1993 FORD F-350 Complaints

WHILE DRIVING THE SERPENTINE BELT SNAPPED OFF. THIS CAUSED THE VEHICLE TO LOSE POWER AND EXTENDED STOPPING DISTANCE. THE DEALERSHIP WAS NOTIFIED, BUT DID NOT RESOLVE PROBLEM. THE CAUSE WAS NOT DETERMINED. PLEASE PROVIDE MORE INFORMATION. *NM

WHILE VEHICLE WAS PARKED A FIRE STARTED UNDER THE HOOD. DEALERSHIP WAS NOTIFIED, BUT DID NOT RESOLVE THE PROBLEM. *AK

THE CLUTCH GOT STUCK IN DRIVE. CONSUMER HAD TO APPLY THE BRAKES IN ORDER TO STOP THE VEHICLE. CONSUMER WAS NOT ABLE TO REMOVE THE GEAR, AND THE VEHICLE IS IN THE SHOP FOR T REPAIRS. *AK

EXHAUST FUMES WERE LEAKING INTO THE CAB OF THE VEHICLE. CONSUMER CONTACTED THE DEALER, WHO DIDN'T THINK THAT THIS PROBLEM WAS IMPORTANT, AND WILL NOT SERVICE VEHICLE IN A TIMELY MANOR. ALSO, CONSUMER ASKED FOR MANUFACTURER'S TELEPHONE NUMBER, BUT THE DEALER REFUSED TO COOPERATE. *AK

SERPENTINE BELT DETACHES FROM TENSION PULLEY AND/OR IDLER PULLEY. DETACHED BELT CAUSES DAMAGE TO TRANSMISSION COOLER LINES, RADIATOR LINES, AND BREAKS IDLER PULLEY FROM BRACKET. POWER STEERING AND BRAKING ARE LOST MAKING VEHICLE VERY DIFFICULT TO CONTROL. FLYING IDLER PULLEY MAY CAUSE ADDITIONAL DAMAGE AND/OR FALLS TO ROADWAY AS HAZARD. DAMAGE TO TRANSMISSION LINES MAY CAUSE FIRE. CAUSED BY UNEVEN WEAR TO THE PLASTIC BELT TENSIONER PULLEY. PLASTIC PULLEY DEFORMS IN SUCH A MANNER THAT THE SERPENTINE BELT TRAVELS FORWARD (TOWARD FAN) AND OFF OF PULLEY. A SIMILAR DEFECT (NHTSA CAMPAIGN NUMBER 96I003000) WAS REMEDIED WITH A VOLUNTARY RECALL BY FORD IN 1996. THIS PARTICULAR VEHICLE WAS REPAIRED TO THAT STANDARD. THE STANDARD APPEARS TO HAVE BEEN INADEQUATE. *AK

WHEN THE VEHICLE IDLED CONSUMER SMELLED AND HEARD EXHAUST LEAKING. DEALER EXAMINED THE VEHICLE, AND FOUND THAT THE EXHAUST GAS RECIRCULATION TUBE (EGR) HAD A HOLE IN IT. *AK

CLUTCH MASTER CYLINDER, PUSH ROD PLASTIC EXTENSION FRACTURED AND BROKE WHILE VEHICLE WAS IN MOTION ON THE HIGHWAY. THE VEHICLE WAS UNABLE TO BE SHIFTED OUT OF GEAR AND WAS UNABLE TO STOP FORWARD MOTION UNTIL THE ENGINE WAS STOPPED. WITH FURTHER INSPECTION OF THE COMPONENT I WAS ABLE TO DETERMINE THAT WEAR AND LUBRICATIONS WILL CAUSE THIS FAILURE. AN ENTIRE ALL METAL UNIT SHOULD REPLACE THIS COMPONENT. VEHICLE WAS AT 150,000 MILES WHEN FAILURE OCCURRED.*JB

WHEN VEHICLE IS BEING DRIVEN THE BELT TENSIONER KEEPS SHREDDING SERPENTINE BELT, CAUSING VEHICLES ENGINE TO DIED. IN ONE CASE THE BELT TENSION SHIERD OFF, SENDING A METAL BOLT FROM ENGINE THAT PUNCTURED RADIATOR FAN. PLEASE PROVIDE ANY FURTHER INFORMATION. MR

WHILE DRIVING CONSUMER TRIED TO PUSH CLUTCH IN THE BUSHING BROKE, AND THE LINKAGE FELL APART, MAKING CLUTCH INOPERATIVE. *AKCONSUMER HAD NOT FOLLOWED UP ON THE FINAL RESPONSE TO THE COMPLAINT FILED VIA TELEPHONE BECAUSE THE VEHICLE BROKE DOWN 800 MILES FROM HIS HOME. CONSUMER FEELS A RECALL SHOULD BE ISSUED TO REPAIR THIS PROBLEM. THE FAILURE TO COMSUMERS VEHICLE WAS DUE TO A PUSH ROD MAST. *JG

VEHICLE WOULD INTERMITTENTLY STALL WHILE DRIVING. VEHICLE BEEN IN DEALER SHOP ON TWO OCCASIONS, AND THE PROBLEM STILL REOCCURRING. FEEL FREE TO PROVIDE ANY FURTHER INFORMATION ON THIS MATTER.*AK