2011 DODGE RAM 3500 Complaints

Seemingly at random whenever the truck goes over a bump at about 25MPH to 65MPH the whole truck will start to shake violently and uncontrollably like an earthquake is happening and the steering wheel will shake back and fourth and not stop until the truck comes to a complete stop. I've had it happen at least fifty to a hundred times since I bought it on 3-6-2026 and it only has 155,000 miles on it. The "Death Wobble has been a known problem on Ram 2500 and 3500 trucks built form 1994 through 2012 according to the internet. Yet nothing seems to have been done to fix it.

At random any time the truck goes over a bump in the road at about 25MPH to 65MPH the whole truck will start to shake violently and uncontrollably like an earthquake is happening and the steering wheel will shake back and fourth and not stop until the truck comes to a complete stop. I've had it happen at least fifty to a hundred times since I bought it on 3/6/2026 and the truck only has 155,000 Miles on it. From what I've read on the internet the "death wobble" is pretty common in Ram trucks from 1994 all the way through 2012 yet Ram hasn't done anything to fix the problem.

A mechanic at professional auto shop diagnosed the failed TIPM. It caused the fuel sending pump in the fuel tank to stop pumping. The truck stalled while driving on the highway leaving me stranded in 2-degree weather. I read online that there was a lawsuit for this issue but don't know how to file to recoup the $1200+ repair bill on top of the $200 cost to tow it to the auto repair shop. There was an electrical draw and emergency flashers randomly turning on causing the batteries to die a month prior to the failure of the TIPM. I did have the check engine light come on when the fuel pump was cutting out and stalling. The truck is currently in the shop, and they ordered a new remanufactured TIPM.

The contact owns a 2011 Ram 3500. The contact stated that the OEM trailer brake controller indicated that the trailer brake was disconnected even though it was attached correctly. The failure occurred while different trailers were hitched to the vehicle. The vehicle was taken to a certified mechanic, but the cause of the failure was not determined. The contact replaced the OEM brakes with new OEM brakes; however, the failure persisted. The vehicle was taken back to an independent mechanic, who diagnosed and determined that there was not enough amp signal to recognize that the trailer was connected. The mechanic attached a magnetic pigtail line with magnets attached to both ends, and the vehicle recognized that the trailer was connected. The cause of failure was found; however, the vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was 145,000.

While driving 70mph on the interstate, the truck randomly shut off. I lost power steering. Luckily I was going straight and there were no curves in the road, and I managed to pull the truck and trailer to the side of the road. All electrical assist, steering and brakes turned completely off, radio turned off, all electrical power was off. The engine shut off as well. As I was pulling over, the electrical turned back on but the engine did not. Once I was stopped, I turned the key off, waited 30 seconds, and then started the truck. It ran fine the rest of the way home, approximately 30 miles. I have not drove the truck since. This has happened 3 times, once parked idling after I pressed the door unlock button and the other time in the middle of an intersection. I took the truck to the dealership, paid for the inspection fee, but they could not recreate or find any wiring problems. It did throw a code when it happened, U0121 (Lost communication with ABS module). The dealer said they had to recreate it to diagnosis. I am fearful if I continue to drive the truck to pull my trailer, this could happen again while I am in a turn and I will not be able to continue to turn or stop the vehicle without electrical assist. Dodge does not seem interested in trying to fix this safety issue.

The contact owns a 2011 Ram 3500. The contact stated that during cold weather, the engine would not heat up properly and hesitated to start. In addition, the contact stated that on several occasions, the heater grid connector on the driver's side melted bolts and wiring that intruded into the engine, causing piston #6 to misfire. The contact related the failure to NHTSA Campaign Number: 23V060000 (Electrical System) however, the VIN was not included. There was no warning light illuminated. The local dealer was contacted; however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 96,000.

The contact owns a 2011 Ram 3500. The contact stated that on several occasions while attempting to make a right turn, the steering wheel seized. No warning light was illuminated. The failure occurred on several occasions. The vehicle was taken to the dealer where it was diagnosed but the cause of the failure was not yet determined. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 20,000.

Coming home at night ran into a horde of bugs, I had just had the wiper reservoir filled. It was empty and I had to stop and wipe my windshield by hand. i looked on line I seen several owners had the same problem this I believe to be a manufactured problem. The dealer wants 400 hundred to replace the reservoir I believe this to be a Chrysler safety problem that has occurring to to many 2011 and 2012 vehicles,

Don’t know, the fireman,said the engine caught on fire, some how look like from on top pointed to the top. I believe I believe it was exhaust? Fire department would write out report and send it to me. Devastated 68+ miles truck was paid off melted the whole front and top of the engine everything down! I want to know what happened?! 2011, dodge ram 1 ton 6.7diesel Cummings ! also melted my boat 2010 nitro Z7 with a 150 mercury bass boat $28,000 boat worth more than that now whet up in value! It had 15 hours only on engine! It’s not completely lost I pray…

I had a recall on the fuel heater plug and took care of the problem a few years back. I noticed today that the plug is leaking fuel and was wondering if the problem was ever fixed or if they used the same recalled parts? Do you ever recall an already recalled part? or do they ever pay for the part if I fix it myself?