2024 GMC YUKON Complaints

Purchase this Vehicle November 1st 2025 as a GM certified used vehicle. Had several issues with the camera system including the backup camera. Would go offline and not be usable for days. Vehicle went back to shop several times for this with no resolution. Now February 18th 2026 at approximately 630PM EST (after sunset) on the way into work traveling on the highway the engine lost power and engine shutdown. Vehicle shifted into neutral with the indication to press the start button in order to shift into Drive. This cause all of the lights to shutdown when it tried to start the engine. I was barely able to pull this over to the shoulder before I lost forward motion. Narrow shoulder. Tried to restart again with the same results. Call towing company. They attempted to jump start vehicle. Same results. All power shutdown. Truck was loaded onto flatbed and towed to dealership. Dealership states bad battery. Got authorization to replace battery from the dealer in which I purchased the truck. hey attempted to start and then it burned out the main fuse. They determined that the engine had seized and they were going to replace the engine. I looked up to find that GM had performed the engine oil replacement procedure in June of 2025. This vehicle is listed in the "recall" for defective L87 engines. Clearly changing the oil had no effect to remedy the issue. I have no faith that the new engine will not fail the same way this one did.

Engine suffered catastrophic failure without warning while traveling highway speeds after being cleared during recall check and suggested oil viscosity change. Most recent dealer performed service on 4/3/26 showed no mechanical issues and engine failed 2 weeks later on 4/17/26.

On March 14th the 6.2L engine was making a loud noise so I took it straight to the dealership and dropped it off. It was determined to be a failed engine. I have not been able to use my vehicle for 5 weeks now.

The contact owns a 2024 GMC Yukon. The contact stated that while the vehicle was stopped at a red traffic light, the accelerator pedal was depressed and the vehicle stalled. The message "Conditions not Available to Change Gear" was displayed. The vehicle was restarted and driven to the residence. The contact stated that several days later, while pulling into a parking lot, the vehicle unexpectedly stalled. The vehicle was restarted and was then towed to the dealer; however, the failure could not be duplicated. The manufacturer was notified of the failure. The failure mileage was approximately 24,000.

From the time i got my 2024 yukon denali i have had problems with the electrical systems not working, it was in the shop for 2 months upon delivery to me when it was brand new, and since then i have had issues with the engine racing, the start button not working, or cutting off and on , on its own, recently the motor cuts on but never turns over. It has been in the shop again for over a week now and they replaced the engine control module and it is still doing the same thing. The dealership is now telling me its a wiring issue causing it. It has been something the entire time I have owned it. I paid 90k for a vehicle that has major issues. I am looking into the Lemon law in my state of NC, and filing a complaint with GMC to see if I can get a replacement vehicle or traded.

This is a Post-Remedy Failure of Recall 25V-274 (GMC 6.2L L87 Engine). Following a full engine replacement performed by the dealer under this safety recall, the vehicle has suffered a catastrophic electrical compromise. The vehicle is currently throwing codes P2534 (Low Ignition Voltage) and U3018 (BCM Communication). Safety Hazards: The vehicle experiences sudden loss of power, engine stalling at highway speeds, and total failure of the exterior turn signals (hyper-flash). The AC system has been disabled by the Body Control Module due to low voltage, creating a hazard in high temperatures. This vehicle fits the exact profile of NHTSA Recall Query RQ26-001 and Engineering Analysis EA25-007. The manufacturer's remedy for the safety recall has failed to restore the vehicle to a safe operating condition, and the dealership is attempting to charge diagnostic fees to investigate their own defective recall workmanship.

While driving I had a sudden loss of power. Contacted dealership and was ask for engine code light. Told them no light had appeared on dashboard. Did note intermittent shift changes while driving after this occurrence. Transmission and or engine feels like it has a studder. Concerning.

Vehicle shut-off while driving on the expressway, around 70-75mph. Upon vehicle turning off, I had no option but to "coast" off to the left side, which thankfully, freed me from traffic for the most part. If anyone who have been a foot over, they would've hit me. I have had numerous electrical issues with this vehicle and have taken it to the dealership but they have been "unable" to duplicate the issue. Vehicle was immediately taken to the dealership (and they still have as of this incident report submission). They told me last night that they will keep it again today and test drive it again to see if they can get it to do anything but if it doesn't show anything new, they have nothing to diagnose and will give me my car back. After requesting a copy of repair orders and a list of the history codes in my car, I am beside myself that anyone thinks giving me this vehicle back to drive is ok. See the history code report in documents uploaded. These are MAJOR safety failures in a large vehicle.

We were driving on the highway when the service lights came on along with the check engine light started flashing. The truck sounded like it hesitated a little, but the lights turned off and it drove his normal. We exited the freeway as we were close to home came home, parked it turned it off and turned it back on to test it, and it hesitated to turn on so we took it straight to the dealership where they repeated the issue. We left it there. They did not call me so I went up to the dealership the following day to check on this and I had not heard from them they told me why they were on the test drive that the engine had locked up. My vehicle was a part of the initial recall. They told me that it passed the inspection and they changed the oil to the new oil that was required and now at 12,000 miles my engine has failed

The contact owns a 2024 GMC Yukon XL. While the contact's wife was driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. In addition, the contact's wife noticed an abnormal knocking sound before the engine seized. The check engine warning light illuminated. The vehicle was towed to the dealer, where it was diagnosed and DTC: P0305 (lifter on cylinder 5); was retrieved, and the intake valve detached and damaged the camshaft. The contact was informed that the lifters and related parts, camshaft, and the coolant pump needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the dealer where it was diagnosed with engine failure due to the metal shavings found in the oil. The contact was informed that the engine needed to be replaced. The vehicle was not diagnosed. In addition, the failure had occurred within 2,500 miles of the initial repair. The manufacturer was made aware of the failure ,and a case was filed. The failure mileage was approximately 14,589.