GMC Complaints

View complaints related to GMC. The complaints found here are submitted by actual consumers with first hand experience. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2025 GMC TERRAIN
    - Galena, MO

    Incident 1: Pulled out from stop sign car made funny noises, light came on said it couldn't shift to drive. Had towed to dealer. They said couldn't find issue except it was quart and a half low of transmission fluid. The car had approx 3,500 miles on it. Incident 2: For about two weeks when pulling out felt like it was skipping but didn't feel like transmission. Felt like over powered. Then it done same as Incident 1. Pulled out made noise would not move. Notice that is couldn't shift and check engine light came on had it towed again. Approx 6,300 miles on it. They then said it was very low on transmission fluid and they did find a small hole in hose. Danger is pulling out and it just stops in cross traffic and won't move could easily be hit. It is very scary to drive not knowing if or when it is going to happen. I have no current invoice on vehicle as it is still in shop.

    Source: NHTSA WEB SITE
  • 2019 GMC ACADIA
    - Fombell, PA

    When I park and then turn the car off the car fails to recognize that the gear shifter is in the park position. As a result, the car doesn’t fully shut down, leaving the engine running or the electronics active. This drains the battery. I have seen this issue is recalled for other 2019 Acadias but don’t under why it is not recalled in mine. I’m afraid I’ll be out and about and unable to turn my car off resulting in a dead battery and being stranded.

    Source: NHTSA WEB SITE
  • 2018 GMC SIERRA 1500
    - Fairview, PA

    The contact owns a 2018 GMC Sierra 1500. The contact stated that while driving on a neighborhood road at 40 MPH, the check engine warning light was flashing with an abnormal knocking sound coming from the engine, and the vehicle was vibrating abnormally. The contact pulled over and used a diagnostic scanner to perform a diagnostic test on the vehicle. The scanner retrieved DTC: P0301 (Cylinder #1 Misfire). The vehicle was towed to a local dealer to be diagnosed, and the contact was informed that the lifters, pushrods, camshaft, sparkplugs, and oil pump were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 111,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2021 GMC YUKON XL
    - Western Springs, IL

    The contact owns a 2021 GMC Yukon XL. The contact received notification of NHTSA Campaign Number: 25V274000 (ENGINE AND ENGINE COOLING). The dealer was contacted; however, the contact was informed that parts were not yet available. The vehicle was not repaired. The manufacturer was contacted about parts not being available. The contact stated that while driving at 70 MPH, the vehicle lost automotive power. There was no warning light illuminated. The contact pulled over, and the vehicle was towed to a local dealer. The vehicle was not repaired. The failure mileage was unknown.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2023 GMC TERRAIN
    - Kennard, TX

    The contact owns a 2023 GMC Terrain. The contact stated that while driving at approximately 5 MPH, and entering the roadway from the driveway, the vehicle stalled. The contact stated that there were no warning lights. The contact stated that the vehicle had lost electrical power. The contact was unable to restart the vehicle. The vehicle used a push-button gear shift PRNDL, and the contact was unable to set the vehicle into park(P) to restart the engine. The contact was able to restart the vehicle after several attempts and drove the vehicle to a dealer. The contact stated that on the drive to the dealer, the check engine warning light illuminated, but they kept driving. The vehicle was diagnosed, and it was determined that the fuel module had failed and needed to be replaced. The vehicle was repaired. The manufacturer was informed of the failure. The failure mileage was 12,825.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2017 GMC ACADIA
    - Corsicana, TX

    The contact owns a 2017 GMC Acadia. The contact stated that the vehicle had to be turned on and off approximately 2 - 3 times to place the gear shifter in park(P), for the transmission to remain in park(P). The message “Shift to Park” would be displayed on the instrument panel. The failure was intermittent at first, but since started occurring more frequently. The dealer was contacted, and it was confirmed that the VIN was not under recall. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was approximately 91,587.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2019 GMC YUKON
    - Los Angeles, CA

    The contact owns a 2019 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle briefly hesitated and jerked before returning to normal functionality. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the transmission. The contact was informed that the transmission needed to be replaced. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 111,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2019 GMC ACADIA
    - Orland Park, IL

    Failure to be in park alarm when shifter is in park. Must play with shifter back into park to stop alarm bells and notice on dash. Supposedly there was a recall issued however not shown on this site per my vin #1GKKNXLS7KZ107842. Very irritating, please advise.

    Source: NHTSA WEB SITE
  • 2025 GMC YUKON
    - Ossining, NY

    The contact owns a 2025 GMC Yukon. While the contact's husband was driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. The contact stated that the brake failure warning light was illuminated. The contact’s husband depressed the brake pedal and noticed that the brake pedal was firm and difficult to depress. The contact stated that an error message indicated that the vehicle was decelerating. The contact's husband depressed the brake pedal and the vehicle decelerated to 40 MPH. While the contact’s husband was slowly driving into the driveway at the residence, the brake pedal was depressed; however, the vehicle failed to stop. The contact’s husband immediately shifted the gear shifter into park(P) to stop the vehicle. The contact stated that the failure had occurred while on the way home from a family trip. The vehicle was towed to the dealer and the vehicle was diagnosed with a failed brake master cylinder assembly, a failed brake control module, and a failed brake plunger. The contact was informed that the brake master cylinder assembly, the brake control module, and the brake plunger needed to be replaced. The vehicle was not repaired. The contact was informed that the parts were on back-order. The manufacturer was not made aware of the failure. The failure mileage was approximately 3,150.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2025 GMC YUKON
    - Lathrop, CA

    While driving on the highway, my SUV lost speed and went into what I believe was limp mode and the check engine light came on. I was unable to accelerate quickly which was very dangerous on the highway as I was only able to very slowly go about 45 MPH on a 65 MPH highway. After the dealer inspected it, I was told I needed a new engine, oil cooler, and turbo. They said it had metal in the oil. My SUV only had 2138 miles at the time of incident.

    Source: NHTSA WEB SITE