2015 FORD MUSTANG Complaints

Hi, I was driving on the freeway and suddenly my car stopped accelerating. I would push the acceleration pedal but it wouldnt speed up. And for a few times it would speed up very much. This was very rapid fluctuation. I also noticed that the cruise control was not working. This was very scary being on the highway with this kind of speed fluctuation. After i came back home, i noticed that the brake light wouldnt turn off at all. After doing some research i found that the brake light switch broke and the car was sensing that the brake was being applied and hence was doing acceleration fluctuations. I also found out that there are many other same vehicles which has the same issue.

The contact's husband owns a 2015 Ford Mustang. The contact while reversing, the rearview camera image was distorted and black. The contact stated that the failure had increased, causing the rearview camera to become inoperable. Additionally, the contact stated that the tailgate had failed to open while using the key fob, while pressing the tailgate release switch inside the cabin and the release button on the decklid. The vehicle was taken to the dealer, where it was diagnosed that the decklid wiring harness needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that the vehicle could not be repaired under NHTSA Campaign Number: 22V082000 (Back Over Prevention) because the VIN was not included. The failure mileage was approximately 42,000.

Related to Regional Recall 22R01, the rubber bumper on my brake pedal that engages the brake light switch failed and placed the vehicle in a low power mode. This failure occurred while merging onto the interstate and almost resulted in my being rear-ended by a semi truck. Having never been notified of this regional recall, I was able to verify this was the case after searching forums and YouTube and identifying the pieces of the broken bumper in my floorboard. I find it to be HORRENDOUSLY unacceptable that this was allowed to be handled as a regional recall and no notice was ever produced, as it is a safety-related issue that could have resulted in grievous bodily harm. I am located in Kentucky, which is not part of the named region.

I was driving home from work and all the sudden it went into limp mode, I could barely get her home. Then I found yellow pieces of plastic in my floorboard. My brake light would not go off so I had to unplug the battery. Very scary to have that happen on the interstate, luckily I got off on an exit.

The brake pedal stop bumper in my car disintegrated in the middle of the day and fell off. The brake lights do not turn off anymore and the vehicle can be started and shifted without needing to press the brake. I found a recall # 22S02 for this exact issue but my vehicle is not covered by it (assuming due to region). The vehicle has not been inspected yet.

There is a well known evaporator core issue with the Ford Mustangs/Trucks that were produced between the 2015-2017 models. Freon leaks out of the evaporator core due to poor build quality this creates a white film on the windshield of the vehicle that makes it hard for drivers to see. This happened to me when I first bought my car and I could have crashed but was able to safely pull over and clean the windshield off. This film buildup can happen at anytime and also releases an unpleasant order into the atmosphere that should not be breathed in and is very harmful to the environment. Ford is well aware of this issue and decided to avoid doing a recall to prevent the company from losing money. I am also having an airbag issue on my Mustang this one is current. I have not been in any accidents or driven the car in anyway to make the light come on. The drivers side airbag light is on and is indicating that their is an issue with my airbag system. This is a huge safety concern and I don't want to wait for something to happen for either of these issues to be fixed. The AC issue is new for me with Ford but out of the 4 mustangs I have owned 3 of them have all had recalls for an airbag issue. The first was my 2005 V6 base model. The second was my 2010 Mustang GT. and the third was my 2014 Mustang GT. This is now my 4th mustang and still having air bag issues. Please do something about any of these issues if you can. I am sure numerous of other people have experienced what I am experiencing. I have even done research and seen forums that are over 150 pages long regarding some of the safety issues mentioned in this message. Please and Thank You Very Much

A plastic clip ("Brake Pedal Bumper") broke and fell out of place, causing the brake pedal to no longer reach the brake light switch. The brake lights now remain illuminated permanently, even with the brakes released. This also caused the engine and transmission to go into "limp mode", the engine no longer revving over 2,000 RPM, the transmission not shifting, and hill-start assist and traction control no longer working, making the car unsafe to drive. The brake lights will remain on even when the car is completely shut off and locked, draining and damaging the battery. It is my understanding that this is a known issue, and there was a recall for this in certain states. (Safety Recall 22S02, Regional Recall 22R01). There should be a national recall for this, as the affected part appears to be of low quality, and causes safety issues when it fails, with the car's drivability and lighting affected.

I ran into the existing issue described in "Part 573 Safety Recall Report" NHTSA Recall Number 22V-011, but in a state not listed under the recall (vehicle purchased used in Pennsylvania in 2017). As a result of this part failing, my brake lights remained engaged permanently, and the car's engine power would increase and decrease rapidly (presumably because it thought I kept hitting the breaks). At time of writing I still have the broken pieces of the original part. I plan to take the vehicle into service within the week. There are no warning lights when this occurs since everything I'm the car is technically "operating correctly" - it just thinks the breaks are engaged constantly, and so has erratic behavior. The original recall lists high humidity as a cause, which Pennsylvania definitely has. I keep my vehicle outside 24/7, so it has definitely been part of many temperature swings.

THIS IS A KNOWN ISSUE ON THE 2015 MUSTANGS. THE RECALL ONLY INVLOLVES VEHICLES FROM CERTAIN STATES WITH HIGH TEMPS AND OR HUMIDITY BUT DOES NOT INCLUDE THE STATE OF MISSOURI WHICH SEES BOTH HIGH TEMPS AND HIGH HUMIDITY. DTC CODE P0504. BRAKE LAMP SWITCH HAS ALREADY BEEN REPLACED AND NO ISSUE WITH WIRING. POSITIVE THE PLASTIC STOP BUMPER IS THE ISSUE.

Door lock not secure. It has happened a few times, usually on the highway, where the passenger side door has opened slightly while driving, causing the opened door light to come on. The door is visibly cracked opened, but it is still locked.