2024 GMC YUKON Complaints

The SUV has 46,000 miles on it. Recently, the check engine light illuminated, prompting me to take it to the dealership for servicing. The diagnostic codes retrieved were U0285 and U1345. I was informed that the aero shutter required replacement. There was no physical damage; it merely ceased functioning. The dealership confirmed the active check engine light and conducted a diagnosis. While my safety was not immediately compromised, I felt extremely frustrated upon learning that GM would not cover the repair under warranty, despite this being a recognized issue that GM has yet to address. This situation is simply unacceptable and warrants further investigation and resolution.

****This complaint is an addendum to ODI Complaint #11715415 **** This report updates the prior complaint to reflect complete engine seizure and pending engine replacement following post-repair loss of propulsion. I respectfully request that NHTSA include my vehicle’s failure in its ongoing evaluations related to L87 engine failures, including Recall 25V-274, Engineering Analysis EA25007, and Recall Query RQ26001. My 2024 GMC Yukon XL Denali experienced progressive internal engine failure beginning at approximately 61, 975 miles. First attempt: The vehicle required camshaft and lifter replacement due to internal mechanical damage. Immediately after 4.5 week repair, the vehicle suffered sudden loss of motive power at highway speed.  The engine shut down without warning at 75 mph with children in the car. (Car was in owners possession for no more than 15 hours, and was driven 25 miles on the highway when it switched to neutral and shut down). Second attempt: The vehicle was towed back to the dealership. Additional electrical repairs were then attempted. (Fuse box) It shut down again during dealer testing. Third attempt: Subsequent internal inspection revealed cylinders 5 and 6 seized, requiring full engine replacement. This represents: • Repeated loss of motive power • Escalation from top-end failure to catastrophic lower-end seizure • Failure occurring immediately after dealer-performed repair(s) • A 2024 model-year vehicle with relatively low mileage Given NHTSA’s ongoing investigations into post-remedy failures (RQ26001) and out-of-scope bearing failures (EA25007), I request that this incident be evaluated as part of the broader defect pattern analysis.

About 4 weeks ago my vehicle began shaking uncontrollably while driving. The check engine light illuminated and multiple warnings appeared including emissions system, variable valve timing system, engine and transmission failures shown on the GMC app. I contacted the selling dealership and was given an appointment 4 days later. Later that day I drove less than 5 miles to pick up my children from school. During that drive the vehicle filled with a strong gasoline odor and exhaust fumes were overwhelming. I feared the vehicle could catch fire. I contacted the dealership again, stated the vehicle was unsafe, dropped it off at approximately 8:00 PM and was required to obtain my own rental vehicle. After one week I was told the engine required a camshaft and lifter replacement. Inspected & approved by extended warranty, parts were ordered and installed. I retrieved the vehicle on 23 days after the initial failure. The following morning (24th day) while driving approximately 75 mph on a major interstate with my children the vehicle suddenly shifted into neutral and would not re-engage. I was unable to shift into any gear and coasted to a narrow shoulder inches from traffic and guardrail.The dashboard stated the vehicle could not shift into gear and instructed me to push the start button. The engine would not restart. We were stranded approximately two hours in 10-degree weather on a major interstate with heavy semi-truck traffic. Roadside assistance was required. 3 days later the dealership stated the failure was a fuse block. After replacement the vehicle was test driven and stated to be operating normally. A second dealership employee test drove the vehicle, it died again and had to be towed back to the dealership. The battery was replaced after draining while disabled. Repeated mechanical and electrical failures resulted in complete loss of power at highway speeds and placed my children and me in immediate danger. I no longer believe this vehicle is safe to operate.

This report documents two separate safety incidents involving the same vehicle that occurred on different dates. Approximately one month prior to the most recent incident, while driving my young children to school, the vehicle experienced a sudden and severe loss of braking effectiveness while in motion. I was unable to stop normally at stop signs and had to roll through and roll to a stop. I was required to press the brake pedal fully to the floor to slow the vehicle, and even then braking response was significantly reduced and not functioning as designed. The engine remained running and the vehicle could still accelerate. After stopping and restarting the vehicle, braking function temporarily returned. On a later date, while again transporting my children, the vehicle experienced a complete loss of power while driving. The vehicle abruptly shut down while in motion. I was unable to accelerate and experienced loss of power assisted braking. The vehicle only came to a stop after coasting. Following this shutdown, a burning or melted plastic odor was present. The vehicle was later towed and inspected by a dealership. The battery was replaced; however, this did not resolve the issue. After the battery replacement, the vehicle later hesitated to start again. The exact cause of these failures remains unknown. These incidents occurred without warning and represent serious safety critical failures involving braking and propulsion systems. Both incidents placed my children, myself, and other motorists at risk. Had either event occurred on a highway or heavily trafficked roadway, there would have been little to no ability to safely slow or stop the vehicle, creating a significant risk of collision or serious injury. Due to these events, I no longer feel safe operating this vehicle and have stopped driving it. The vehicle remains available for inspection.

I am filing this complaint regarding a serious and ongoing safety issue with my GMC Yukon Denali that began with a complete engine failure while driving on the highway with my entire family in the vehicle. While driving at highway speed (about 60–70 mph), the vehicle suddenly lost power and shifted into neutral on its own. While still moving, I tried multiple times to shift back into Drive so I could safely get off the road, but it would not engage. I was only able to coast partially onto the shoulder before the vehicle came to a complete stop, still partly exposed to traffic. The engine shut off and would not restart at all. It would not go into Drive or Neutral, and the vehicle was completely dead. And it had to be towed. The dealer later told me the engine had failed and that a new engine was installed. About a week later, I picked the vehicle up. Less than 20 minutes after leaving the dealership and getting back on the highway, smoke started coming from the vehicle and warnings appeared, messages that the engine was overheating and that I needed to stop the engine immediately. The vehicle was not drivable again and had to be towed back. I again had to arrange transportation home. A few days later, I picked the vehicle up again. Since then, I have had serious four-wheel-drive and drivetrain issues. The vehicle became stuck in 4 Low and I could not get it out for over a day. When it finally came out, the drive mode buttons stopped working correctly. Selecting 2 High sometimes puts it into 4 High, selecting Auto puts it into 2 High, and Auto mode no longer appears. Even when it shows 4 High, the steering is restricted cannot steer 100% to the right or left and the vehicle binds, pops, and jumps when turning. I believe this vehicle is unsafe and poses a serious risk.

While parked, my [XXX] daughter was in the third-row bench seat. The seat belt became wrapped around her body/neck area. The seat belt entered its 'Automatic Locking Retractor' (ALR) mode and continued to tighten as she moved, pinning her against the seat. The locking mechanism would not release, and the belt became so tight she was unable to breathe. We attempted to manually release the buckle and create slack, but the retractor remained locked and continued to tighten. After several minutes of unsuccessful attempts to free her, we had to use a cutting tool to sever the seat belt to save her life as she couldnt breath, she has brusing where the seat bealt was tighten. The vehicle was stationary in a parking lot at the time. The car has not being inspected , there was not warning. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Vehicle can be completely off and windshield wipers are still going. So you have to pop the hood and pull fuse out. If you want to use them ( it starts raining, dirty windshield) you have to stop pop the hood and put fuse in. Has been in shop almost weekly repaired every part they could possible switch and still not repaired.

Transmission appears to be lunging and shuttering. Dealer has indicated that the valve body need to be replaced or the vehicle could leave me stranded or without propulsion while driving. From my research this appears to be related to other safety recall and service campaigns for this type of vehicle and the transmission that I have in my vehicle. Also the camera system doesn't work correctly as it relates to parking assist and collision control. My repair dealership has stated they are having trouble getting GM to cover this repair.

I have a 2024 GMC Denali that had an engine service appointment in September 2025 for the engine recall where they did an oil change & put in performance grade oil & scoped my engine. Rochester Serra GMC said they sent all the engine pictures to GM and my engine was okay according to them. After that appointment in November my engine light went on and my Denali was leaking oil in my driveway. We took the truck back to Serra GMC Rochester and they replaced the oil filter that they said was defective & an oil change was done after my husband requested that just filling up the oil was not okay. They also told us the engine light didn’t show up on their computer system and it must have cleared out, so nothing was done for that. Today 1/25/26 now about a month later my engine light is back on and has remained on with multiple starts. This is not acceptable and needs to be investigated and I want this escalated. I do not feel comfortable driving my truck with this engine light on with a known engine propulsion recall that has no actual cure. The oil replacement and cap change has done nothing and engine light remains on. I just don’t want to hear the same thing that the computer must have cleared the error code. My engine light is on for a reason and I’m asking for a thorough diagnostic test to be done by a certified technician and a get a valid explanation of why my engine light keeps going on & not just changing my oil or waiting for something catastrophic to happen to me or my family. GM is putting me and my family at risk by saying that my truck’s engine is fine when clearly the engine light keeps repeatedly going on for 3 months in a row now since November 17, 2025.

Vehicle 4WD performs poorly with car fishtailing at very low speeds 30 MPH in a straight lane. Very scary . Feels unsafe to drive . Brand new tires were installed prior to that. So not a tire issue.