedly (sometimes in excess of 20 times) pull the belt in different rates of speed ie. pull the belt very slowly, pull it normally, pull it very fast by basically snatching the belt. I've even tried to help the belt further retract into the retractor by slowly feeding the belt rearward. There's no 1 action that seems to work better than the other. Furthermore, at times, the belt (once able to be used) will not hold its position to keep the occupant from moving forward in a panic stop or even by snatching the belt to check its operation. The buckle does function as designed so this problem is strictly related to the shoulder belt not keeping the occupant secure. Apon visual inspection, there are no noted frays, stains, foreign objects, or signs of attempted (prior) repairs. I also want to note that I am an ASE certified Master Mechanic so I am well versed on the operation, diagnosis and replacement of seat belts/retractors/sinchers buckets etc. I'm asking for assistance by any information you can share with me to remedy this issue. This is my "daily driver" routinely using the back seat for my children. I don't want to replace it with a used part because I believe this is a common issue for this platform vehicle. Thank you for your time and assistance!

The contact owns a 2008 Dodge Ram 2500. The contact stated while driving various speeds, he started to smell exhaust fumes inside the cabin of the vehicle. The contact stated no warning light was illuminated. The vehicle was not diagnosed or repaired. A dealer was not contacted. The manufacturer had not been informed of the failure. The failure mileage was approximately 162,000.

during cold weather - when outside temp is below 30 degrees the wipers will not work. When outside temp is above 30 degrees wipers work. During a snow storm, driving home the wipers stop working and windshield freezes up. I replaced the multifunction switch and the wiper motor and dealer stated that the totally integrated power module could be bad. there is so many complaints about others having this issue. This is a major safety issue. Something needs to be done before someone is killed.

While driving the vehicle suddenly lost engine power and turned off. When this happened the steering column locked. It did not just loose power steering. The column itself entirely locked up. At this point the vehicle had no steering and limited breaking and went off the road. Thankfully it just went into a ditch and no damage was done. The vehicle turned right back on. The next day I recreated the problem on some friends property. I gave the keys in the ignition a small tug and the engine would stop and the steering column would lock. The ignition never rotated out of the on position and the key remained in the ignition. I recreated this probably 5 times and it did the same thing every time. I then brought it to the dealer but they didn't have the parts to repair it so I didn't have them look at it. I had to use the vehicle sooner then they could repair it to pull a camper about 1200 miles. I diagnosed the problem to be the ignition switch. I replaced the switch myself and the vehicle has not had the same problem since. I have given the keys in the ignition the same kind of tug and it is no longer a problem. I do have the switch available for inspection. I personally can totally understand the engine turning off due to an ignition switch failure but I believe the actual steering column locking is unacceptable.

The contact owns a 2008 Dodge Ram 2500. The contact stated while exiting out of the garage, the windshield defroster was activated and there was a loud clicking sound coming from the HVAC system. The contact stated that the HVAC system failed to switch over to the air vents. The contact inspected the vehicle and became aware that the defroster actuator was cracked inside in the vents causing the failure. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 109,000.

TL* THE CONTACT OWNS A 2008 DODGE RAM 2500. THE CONTACT STATED WHILE DRIVING 4 MPH, HE HEARD AN ABNORMAL SOUND COMING FROM THE VEHICLE. THE CONTACT STATED NO WARNING LIGHT WAS ILLUMINATED. THE CONTACT STATED THAT HE ATTEMPTED TO STEER TO THE VEHICLE TO THE RIGHT HOWEVER, THE VEHICLE FAILED TO RESPOND. THE VEHICLE WAS STOPPED IN THE MIDDLE OF THE ROADWAY. THE VEHICLE WAS NOT DRIVABLE. THE VEHICLE WAS TOWED TO HIS RESIDENCE. THE CONTACT CALLED COLORADO SPRINGS DODGE (7455 AUSTIN BLUFFS PKWY, COLORADO SPRINGS, CO 80923, (719)475-8550) AND THE DEALER WAS MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. UPON INVESTIGATION, THE CONTACT ASSOCIATED THE FAILURE WITH NHTSA CAMPAIGN NUMBER: 13V529000 (STEERING) HOWEVER, THE VIN WAS NOT INCLUDED. THE MANUFACTURER HAD NOT BEEN INFORMED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 289,000.

I WAS DRIVING ON I405 IN WASHINGTON STATE TRAVELING SOUTHBOUND WHEN I NOTICED SMOKE COMING FROM MY ENGINE COMPARTMENT...I PULLED OVER POPPED THE HOOD AND TOOK A QUICK LOOK.. I NOTICED FLAMES ON THE LOWER PORTION OF THE MOTOR ALMOST BEHIND THE FIREWALL...CALLED 911...

THE BRAKE LIGHTS COME ON THEMSELVES WHEN THE TRUCK IS COMPLETELY OFF. IT'S INTERMITTENT HOWEVER IT DOES IT FREQUENTLY ENOUGH TO DRAIN THE BATTERY. THE ENGINE LIGHT COMES ON AS WELL HOWEVER IT DOES NOT PROVIDE A CODE TO DETERMINE THE CAUSE OF THE ISSUE.

BRAKE LIGHT AND TURN SIGNALS DO NOT WORK EVEN AFTER REPLACING BULBS, BULB SOCKETS AND MULTIFUNCTION TURN SIGNAL SWITCH