1996 FORD CROWN VICTORIA Complaints

METAL BRAKE LINES ALONG DRIVERS SIDE FRAME RAIL RUSTED THROUGH CAUSING COMPLETE LOSS OF BRAKES.

1996 FORD CP INTAKE MANIFOLD CRACKED AT THE SEAAM.*MR...MANUFACTURER'S RECALL, NO NOTIFICATION. *AK

PLASTIC INTAKE MANIFOLD ON 1006 FORD CROWN VICTORIA VAILED. CALIFORNIA CLASS ACTION SUIT ALREADY IDENTIFIED PROBLEM. FORD HAS FAILED TO NOTIFY CONSUMERS OF POTENTIAL DANGEROUS DEFECT. SEE - HTTP://WWW.LROLAW.COM/MANIFOLDS.JSP.

CRACKED PLASTIC INTAKE MANIFOLD LOST ENGINE COOLANT REPALCED INTAKE MANIFOLD WITH ALUMINUM MANIFOLD I STILL HAVE OLD PART

I HAVE A 1996 FORD CROWN VICTORIA WITH A 4.6L ENGINE. I BOUGHT IT MARCH 16TH 2005. ON MARCH 17TH 2005 I DROVE IT FOR THE FIRST TIME TO WORK. I ACCELERATED TO 70 MPH ON THE US-131. THE INTAKE GAVE OUT AND SMOKED OUT THE ENTIRE HIGHWAY. IT CRACKED ON THE FRONT COOLANT RUNNER OF THE INTAKE MANIFOLD. I WAS ALTE TO WORK AND HAD TO HAVE THE CAR TOWED. I AM GOING TO BE CHARGED ABOUT $600 FOR THE REPLACEMENT INTAKE INSTALLLED. THE MECHANIC TOLD ME THAT THE INTAKES WERE RECALLED, BUT ONLY ON COMMERCIAL VEHICLES NOT PRIVATE OWNED. WHY IS THIS? IS THE PRIVATE CITIZEN NOT IMPORTANT ENOUGH? I AM LIVING FROM PAYCHECK TO PAYCHECK NOW, I CAN'T AFFORD TO HAVE THIS KIND OF WORK DONE. MY INCOME IS LIMITED. I CAN ONLY HOPE I CAN SCRAPE UP THE MONEY, SO I CAN GET TO WORK NOW. NOT HAPPY. I WILL KEEP THE OLD PART.*AK

PLASTIC INTAKE MANIFOLD CRACKED, FIRE HAZARD; MAJOR ENGINE PARTS MADE OF PLASTIC, NOT MADE TO WITH STAND HIGH HEAT TEMPS. REPLACED INTAKE MANIFOLD, ONLY AVAILABLE REPLACEMENT IS PLASTIC AS WELL, WHICH WILL CRACK AGAIN!!!!*AK

WHILE AT WORK PERFORMING AN ALTERNATOR TEST ON A 96 CROWN VICTORIA WITH THE 4.6 ENGINE I WAS RUNNING THE ENGINE AT 2000 RPM. THERE WAS A LOUD POP AND THEN THE ENGINE COMPARTMENT WAS FILLED WITH STEAM AND HOT COOLANT. I WAS ALMOST SCALDED, AS I WAS LEANING OVER THE ENGINE TO ACCESS THE THROTTLE LINKAGE. THE INTAKE HAD CRACKED ON THE COOLANT RUNNER BEHIND THE ALTERNATOR ABOUT 2" WIDE. OUR SHOP HAD TO REPLACE THE CUSTOMER'S INTAKE MANIFOLD AND COULD NOT CHARGE THE CUSTOMER FOR THE PARTS OR LABOR BECAUSE THE CUSTOMER BLAMED US FOR THE DAMAGE. I BELIEVE THAT THE CUSTOMER SHOULD HAVE BEEN INFORMED OF THIS SITUATION BY FORD MOTOR COMPANY AND THE RECALL SHOULD COVER MORE THAN JUST THE "FLEET USE" VEHICLES. THIS IS CLEARLY A PRODUCT DURABILITY/DEFECT ISSUE.*AK

THE BRAKE LINE FROM THE ABS PUMP TO THE RIGHT FRONT BRAKE RUSTED THROUGH WHICH RESULTED IN THE LOSS OF ALL FLUID IN THE MASTER CYLINDER. FURTHER INSPECTION FOUND THE TWO REAR BRAKE LINES ALSO SEVERELY RUSTED. THE LOCATION OF THE FAILURE AND THE EXTENSIVELY RUSTED REAR LINES WAS DIRECTLY UNDER THE MASTER CYLINDER, ON TOP OF THE CHASSIS RAIL. *AK

I OWN A 1996 FORD CROWN VICTORIA LX, ON AUG. 13TH, 2004 THE CAR OVERHEATED. THERE WAS A SMALL CRACK IN THE PLASTIC INTAKE MANIFOLD. UPON INVESTIGATING THIS, IT WAS FOUND THERE ARE NUMEROUS COMPLAINTS BUT FORD ONLY REPAIRED VECHICLES OWNED BY POLICE AND TAXIS. THE COST TO REPAIR THEIR DEFECT IS OVER $800. I BELIEVE US CONSUMERS SHOULD BE REIMBURSED FOR FORD DEFECTIVE PLASTIC INTAKE MANIFOLD. THE RECALL FOR THE POLICE AND TAXIS WAS 01M02. *AK *NM

WHILE DRIVING AT ANY SPEED CONSUMER HEARD A GROANING SOUND. VEHICLE WAS PARKED PARKED WHEN THE RIGHT FRONT END COLLAPSED. A REPAIR SHOP EXAMINED THE VEHICLE, AND FOUND THAT THE LOWER RIGHT BALL JOINTS BROKE.*AK UPDATED 11/18/09. *LJ UPDATED 11/19/09.*JB