2025 FORD RANGER Complaints

2025 Ford Ranger XLT experienced an electrical short-circuit causing a persistent speaker hiss with the vehicle turned off, accompanied by an electrical burning smell. The radio and audio became very staticky and a constant hissing sound with the radio and the truck turned off. By the time the dealer looked at the vehicle it was operating normally. Dealership refused to inspect wiring or ACM due to intermittent nature of the failure.

I am not a mechanic or a 'car person', so I may not know technical terms. This has occurred 4-6 times since purchasing the truck in March '26. After initial start up, it has a tendency to accelerate when applying the break. This is only within the first several minutes after startup. The most recent incident caused the truck to "roll" into the main street rather than coming to a complete stop. I was applying the break, but the truck was 'resisting' to come to a complete stop. The local Ford mechanic found this to be "undesirable, but normal characteristic". The situation that is occurring is anything BUT normal. The Ford dealer was able to replicate the situation, but deemed it to be "no further instructions on fixes or issues related to this concern and no further action can be perfomed" The truck is available for inspection. This is a major safety issue as I was unable to stop the truck before entering the main road. Yes, the truck was inspected by the dealer. There were no warning messages

Vehicle received and installed an over-the-air software update to the Body Control Module, identified on the vehicle screen as BCM-26.6.3 and associated with Safety Recall 26S29 (A-pillar/sun visor wiring, NHTSA 26V238000). The update screen displayed a status of "Not Completed." Since that update the vehicle will not start and is inoperative. Current condition: opening the driver door wakes the center infotainment screen only. The instrument cluster does not illuminate. Pressing the brake pedal produces no response - no cluster illumination, no warning lamps, no chimes, no messages, no crank. 12V power is present; the manufacturer's telematics app still reaches the vehicle and returns status. Symptoms are consistent with a Body Control Module that is powered but not communicating on the vehicle network. No warning lamps, messages, or symptoms were present before the update. The vehicle operated normally until the update was installed. Safety risk: the vehicle became immobile without warning immediately following installation of a manufacturer-pushed safety recall remedy. The transmission cannot be shifted electronically, requiring the manual park release to move or tow the vehicle. Had this occurred away from home or in a traffic lane, the vehicle would have been stranded and unable to move under its own power. The BCM also governs exterior lighting and hazard lamp function. Note: the update screen header displayed "25S29" while the body text referenced completing Safety Recall 26S29. The vehicle has a dealer-installed Ford Performance ProCal calibration. The vehicle has not yet been inspected by the dealer or manufacturer. It is available for inspection upon request.

Truck is randomly switching to Baja mode which engages the 4wheel drive making steering difficult

I was exiting the freeway, and as I was turning off of the freeway onto a side street, at approximately 20mph, my vehicle did not respond to throttle input, and left me slowing to a stop in the middle of a busy intersection. I had to shift my vehicle into neutral and then back into drive, to get it to respond to throttle input. When I slow down at intersections, turn and then attempt to throttle my vehicle, it hesitates and struggles to output power until I throttle about halfway.

No incident occurred. This is to report a safety issue related to the activation of the rear view camera while driving forward. There are times when a vehicle (automobile/motorcycle) may be following closely, and the rear view mirrors are inadequate to see the following vehicle clearly. If the rear view camera is activated, the image projected by the camera is obscurred by a message stating "Full View Not Available". There appears to be no way to remove this message so that the image in not obsurred. See attached photo.

2025 Ranger STX with 950 miles on odometer. When starting vehicle with transmission in park, a pronounced clunk/thump is heard and felt. The clunk/thump varies in intensity with the most intense episode resulting in the physical slight rearward movement of the truck. Symptom seems to be more prevalent when vehicle has been dormant for a few hours or overnight. Initially thought vehicle was going to lunge rearward by physical movement of truck. No warning lights were present with the event. Dealer appointment is scheduled later next week. vehicle is availabe for inspection upon request.

Rear view camera has significant delay, lag, or stutter at times, in reverse, more noticeably at faster that idle reverse speeds.

I believe this is a transmission problem; however, not sure if it could be program related. The main safety issue is after taking off from a stop, the truck just stopped accelerating and hesitated, as if though it got "stuck" trying to change gears. This issue has happened a few times, once with my Wife in the truck, who looked at me like what the heck was I doing. This definitely creates a situation for a rear impact collision if the person behind you didn't hit the brakes soon enough. The transmission also seems to "clunk" real hard at times when coming to a stop, as if though it is switching gears from say 4th down to 1st, skipping 3rd and 2nd gears. I did report this to Kendall Ford of Eugene and they said it shifts just the same as all of the other Rangers with this same transmission. I received no warning lamps, symptoms, or messages.

While driving at highway speeds vehicle changes the drive mode at random. Even attempting to go into 4 low at high speeds. If the vehicle is able to change into 4 low at high speeds this could send the vehicle into uncontrollable lock down to the drive train and potently creating uncontrollable spin out. Car has been at the dealership for this issue, but they cannot find any problems or able to replicate the issue.