2013 FIAT 500 Complaints

Systemic Hydraulic Defect & Safety Recall Circumvention I am reporting a critical safety defect in the clutch hydraulic system of my 2013 Fiat 500 Abarth, which directly mirrors the failures described in NHTSA Recalls 16V-302 and 20V-124. Diagnostic measurements confirm a 1.23mm hydraulic over-travel in the clutch release bearing/slave cylinder assembly. This over-travel causes the diaphragm spring to be over-extended, leading to the catastrophic failure of the pressure plate and subsequent inability to disengage the clutch. This poses an immediate safety risk of vehicle surge or inability to shift gears while in motion. Despite this objective engineering data, Stellantis (FCA US, LLC) Executive offices (specifically Mike Macdonald) have formally refused to perform the safety recall repair, citing my status as the "5th owner" as a justification for exclusion. This represents a willful circumvention of a federal safety recall, as the hydraulic over-travel is a latent design defect present since manufacture and is entirely unrelated to ownership history or vehicle maintenance. The vehicle is currently available for inspection to verify these measurements.

While driving 40mph, pressed clutch and the transmission would not shift into gear. Car began to slow in traffic ans I was unable to accelerate as the clutch would not engage a gear. Mamaged to sagely get iff road. No fluid leaks found. Would shift into gear with car off. Gear selection works, not a shift cable issue.

In June 2025, while driving my 2013 Fiat Abarth at highway speed, the vehicle suddenly stalled without warning. This happened on one of the hottest days of the year with another person in the car, creating a serious risk of a high-speed collision. The cause was later confirmed by a different Fiat dealership: a port in the intake/PCV system had been left completely uncapped after service at a Fiat dealership in 2024. The mechanic who worked on my car apparently believed this was only a “vent” and not part of the vacuum system — a dangerous misunderstanding that allowed unmetered air into the engine. This disrupted the air/fuel mixture and led directly to the stall. I have written proof from the dealership admitting to the “vent” claim. A competent technician should know the difference between a vent and a vacuum port. Returning a vehicle in this condition is negligence and puts lives at risk. The component is still available for inspection, and I have documentation supporting my claims.

Dear NHTSA Office of Defects Investigation, I am filing this formal complaint to report the sale and interstate delivery of a dangerously defective and noncompliant vehicle sold to me by Arlington Auto Group, located at 3621 Columbia Pike, Arlington, Virginia. On [XXX], I purchased a 2013 Fiat 500 (VIN: [XXX] ). The vehicle was delivered to my home in Englewood, Colorado on [XXX]. Within 24 hours of taking possession of the car—and having driven fewer than 100 miles—I had the vehicle inspected by a certified mechanic at The Auto Repair Place in Boulder, Colorado. Their findings revealed multiple severe safety hazards, including: Rear brake pads completely worn to metal-on-metal contact Two bolts missing from the rear passenger wheel A destroyed and leaking turbocharger, which increases the risk of engine failure Inoperable tire pressure monitoring system (TPMS) No Virginia safety inspection documentation provided Additionally, the car had been illegally tampered with to bypass emissions systems, including removal of the catalytic converter and installation of sensor bypass wiring, which also violates federal law and emissions standards. This vehicle was represented as safe and legally operable at the time of sale. However, these issues clearly indicate the vehicle poses a substantial risk to public safety and should not have been sold or shipped across state lines. Request for Investigation I respectfully request that NHTSA investigate this matter for violations of federal motor vehicle safety standards (FMVSS) and to determine whether this dealership has a pattern or practice of selling unsafe or defective vehicles. I am prepared to provide: Full mechanic inspection report Purchase contract and shipping records Photos of the damage and mechanical issues Communications with the dealership and lender Thank you for your time and attention to this serious safety matter. Sincerely, [XXX] [XXX] (303) INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

2013 FIAT 500 - Manual Transmission. The clutch cover diaphragm spring on the vehicle has fatigue and/or fracture. A failed clutch cover diaphragm spring has resulted in the inability to disengage the clutch, or shift gears. There is an inability to disengage the clutch, shift gears. It is potentially available for inspection if needed. This occurred while driving at low speed (thank goodness). The car became stuck in place when the failure occurred (obviously a safety concern). The issue has been confirmed by a professional. The component has been inspected by service technician. There were no warnings (lamps, messages, etc.). I believe this failure is described in Recall S34 (NHTSA), and this vehicle should be included in that recall. FIAT disagrees and has denied responsibility. Can you help?

The contact owns a 2013 Fiat 500. The contact received notification of NHTSA Campaign Number: 16V302000 (POWER TRAIN); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated while driving approximately 30 MPH, the clutch pedal was depressed; however, the pedal was sticking and failed to respond as designed. The contact was almost involved in a crash due to the failure. The contact stated that the vehicle then started operating as needed after the failure. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage 195,000. VIN tool showed no open recall.

The contact owns a 2013 Fiat 500. The contact stated that while driving at an undisclosed speed, the clutch was depressed; however, the vehicle failed to stop as intended. The contact stated that there was a jingling sound coming from the engine compartment. In addition, the contact stated that while the clutch was depressed, the vehicle jerked and then rolled forward. The contact stated that several unknown warning lights were illuminated. The contact stated that the hard braking warning light was illuminated. The vehicle was taken to the dealer and the dealer was made aware of the failure. The contact was informed that parts were not available to repair the vehicle. The contact was fearful of driving the vehicle due to the failure. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The contact received notification of NHTSA Campaign Number: 16V302000 (Power Train); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure and a case was filed. The failure mileage was 90,000. Parts distribution disconnect.

The contact owns a 2013 Fiat 500. The contact stated that while reversing, the vehicle failed to shift into park after stopping. While shifting into gear, the vehicle failed to move after the gear selector was placed in the desired gear. There were no warning lights illuminated. The contact stated that the failure was related to NHTSA Campaign Number: 19V817000 (Power Train). The contact called a towing company. The tow truck driver was able to re-attach the gear shifter cable, but the failure recurred. While reversing slowly to parallel park, the gear shifter cable detached again. The contact reattached the shifter cable. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 128,300.

The contact's daughter owns a 2013 Fiat 500. The contact stated while the vehicle was parked, the convertible sunroof retractor failed to function as intended. The contact stated that the convertible sunroof failed to close as needed. The vehicle was taken to an independent mechanic where it was diagnosed and determined that the convertible sunroof mechanical system had failed and needed to be replaced. The contact was informed that the convertible sunroof mechanical system needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 65,000.

The contact owns a 2013 Fiat 500. The contact received notification of NHTSA Campaign Number: 16V302000(Power Train) however, the part to do the recall repair was unavailable. The local dealer was contacted and it was confirmed that the part was not available. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had experienced the failure causing the clutch to fail. The failure mileage was 103,000. Parts distribution disconnect.